Cargando…

Comparing Thermal Stability of NbTi and Nb$_3$Sn Wires

The investigation of quenching in low temperature superconducting wires is of great relevance for a proper design of superconductive cables and magnets. This paper reports the experimental results of a vast measurement campaign of quench induced by laser pulses on NbTi and Nb$_{3}$Sn wires in pool b...

Descripción completa

Detalles Bibliográficos
Autores principales:	Breschi, M, Trevisani, L, Bottura, L, Devred, A, Trillaud, F
Lenguaje:	eng
Publicado:	2008
Materias:	Accelerators and Storage Rings
Acceso en línea:	https://dx.doi.org/10.1088/0953-2048/22/2/025019 http://cds.cern.ch/record/1168730

Ejemplares similares

Minimum Quench Energy and Early Quench Development in NbTi Superconducting Strands
por: Breschi, M, et al.
Publicado: (2007)

(NbTi)N and NbTi coatings for superconducting accelerating cavities
por: Benvenuti, Cristoforo, et al.
Publicado: (1992)

A Practical Fit for the Critical Surface of NbTi
por: Bottura, L
Publicado: (1999)

Magnetization and loss measurements on Nb$_{3}$Sn and NbTi strands for ITER and LHC
por: Foitl, M
Publicado: (2001)

Technical specification of NbTi superconducting wires for the sextupolar correction models
Publicado: (1988)

A survey of NbTi conductor status
por: Billinge, R, et al.
Publicado: (1985)

A SURVEY OF NbTi CONDUCTOR STATUS
por: Billinge, R, et al.
Publicado: (1985)

NbTi Superferric Corrector Magnets for the LHC Luminosity Upgrade
por: Volpini, G, et al.
Publicado: (2014)

Artificial Pinning in Nb$_3$Sn Wires
por: Spina, Tiziana, et al.
Publicado: (2017)

Nb$_{3}$Sn and NBTI for High Field Applications with Emphasis to Fusion Magnets
por: Duchateau, J L
Publicado: (2005)

Stability in a long length NbTi CICC
por: Bottura, L, et al.
Publicado: (2001)

Magnetization and Inter-Filament Contact in HEP and ITER Bronze-Route Nb$_{3}$Sn Wires
por: Bordini, B, et al.
Publicado: (2011)

Stability modeling of the LHC Nb-Ti Rutherford cables subjected to beam losses
por: Bottura, L, et al.
Publicado: (2019)

Low-field Instabilities in Nb$_{3}$Sn Multifilamentary Wires: the Possible Role of Unreacted Nb
por: Devred, A, et al.
Publicado: (2007)

Nb$_3$Sn wire layout optimization to reduce cabling degradation
por: Farinon, S, et al.
Publicado: (2007)

Are Large-Aperture NbTi Magnets Compatible with 1e35?
por: Wildner, E, et al.
Publicado: (2008)

A 5 m long impregnated NbTi dipole magnet
por: Leroy, D, et al.
Publicado: (1985)

Low-current Resistance of Multifilamentary Superconducting Cu/NbTi Strands
por: Boutboul, T, et al.
Publicado: (2003)

Critical Current Test Facilities for LHC Superconducting NbTi Cable Strands
por: Boutboul, T, et al.
Publicado: (2001)

Quench Level of the HL-LHC $Nb_3Sn$ IR Quadrupoles
por: Breschi, Marco, et al.
Publicado: (2017)

NbTi/Nb/Cu multilayer shield for the superconducting shield (SuShi) septum
por: Barna, D., et al.
Publicado: (2018)

Experimental and numerical analysis of interfilament resistances in NbTi strands
por: Breschi, M, et al.
Publicado: (2014)

Radioactivity of Nb$_{3}$Sn/Cu wires after proton irradiation
por: Otto, Th, et al.
Publicado: (2013)

Residual Resistivity Ratio (RRR) Measurements of LHC Superconducting NbTi Cable Strands
por: Charifoulline, Z
Publicado: (2006)

Layout Study for the Dipole Magnets of the Future Circular Collider Using Nb-Ti and Nb$_{3}$Sn
por: van Nugteren, J, et al.
Publicado: (2016)

On the effect of strand damage on the operating margin of a Nb$_3$Sn Rutherford cable
por: Succi, G, et al.
Publicado: (2022)

Tensile Properties of the Individual Phases in Unreacted Multifilament Nb$_{3}$Sn Wires
por: Scheuerlein, C, et al.
Publicado: (2007)

Impact of the Residual Resistivity Ratio on the Stability of Nb$_{3}$Sn Magnets
por: Bordini, B, et al.
Publicado: (2012)

Tensile Properties of the Individual Phases in Un-Reacted Multifilament Nb$_{3}$Sn Wires
por: Scheuerlein, C, et al.
Publicado: (2006)

Test Results of the MQYYM: A 90 Mm NbTi Quadrupole Magnet Option for HL-LHC
por: Simon, D, et al.
Publicado: (2022)

Development of MQYY: A 90-mm NbTi Double Aperture Quadrupole Magnet for HL-LHC
por: Felice, Helene, et al.
Publicado: (2018)

Fabrication and test of a LHC NbTi dipole model magnet with a split collar system,
por: Zerobin, F, et al.
Publicado: (1992)

Magneto-Thermal Stability in LARP Nb$_{3}$Sn TQS Magnets
por: Bordini, B, et al.
Publicado: (2010)

LHC instertion upgrade combining $Nb_{3}Sn and Nb-Ti magnets
por: Ostojic, R, et al.
Publicado: (2007)

Direct Measurement of Inter-Filament Resistance in Superconducting Multifilamentary NbTi and Nb(3)Sn Strands
por: Zhou, C, et al.
Publicado: (2011)

Nb$_{3}$Sn 11 T Dipole for the High Luminosity LHC (CERN)
por: Bordini, Bernardo, et al.
Publicado: (2019)

Finite Element Model to Study the Deformations of Nb$_{3}$Sn Wires for the Next European Dipole (NED)
por: Farinon, S, et al.
Publicado: (2007)

Decay and snapback in Nb$_{3}$Sn dipole magnets
por: Bermudez, S Izquierdo, et al.
Publicado: (2016)

A Lowgradient Triplet Quadrupole Layout Compatible with NbTi Magnet Technology and $\Beta^{*}$ = 0.25m
por: Brüning, Oliver Sim, et al.
Publicado: (2006)

Development of a $Nb_{3}$Sn multifilamentary wire for accelerator magnet applications
por: Durante, M, et al.
Publicado: (2000)

Cannot write session to /tmp/vufind_sessions/sess_h1h5ll0mmb2b2629biq3e1n7hk