Cargando…

Inserting the beampipe into the ITS barrel

Inserting the beampipe into the ITS barrel

Detalles Bibliográficos
Autor principal:	Decosse Catherine
Publicado:	2007
Materias:	ITS
Acceso en línea:	http://cds.cern.ch/record/1044993

Ejemplares similares

Installation of the Inner Tracking System (ITS) of ALICE
por: Decosse, C.
Publicado: (2007)

A few members of the Silicon Pixel Detector working on the completed first half barrel
por: Saba, A
Publicado: (2007)

ALICE beampipe insertion
por: Brice, Maximilien, et al.
Publicado: (2020)

Alice Silicon Strip Detector, detail laddermal insert lock
por: xxx, x
Publicado: (2001)

LHCb beampipe installation and insertion
por: Ordan, Julien Marius, et al.
Publicado: (2021)

ALICE ITS
Publicado: (2003)

ALICE ITS
Publicado: (2003)

ALICE ITS Silicon Strip Module
Publicado: (2006)

Full-scale model of the ALICE ITS Detector
Publicado: (2004)

ALICE ITS Testbeam setup with 4 pixel reference planes
Publicado: (2002)

A silicon Drift Detector and its two fronted boards
por: Nouais, D.
Publicado: (2004)

Gert-Jan Nooren and Jean-Robert Lutz looking at the ALICE Inner Tracking System
por: Saba, A
Publicado: (2007)

Detail of the ALICE Silicon Strip Detector
por: Saba, A.
Publicado: (2007)

Gert-Jan Nooren, co-project leader of the Silicon Strip Detector of the ALICE Inner Tracking System
por: Saba, A.
Publicado: (2007)

Jean-Robert Lutz, co-project leader of the Silicon Strip Detector of teh ALICE Inner Tracking System
por: Saba, A.
Publicado: (2007)

Alice Silicon Strip Detector, Spaceframe production
por: xxx, x
Publicado: (2007)

Alice Silicon Strip Detector, folding tools
por: xxx, x
Publicado: (2007)

Alice Silicon Strip Detector, HAL cable
por: xxx, x
Publicado: (2007)

Alice Silicon Strip Detector, ladder legs cutting
por: xxx, x
Publicado: (2007)

Alice Silicon Strip Detector, aligment system from St. Petersburg
por: xxx, x
Publicado: (2007)

Alice Silicon Strip Detector, cooling
por: xxx, x
Publicado: (2007)

Alice Silicon Strip Detector
por: Durk, Gardenier
Publicado: (2007)

ALICE Pixel Ladder (5 chips bump bonded to 1 sensor) mounted on prototype bus
Publicado: (2002)

ALICE pixel prototype bus with 10 readout chips
Publicado: (2002)

ALICE pixel readout chip with 8192 readout channels
Publicado: (2001)

ALICE Carbon fibre sector support
Publicado: (2001)

ALICE ladder mounted on prototype bus
Publicado: (2002)

ALICE ladder mounted and wire bonded on prototype bus
Publicado: (2002)

ALICE Testbeam 2002-Reference plane made of 2 bump bonded single chip assemblies
Publicado: (2002)

SEM picture of bump bonding pads on ALICE readout chip
Publicado: (2002)

Probing of ALICE single chip assembly
Publicado: (2001)

Multiple trigger scintillators were installed: big ones covering the total surface of the sensor and several smaller ones. The former give a trigger for each beam particle. The latter are used to select a part of the sensor surface for efficiency measurements.
por: Nooren, G.
Publicado: (2004)

In ALICE particles will hit the sensors at oblique angles. This is partly simulated here by rotating the modules.
por: Nooren, G.
Publicado: (2004)

Installation of the light tight cover for the SSD modules (the modules are behind the aluminium plate). The silicon sensors are sensitive to light tight, so ambient light will increase the noise and may even damage them.
por: Nooren, G.
Publicado: (2004)

The T10 beam produces a few hits per event. In ALICE the SSD will have to cope with many hits per strip. In the three centimeters of aluminium the beam will produce many secondary particles. This increases the chance of multiple hits per strip, although not to the level in ALICE.
por: Nooren, G.
Publicado: (2004)

Particular of the set up for testing the cooling system of SDD
por: Alessandro, B.
Publicado: (2004)

Set up to test the cooling system of SDD
por: Alessandro, B.
Publicado: (2004)

The board with the front-end ASIC's called PASCAL and AMBRA (part of readout setup)
por: Alessandro, B.
Publicado: (2004)

The DAQ screen during the test of the readout of SDD
por: Alessandro, B.
Publicado: (2004)

Set up to test the redout chain of SDD
por: Alessandro, B.
Publicado: (2004)

Cannot write session to /tmp/vufind_sessions/sess_e1rqqd5qn6uqenc4huqc5pgdvm