Cargando…

BEAM TEST RESULTS WITH THE FONT4 ILC PROTOTYPE INTRA-TRAIN BEAM FEEDBACK SYSTEM

We present the design and beam test results of a prototype beam-based digital feedback system for the Interaction Point of the International Linear Collider. A custom analogue front-end processor, FPGA-based digital signal processing board, and kicker drive amplifier have been designed, built, and t...

Descripción completa

Detalles Bibliográficos
Autores principales:	Apsimon, R, Burrows, P N, Clarke, C, Constance, B, Dabiri Khah, H, Hartin, T, Perry, C, Resta Lopez, J, Swinson, C, Christian, G B, Kalinin, A
Formato:	info:eu-repo/semantics/article
Lenguaje:	eng
Publicado:	2009
Materias:	Accelerators and Storage Rings 9: Technology for normal conducting higher energy linear accelerators
Acceso en línea:	http://cds.cern.ch/record/1239672

Ejemplares similares

Latest Beam Test Results from ATF2 with the Font ILC Prototype Intra-train Beam Feedback Systems
por: Apsimon, Robert, et al.
Publicado: (2010)

THE FONT5 PROTOTYPE ILC INTRA-TRAIN FEEDBACK SYSTEM AT ATF2
por: Apsimon, R J, et al.
Publicado: (2011)

DEVELOPMENT OF A FAST MICRON-RESOLUTION BEAM POSITION MONITOR SIGNAL PROCESSOR FOR LINEAR COLLIDER BEAMBASED FEEDBACK SYSTEMS
por: Apsimon, R, et al.
Publicado: (2009)

Development of a Fast, Single-pass, Micron-resolution Beam Position Monitor Signal Processor: Beam Test Results from ATF2
por: Apsimon, Robert, et al.
Publicado: (2010)

Latest Performance Results from the FONT5 Intra-train Beam Position and Angle Feedback System at ATF2
por: Christian, G B, et al.
Publicado: (2012)

Design of the ILC Prototype FONT4 Digital Intra-train Beam-based Feedback System
por: Burrows, P N, et al.
Publicado: (2006)

DESIGN AND INITIAL RESULTS OF A TURN-BY-TURN BEAM POSITION MONITORING SYSTEM FOR MULTIPLE BUNCH OPERATION OF THE ATF DAMPING RING
por: Christian, G B, et al.
Publicado: (2011)

Transverse Beam Jitter Propagation in Multi-Bunch Operation at ATF2
por: Resta-Lopez, J, et al.
Publicado: (2011)

Status of the CLIC Beam Delivery System
por: Tomás, R, et al.
Publicado: (2010)

FABRICATION AND VALIDATION OF THE PROTOTYPE SUPPORTING SYSTEM FOR THE CLIC TWO-BEAM MODULES
por: Gazis, N, et al.
Publicado: (2011)

Modal Analysis and Measurement of Water Cooling Induced Vibrations on a CLIC Main Beam Quadrupole Prototype
por: Artoos, K, et al.
Publicado: (2011)

CAVITY BEAM POSITION MONITOR SYSTEM FOR ATF2
por: Boogert, S T, et al.
Publicado: (2010)

Beam Delivery System Dogleg Design and Integration for the International Linear Collider
por: Jones, J, et al.
Publicado: (2010)

Beam Trajectory control of the future Compact LInear Collider beam
por: Balik, G, et al.
Publicado: (2011)

DESIGN AND PERFORMANCE OF INTRA-TRAIN FEEDBACK SYSTEMS AT ATF2
por: Resta-Lopez, J, et al.
Publicado: (2009)

A sensitiviy analysis for the stabilization of the CLIC main beam quadrupoles
por: Janssens, S, et al.
Publicado: (2010)

Stabilization and Fine Positioning to the Nanometre Level of the CLIC Main Beam Quadrupoles
por: Artoos, K, et al.
Publicado: (2010)

