Cargando…

Fast Dump of the ATLAS Toroids

The toroidal magnet system of the ATLAS Detector at CERN consists of a Barrel Toroid (BT) and two End Cap Toroids (ECT-A and ECT-C). Each toroid is built up from eight racetrack coils wound with an aluminum stabilized NbTi conductor and indirectly cooled by forced flow liquid helium. The three toroi...

Descripción completa

Detalles Bibliográficos
Autores principales:	Dudarev, A, Rolando, Gabriella, Volpini, Giovanni, Dudarev, Alexey, Kate, Herman Ten
Lenguaje:	eng
Publicado:	2010
Materias:	Detectors and Experimental Techniques Engineering
Acceso en línea:	https://dx.doi.org/10.1109/TASC.2010.2042695 http://cds.cern.ch/record/1359291

Ejemplares similares

Electro-mechanical behavior of the ATLAS toroids in fault condition
por: Foussat, A, et al.
Publicado: (2004)

Quench modeling of the ATLAS superconducting toroids
por: Gavrilin, A V, et al.
Publicado: (2001)

Completion of the Manufacturing of the ATLAS Barrel Toroid Magnet at CERN
por: Védrine, P, et al.
Publicado: (2006)

ATLAS End Cap Toroid Cold Mass and Cryostat Integration
por: Baynham, D E, et al.
Publicado: (2006)

Quench propagation and protection analysis of the ATLAS Toroids
por: Dudarev, A, et al.
Publicado: (2000)

Mechanical Commissioning of the ATLAS Barrel Toroid Magnet
por: Foussat, A, et al.
Publicado: (2008)

Cold Mass Integration of the ATLAS Barrel Toroid Magnets at CERN
por: Rey, J M, et al.
Publicado: (2006)

Manufacturing and integration progress of the ATLAS barrel toroid magnet at CERN
por: Védrine, P, et al.
Publicado: (2004)

ATLAS End Cap Toroid Integration and Test
por: Baynham, D E, et al.
Publicado: (2007)

ATLAS Superconducting Toroids: The Largest Ever Built
por: ten Kate, Herman H J
Publicado: (2010)

ATLAS B0 toroid model coil test at CERN
por: Miele, P, et al.
Publicado: (2002)

Theoretical and Experimental Investigation of the Ramp Losses in Conductor and Coil Casing of the ATLAS Barrel Toroid Coils
por: Rabbers, J J, et al.
Publicado: (2006)

On-Surface Test of the ATLAS Barrel Toroid Coils: Overview
por: Dudarev, A, et al.
Publicado: (2006)

ATLAS superconducting toroids and solenoid
por: ten Kate, H H J
Publicado: (2005)

The Superconducting Toroid for the New International AXion Observatory (IAXO)
por: Shilon, I., et al.
Publicado: (2013)

Assembly Concept and Technology of the ATLAS Barrel Toroid
por: Foussat, A, et al.
Publicado: (2006)

New Superconducting Toroidal Magnet System for IAXO, the International AXion Observatory
por: Shilon, I., et al.
Publicado: (2013)

Conceptual Design of a New Large Superconducting Toroid for IAXO, the New International AXion Observatory
por: Shilon, I., et al.
Publicado: (2012)

Commissioning Test of ATLAS End-Cap Toroidal Magnets
por: Dudarev, A, et al.
Publicado: (2009)

First full-size ATLAS barrel toroid coil successfully tested up to 22 kA at 4 T
por: Dudarev, A, et al.
Publicado: (2005)

Analysis of the discharge of the ATLAS barrel toroid and end cap toroids with different configurations of the protection circuit
por: Acerbi, E, et al.
Publicado: (2001)

20.5 kA current leads for ATLAS Barrel Toroid superconducting magnets
por: Dudarev, A, et al.
Publicado: (2002)

Progress on the conductor for the superconducting toroids of the ATLAS experiment
por: Rossi, L, et al.
Publicado: (1999)

The protection system of the superconducting coils in the Barrel Toroid of ATLAS
por: Acerbi, E, et al.
Publicado: (1999)

Experimental characterization of resistive joints for use inside ATLAS toroids
por: Volpini, G, et al.
Publicado: (2001)

A possible geometry for joints inside windings for ATLAS Barrel Toroid
por: Acerbi, E, et al.
Publicado: (1998)

Thermal and electrical behaviour of a resistive junction in the ATLAS toroids
por: Acerbi, E, et al.
Publicado: (1997)

Transient behaviour of a resistive joint in the ATLAS toroids during the magnet ramp-up and discharge
por: Volpini, G, et al.
Publicado: (2000)

Mechanical characteristics of the ATLAS B0 model coil
por: Foussat, A, et al.
Publicado: (2003)

Energy dump of the ATLAS superconducting system: simulations of electrical and thermal behaviour of magnet system at slow- and fast dump
por: van Beek, Martijn
Publicado: (2008)

A new approach for the protection system of the superconducting coils in the Barrel Toroid of ATLAS
por: Acerbi, E, et al.
Publicado: (1998)

New and Optimized Magnetization Scheme for the Baby Magnetized Iron Neutrino Detector at J-PARC
por: Rolando, Gabriella, et al.
Publicado: (2017)

Progress in the construction of the B0 model of the ATLAS Barrel Toroid magnet
por: Acerbi, E, et al.
Publicado: (2000)

Study of the thermal shield of the ATLAS Barrel Toroid in case of a fast discharge
por: Alessandria, F, et al.
Publicado: (1998)

Development of Joint Terminals for a New Six-Around-One ReBCO-CORC Cable-in-Conduit Conductor Rated 45 kA at 10T/4K
por: Mulder, Tim, et al.
Publicado: (2016)

Quench Protection of Very Large, 50-GJ-Class, and High-Temperature-Superconductor-Based Detector Magnets
por: Mentink, Matthias, et al.
Publicado: (2016)

The normal zone propagation in ATLAS B00 model coil
por: Boxman, E W, et al.
Publicado: (2002)

Thermal analysis of the ATLAS dump system
por: Wichrowska Polok, I
Publicado: (2003)

Evolution of the design of the ATLAS barrel toroid structure
por: Sun, L Z, et al.
Publicado: (2004)

ATLAS barrel superconducting toroid: conceptual design
por: Desportes, H, et al.
Publicado: (1992)

Cannot write session to /tmp/vufind_sessions/sess_gd93p9rhu7vvf7gen6pjblltv1