Cargando…

Active Control of Quadrupole Motion for Future Linear Particle Colliders

The future Compact LInear particle Collider (CLIC) under study at CERN will require to stabilize heavy electromagnets, and also provide them some positioning capabilities. Firstly, this paper presents the concept adopted to address both requirements. Secondly, the control strategy adopted for the st...

Descripción completa

Detalles Bibliográficos
Autores principales:	Collette, Christophe, Artoos, Kurt, Kuzmin, Andrey, Sylte, Magnus, Guinchard, Michael, Hauviller, Claude
Formato:	info:eu-repo/semantics/article
Lenguaje:	eng
Publicado:	2009
Materias:	Accelerators and Storage Rings 9: Technology for normal conducting higher energy linear accelerators
Acceso en línea:	http://cds.cern.ch/record/1268422

Ejemplares similares

Active quadrupole stabilization for future linear particle colliders
por: Collette, Christophe, et al.
Publicado: (2010)

Hard Mounts for Quadrupole Nanopositioning in the Next Linear Particle Collider
por: Collette, C, et al.
Publicado: (2010)

Study of the electronics architecture for the mechanical stabilisation of the quadrupoles of the CLIC linear accelerator
por: Artoos, K, et al.
Publicado: (2010)

Compatibility and Integration of a CLIC Quadrupole Nanometre-Stabilization and Positioning system in a Large Accelerator Environment
por: Artoos, K, et al.
Publicado: (2010)

Nano-motion control of heavy quadrupoles for future particle colliders: An experimental validation
por: Collette, C, et al.
Publicado: (2011)

CLIC quadrupole stabilization and nano-positioning
por: Collette, C, et al.
Publicado: (2010)

Seismic response of linear accelerators
por: Collette, C, et al.
Publicado: (2010)

Stabilization and Fine Positioning to the Nanometre Level of the CLIC Main Beam Quadrupoles
por: Artoos, K, et al.
Publicado: (2010)

Stabilization and positioning of CLIC quadrupole magnets with sub-nanometre resolution
por: Janssens, S, et al.
Publicado: (2011)

Status of a study of stabilization and fine positioning of CLIC quadrupoles to the nanometre level
por: Artoos, K, et al.
Publicado: (2011)

System control for the CLIC main beam quadrupole stabilization and nano-positioning
por: Janssens, S, et al.
Publicado: (2011)

GROUND VIBRATION AND COHERENCE LENGTH MEASUREMENTS FOR THE CLIC NANO-STABILIZATION STUDIES
por: Artoos, K, et al.
Publicado: (2009)

Study of the hybrid controller electronics for the nano-stabilization of mechanical vibrations of CLIC quadrupoles
por: Fernandez Carmona, P, et al.
Publicado: (2011)

A sensitiviy analysis for the stabilization of the CLIC main beam quadrupoles
por: Janssens, S, et al.
Publicado: (2010)

STUDY OF THE STABILIZATION TO THE NANOMETER LEVEL OF MECHANICAL VIBRATIONS OF THE CLIC MAIN BEAM QUADRUPOLES
por: Artoos, K, et al.
Publicado: (2009)

Development of an Eccentric CAM Based Active Pre-Alignment System for the CLIC Main Beam Quadrupole Magnet
por: Lackner, F, et al.
Publicado: (2010)

Active vibration isolation of high precision machines
por: Collette, C, et al.
Publicado: (2010)

Modal Analysis and Measurement of Water Cooling Induced Vibrations on a CLIC Main Beam Quadrupole Prototype
por: Artoos, K, et al.
Publicado: (2011)

CLIC Quadrupole Module final report
por: Artoos, K, et al.
Publicado: (2013)

Status of Ground Motion Mitigation Techniques for CLIC
por: Snuverink, J, et al.
Publicado: (2011)

Beam Trajectory control of the future Compact LInear Collider beam
por: Balik, G, et al.
Publicado: (2011)

Beam Delivery System Dogleg Design and Integration for the International Linear Collider
por: Jones, J, et al.
Publicado: (2010)

Wake field suppression in high gradient linacs for lepton linear colliders
por: Jones, R
Publicado: (2009)

Theoretical and practical feasibility demonstration of a micrometric remotely controlled pre-alignment system for the CLIC linear collider
por: Mainaud Durand, H, et al.
Publicado: (2011)

DEVELOPMENT OF A FAST MICRON-RESOLUTION BEAM POSITION MONITOR SIGNAL PROCESSOR FOR LINEAR COLLIDER BEAMBASED FEEDBACK SYSTEMS
por: Apsimon, R, et al.
Publicado: (2009)

FUNCTIONAL REQUIREMENTS ON THE DESIGN OF THE DETECTORS AND THE INTERACTION REGION OF AN E+E- LINEAR COLLIDER WITH A PUSH-PULL ARRANGEMENT OF DETECTORS
por: Parker, B, et al.
Publicado: (2009)

CLIC main beam quadrupole active pre-alignment based on cam movers
por: Kemppinen, J, et al.
Publicado: (2012)

Validation of a Micrometric remotely controlled pre-alignment system for the CLIC Linear Collider using a test setup (Mock-Up) with 5 degrees of freedom
por: Mainaud Durand, H, et al.
Publicado: (2011)

Design and Manufacture of a Main Beam Quadrupole Model for CLIC
por: Modena, Michele, et al.
Publicado: (2012)

Design and Manufacture of a Hybrid Final Focus Quadrupole Model for CLIC
por: Modena, Michele, et al.
Publicado: (2012)

Design of the Clic main Linac accelerating structure for Clic conceptual design report
por: Grudiev, A, et al.
Publicado: (2010)

High power evaluation of X-band high power loads
por: Matsumoto, Shuji, et al.
Publicado: (2010)

Breakdown Studies for the CLIC Accelerating
por: Calatroni, S, et al.
Publicado: (2010)

Studies on the thermo-mechanical behavior of the CLIC two-beam module
por: Nousiainen, R, et al.
Publicado: (2010)

A high phase advance damped and detuned structure for the main linacs of CLIC
por: Khan, V.F., et al.
Publicado: (2010)

CLIC two-beam module design and integration
por: Riddone, G, et al.
Publicado: (2010)

Studies on high-precision machining and assembly of CLIC RF structures
por: Huopana, J, et al.
Publicado: (2010)

Wakefield monitor development for CLIC accelerating structure
por: Peauger, F, et al.
Publicado: (2010)

2D Arc-PIC Code Description: Methods and Documentation
por: Timko, H
Publicado: (2011)

PRELIMINARY DESIGN OF CLIC MAIN BEAM NORMAL CONDUCTING MAGNETS REQUIRED FOR THE POST COLLISION LINE.
por: Vorozhtsov, A
Publicado: (2010)

Cannot write session to /tmp/vufind_sessions/sess_tk8ra0k82l4ctff8d76hh41thi