The LHC beam loss monitoring system's data acquisition card

The beam loss monitoring (BLM) system [1] of the LHC is one of the most critical elements for the protection of the LHC. It must prevent the super conducting magnets from quenches and the machine components from damages, caused by beam losses. Ionization chambers and secondary emission based beam loss detectors are used on several locations around the ring. The sensors are producing a signal current, which is related to the losses. This current will be measured by a tunnel electronic, which acquires, digitizes and transmits the data via an optical link to the surface electronic. The so called threshold comparator (TC) [2] collects, analyzes and compares the data with threshold table. It also gives a dump signal through the combiner card to the beam inter lock system (BIC). The usage of the system, for protection and tuning of the LHC and the scale of the LHC, imposed exceptional specification of the dynamic range and radiation tolerance. The input current dynamic range should allow measurements between 10pA and 1mA and it should also be protected to very high pulse of 1.5kV and its corresponding current. To cover this range, a current to frequency converter (CFC) is used in the tunnel card, which produces an output frequency of 0.05Hz at 10pA, and 5MHz at 1mA. In addition to the output frequency, the integrator output voltage is measured with a 12bit ADC to improve the resolution. The location of the CFC card next to the detector imposes the placement of the card in the LHC tunnel, exposing the card to radiation. The radiation tolerance was defined by assuming a 20 year operation period corresponding to 400Gy. A mixture of radiation tolerant Asics from the microelectronic group at CERN, and standard component was chosen to cope with these requirements.