Cargando…

High vacuum pumping equipment

Detalles Bibliográficos
Autor principal:	Power, Basil Dixon
Lenguaje:	eng
Publicado:	Chapman and Hall 1966
Materias:	Accelerators and Storage Rings
Acceso en línea:	http://cds.cern.ch/record/109078

Ejemplares similares

Vacuum equipment and techniques
por: Wakerling, Raymond K, et al.
Publicado: (1949)

Treatment of materials for use in high vacuum equipment
por: Cherepnin, N V
Publicado: (1976)

Control and operational models for vacuum equipment
por: Strubin, Pierre M, et al.
Publicado: (1997)

Vacuum stability with beam pumping
por: Gröbner, Oswald
Publicado: (1998)

Vacuum Pumping by Freezing Molecules
por: Benvenuti, Cristoforo
Publicado: (2017)

Vacuum system of the Serpukhov fast ejection equipment
por: Riboni, P
Publicado: (1968)

Vacuum tests in the Booster with sublimation pumps
por: Brouet, M
Publicado: (1988)

A Common Control Model for Vacuum Equipment at CERN
por: Laugier, I, et al.
Publicado: (1999)

A bakeout system for vacuum equipment of the SPS machine
por: Koelemeijer, W
Publicado: (1981)

Note on vacuum system of Serpukhov fast ejection equipment
por: Riboni, P
Publicado: (1967)

Dimensional drawings of LPI vacuum pumping components (vacuum section PS/ML)
por: Malthouse, H F
Publicado: (1983)

A Pumping Vacuum Chamber: Ultimate Simplicity
por: Benvenuti, Cristoforo
Publicado: (2017)

Sputter ion pumps for the LEAR vacuum system
Publicado: (1981)

Titanium sublimation pump for the PSB vacuum system
por: Hoekemeijer, F
Publicado: (1978)

Vacuum system for Proton Storage Rings equipped with superconducting magnets
por: Benvenuti, Cristoforo
Publicado: (1974)

Radiation zoning for vacuum equipment of the CERN Large Hadron Collider
por: Mahner, E, et al.
Publicado: (2009)

High-voltage power converters feeding the ion pumps of the LEP vacuum system
por: Genand, R, et al.
Publicado: (1990)

Vacuum science and engineering: properties of gases at low pressure, vacuum measurements, design and operating features of vacuum pumps and systems
por: Van Atta, C W
Publicado: (1965)

A linear pump for conductance limited vacuum systems
por: Benvenuti, Cristoforo, et al.
Publicado: (1977)

Energy loss from pumping holes in the vacuum chamber
por: Henke, H
Publicado: (1983)

Vacuum Simulation of RF Cavities to Optimize Pump Configurations
por: Shen, S, et al.
Publicado: (1999)

Specifications of the vacuum equipment for the 2-MeV electron storage ring
por: CERN. Geneva
Publicado: (1961)

First Experience with Control and Operational Models for Vacuum Equipment in the AD Decelerator
por: Strubin, Pierre M, et al.
Publicado: (1999)

Experience with the vacuum equipment for the CERN 25 GeV proton synchrotron
por: Munday, G L, et al.
Publicado: (1962)

Vacuum system for proton storage rings equipped with super-conducting magnets
por: Benvenuti, Cristoforo
Publicado: (1974)

Technical specifications super-ion pumps for the SPS vacuum system
por: Wahl, H
Publicado: (1981)

Technical specification sputter-ion pumps for the SPS vacuum system
por: Wahl, H
Publicado: (1981)

Technical specification of PE insulated vacuum pump supply cable
por: CERN. Geneva
Publicado: (1978)

Technical specification of radiation-resistant vacuum pump supply cables
por: CERN. Geneva
Publicado: (1972)

Technical note - First pump down of the AA vacuum system
por: Malthouse, H F
Publicado: (1980)

Leakage of RF power from the LEP vacuum chamber into the distributed pump
por: Bramham, Peter
Publicado: (1981)

The use of NEG pumps and coatings in large vacuum systems: experience and limitations
por: Mazzolini, F
Publicado: (2007)

Technical specifications - Turbomolecular pumps for the antiproton accumulator ring vacuum system
Publicado: (1978)

Note on acceptance test of 400 l/s ion pumps for LEAR vacuum system
Publicado: (1982)

Note on acceptance test of 60 l/s ion pumps for for LEAR vacuum system
por: Hoekemeijer, F
Publicado: (1982)

Technical specification for rough pumping stations for the vacuum system of the TT2 line
por: Hoekemeijer, F
Publicado: (1977)

Technical specifications - Sputter-ion pumps for the antiproton accumulator ring vacuum system
Publicado: (1978)

Technical specifications backing pump stations for the antiproton accumulator ring vacuum system
Publicado: (1978)

Paper for the eighth Annual Symposium of the American Vacuum Society, Washington, October 1961: Experience with the pumping equipment for the CERN 25 GeV proton synchrotron (presented by G.L. Munday and G. Zinsmeister)
Publicado: (1961)

The vacuum behaviour of screen pumping holes in the LHC studies by Monte Carlo simulation techniques
por: Gómez-Goñi, J, et al.
Publicado: (1992)

Cannot write session to /tmp/vufind_sessions/sess_pl3gu77m5o5j7b3b2biqdunfng