Cargando…

Conceptual Design of a new Sample Holder for the Fresca Cable Test Station

At present Nb$_{3}$Sn Rutherford Cables seem to be the most suitable conductors for next generation superconducting accelerator magnets. These magnets will have a peak field in the coils larger than 10 T and the large Lorentz forces will impose coil pre-stresses significantly larger than 100 MPa. Si...

Descripción completa

Detalles Bibliográficos
Autores principales:	Bordini, B, Regis, F, Crettiez, O, Fessia, P, Guinchard, M, Perez, J C, Sexton, I
Lenguaje:	eng
Publicado:	2010
Materias:	Accelerators and Storage Rings
Acceso en línea:	https://dx.doi.org/10.1109/TASC.2009.2039707 http://cds.cern.ch/record/1282396

Ejemplares similares

40 kA Superconducting DC Transformer for the FRESCA test station
por: Vincent-Viry, O
Publicado: (2004)

CEA–CERN Block-Type Dipole Magnet for Cable Testing: FRESCA2
por: Rochepault, Etienne, et al.
Publicado: (2019)

Assembly, Loading, and Cool‐down of the FRESCA2 Support Structure
por: Muñoz Garcia, J E, et al.
Publicado: (2014)

Design and Fabrication of FRESCA2 Cryostat
por: Dallocchio, Alessandro, et al.
Publicado: (2022)

Electrical and Mechanical Performance of an Enhanced Cable Insulation Scheme for Superconducting Magnets
por: Fessia, P, et al.
Publicado: (2010)

Mechanical Validation of the Support Structure of the Magnet FRESCA2
por: Muñoz Garcia, J E, et al.
Publicado: (2015)

Mechanical Analysis of the FRESCA2 Dipole During Preload, Cool-Down, and Powering
por: Rochepault, Etienne, et al.
Publicado: (2018)

Development of the EuCARD Nb$_{3}$Sn Dipole Magnet FRESCA2
por: Ferracin, P, et al.
Publicado: (2013)

Development of the Nb$_{3}$Sn Rutherford Cable for the EuCARD High Field Dipole Magnet FRESCA2
por: Oberli, l
Publicado: (2013)

Design of the EuCARD High-Field Model Dipole Magnet FRESCA2
por: Milanese, A, et al.
Publicado: (2012)

Extensive Characterization of the 1 mm PIT Nb$_{3}$Sn strand for the 13-T FRESCA2 Magnet
por: Bordini, B, et al.
Publicado: (2012)

Performance Improvement of a Measurement Station for Superconducting Cable Test
por: Arpaia, P, et al.
Publicado: (2012)

Cold Powering Tests and Protection Studies of the FRESCA2 100 mm Bore Nb$_{3}$Sn Block-Coil Magnet
por: Willering, G, et al.
Publicado: (2018)

Assembly of the Nb$_{3}$Sn dipole magnet FRESCA2
por: Bourcey, Nicolas, et al.
Publicado: (2018)

Conceptual Design of a Large Aperture Dipole for Testing of Cables and Insert Coils at High Field
por: Bruzzone, Pierluigi, et al.
Publicado: (2017)

Simulation of the cabling process for Rutherford cables: An advanced finite element model
por: Cabanes, J, et al.
Publicado: (2016)

Fabrication and Assembly of the $Nb_3Sn$ Dipole Magnet FRESCA2
por: Rochepault, Etienne, et al.
Publicado: (2017)

Protection of the 13 T Nb$_{3}$Sn Fresca II dipole
por: Fazilleau, Ph., et al.
Publicado: (2014)

Design, Performance and Cabling Analysis of Nb3Sn Wires for the FCC Study
por: Hopkins, Simon C, et al.
Publicado: (2020)

Design and thermal calculations of FRESCA2 heat exchangers for pressurised superfluid helium baths temperature controlling
por: Polinski, J, et al.
Publicado: (2019)

“Block-Type” Coils Fabrication Procedure for the Nb$_3$Sn Dipole Magnet FRESCA2
por: Rondeaux, F, et al.
Publicado: (2016)

Protection of the 6 T YBCO insert in the 13 T Nb$_{3}$Sn Fresca II dipole
por: Stenvall, A., et al.
Publicado: (2014)

Heat Transfer in an Enhanced Cable Insulation Scheme for the Superconducting Magnets of the LHC Luminosity Upgrade
por: Granieri, P P, et al.
Publicado: (2010)

Thermally Enhanced Cable Insulation for the Nb-Ti High Luminosity LHC Inner Triplet Model
por: Granieri, P P, et al.
Publicado: (2012)

Tests of the FRESCA2 100 mm bore Nb$_3$Sn block-coil magnet to a record field of 14.6 T
por: Willering, Gerard, et al.
Publicado: (2019)

Computation of the Reversible Critical Current Degradation in Nb $_{3}$Sn Rutherford Cables for Particle Accelerator Magnets
por: Vallone, Giorgio, et al.
Publicado: (2018)

On the mechanisms governing the critical current reduction in Nb$_{3}$Sn Rutherford cables under transverse stress
por: De Marzi, Gianluca, et al.
Publicado: (2021)

On the effect of strand damage on the operating margin of a Nb$_3$Sn Rutherford cable
por: Succi, G, et al.
Publicado: (2022)

Quench Propagation in Nb$_3$Sn Rutherford Cables for the Hi-Lumi Quadrupole Magnets
por: Fleiter, J, et al.
Publicado: (2015)

Cable Design and R&D for NED
por: Leroy, D
Publicado: (2005)

New Methodology to Derive the Mechanical Behavior of Epoxy-Impregnated Nb$_3$Sn Cables
por: Fichera, Claudio, et al.
Publicado: (2019)

Semi-analytical approaches to magnet design
por: Borgnolutti, F, et al.
Publicado: (2009)

Characterization of Nb$_{3}$Sn Rutherford cables for the LHC 11-T Dipole Magnet
por: Wuis, A J, et al.
Publicado: (2014)

Conceptual Design of the LHC Interaction Region Upgrade: Phase-I
por: Ostojic, R, et al.
Publicado: (2008)

Installation Of Mobile Tilted Foil Holder At REX - ISOLDE
por: Eriksson, M
Publicado: (2010)

Design of the EuCARD high field model dipole magnet FRESCA2
por: Milanese, A, et al.
Publicado: (2011)

SSC conceptual design
por: SSC Central Design Group. Berkeley, Calif.
Publicado: (1986)

SSC conceptual design
por: SSC Central Design Group. Berkeley, Calif.
Publicado: (1986)

SSC conceptual design
por: SSC Central Design Group. Berkeley, Calif.
Publicado: (1986)

Cable Design and Development for the High-Temperature Superconductor Cable Test Facility Magnet
por: Pong, Ian, et al.
Publicado: (2021)

Cannot write session to /tmp/vufind_sessions/sess_a2tmpo469skl073tjv1tm770o4