The CLIC Drive Beam Phase Monitor
por: Marcellini, F, et al.
Publicado: (2010)

PRELIMINARY DESIGN OF CLIC MAIN BEAM MAGNETS REQUIRED FOR THE BEAM TRANSPORT. Project Breakdown Structure (PBS): 1.3
por: Vorozhtsov, A
Publicado: (2011)

CLIC two-beam module design and integration
por: Riddone, G, et al.
Publicado: (2010)

Laser Wire and Beam Position Monitor tests
por: Boogert, S T, et al.
Publicado: (2013)

System control for the CLIC main beam quadrupole stabilization and nano-positioning
por: Janssens, S, et al.
Publicado: (2011)

STUDY OF THE STABILIZATION TO THE NANOMETER LEVEL OF MECHANICAL VIBRATIONS OF THE CLIC MAIN BEAM QUADRUPOLES
por: Artoos, K, et al.
Publicado: (2009)

CAVITY BEAM POSITION MONITOR SYSTEM FOR ATF2
por: Boogert, S T, et al.
Publicado: (2011)

Development of an Eccentric CAM Based Active Pre-Alignment System for the CLIC Main Beam Quadrupole Magnet
por: Lackner, F, et al.
Publicado: (2010)

Studies on the thermo-mechanical behavior of the CLIC two-beam module
por: Nousiainen, R, et al.
Publicado: (2010)

Drive Beam Phase Measurement using RF data from the PETS
por: Ogburn, Daniel, et al.
Publicado: (2011)

CALIBRATION ERRORS IN THE CAVITY BEAM POSITION MONITOR SYSTEM AT THE ATF2
por: Cullinan, F, et al.
Publicado: (2011)

Beam Phase Monitor for CLIC and CTF3: pick-up design
por: Marcellini, F
Publicado: (2009)

Progress on modelling of the thermo-mechanical behavior of the CLIC two-beam module
por: Raatikainen, R, et al.
Publicado: (2011)

CLIC main beam quadrupole active pre-alignment based on cam movers
por: Kemppinen, J, et al.
Publicado: (2012)

CLIC TWO-BEAM MODULE FOR THE CLIC CONCEPTUAL DESIGN AND RELATED EXPERIMENTAL PROGRAM*
por: Samoshkin, A, et al.
Publicado: (2011)

PRELIMINARY DESIGN OF CLIC MAIN BEAM NORMAL CONDUCTING MAGNETS REQUIRED FOR THE DAMPING RINGS.
por: Vorozhtsov, A
Publicado: (2010)

PRELIMINARY DESIGN OF CLIC MAIN BEAM NORMAL CONDUCTING MAGNETS REQUIRED FOR THE POST COLLISION LINE.
por: Vorozhtsov, A
Publicado: (2010)

ATF2 COMMISSIONING
por: Seryi, A, et al.
Publicado: (2010)

Status of Ground Motion Mitigation Techniques for CLIC
por: Snuverink, J, et al.
Publicado: (2011)

Prototypes with descriptive report (technical, design and fabrication) of the hardware prepared for the test module
por: Gudkov, D, et al.
Publicado: (2013)

PRELIMINARY DESIGN OF CLIC DRIVE BEAM MAGNETS REQUIRED FOR THE: DELAY LINE, COMBINER RINGS, TURNAROUND, TRANSPORT TO TUNNEL, LONG TRANSFER LINE AND INJECTOR LINAC.
por: Vorozhtsov, A
Publicado: (2010)

Performance of the FONT3 Fast Analogue Intra-train Beam-based Feedback System at ATF
por: Burrows, P N, et al.
Publicado: (2006)

Design and Manufacture of a Main Beam Quadrupole Model for CLIC
por: Modena, Michele, et al.
Publicado: (2012)

Cannot write session to /tmp/vufind_sessions/sess_t3bg0fi3qhkkq0tp4tb9b5qlvp