Cargando…

System control for the CLIC main beam quadrupole stabilization and nano-positioning

The conceptual design of the active stabilization and nano-positioning of the CLIC main beam quadrupoles was validated in models and experimentally demonstrated on test benches. Although the mechanical vibrations were reduced to within the specification of 1.5 nm at 1 Hz, additional input for the st...

Descripción completa

Detalles Bibliográficos
Autores principales:	Janssens, S, Artoos, K, Collette, E, Esposito, M, Fernandez Carmona, P, Guinchard, M, Hauviller, C, Kuzmin, A, Leuxe, R, Pfingstner, J, Schulte, D, Snuverink, J
Formato:	info:eu-repo/semantics/article
Lenguaje:	eng
Publicado:	2011
Materias:	Accelerators and Storage Rings 9: Technology for normal conducting higher energy linear accelerators
Acceso en línea:	http://cds.cern.ch/record/1423011

Ejemplares similares

Stabilization and Fine Positioning to the Nanometre Level of the CLIC Main Beam Quadrupoles
por: Artoos, K, et al.
Publicado: (2010)

Stabilization and positioning of CLIC quadrupole magnets with sub-nanometre resolution
por: Janssens, S, et al.
Publicado: (2011)

Status of a study of stabilization and fine positioning of CLIC quadrupoles to the nanometre level
por: Artoos, K, et al.
Publicado: (2011)

CLIC quadrupole stabilization and nano-positioning
por: Collette, C, et al.
Publicado: (2010)

Study of the electronics architecture for the mechanical stabilisation of the quadrupoles of the CLIC linear accelerator
por: Artoos, K, et al.
Publicado: (2010)

A sensitiviy analysis for the stabilization of the CLIC main beam quadrupoles
por: Janssens, S, et al.
Publicado: (2010)

Compatibility and Integration of a CLIC Quadrupole Nanometre-Stabilization and Positioning system in a Large Accelerator Environment
por: Artoos, K, et al.
Publicado: (2010)

Study of the hybrid controller electronics for the nano-stabilization of mechanical vibrations of CLIC quadrupoles
por: Fernandez Carmona, P, et al.
Publicado: (2011)

Modal Analysis and Measurement of Water Cooling Induced Vibrations on a CLIC Main Beam Quadrupole Prototype
por: Artoos, K, et al.
Publicado: (2011)

Development of an Eccentric CAM Based Active Pre-Alignment System for the CLIC Main Beam Quadrupole Magnet
por: Lackner, F, et al.
Publicado: (2010)

Active quadrupole stabilization for future linear particle colliders
por: Collette, Christophe, et al.
Publicado: (2010)

Nano-motion control of heavy quadrupoles for future particle colliders: An experimental validation
por: Collette, C, et al.
Publicado: (2011)

Hard Mounts for Quadrupole Nanopositioning in the Next Linear Particle Collider
por: Collette, C, et al.
Publicado: (2010)

STUDY OF THE STABILIZATION TO THE NANOMETER LEVEL OF MECHANICAL VIBRATIONS OF THE CLIC MAIN BEAM QUADRUPOLES
por: Artoos, K, et al.
Publicado: (2009)

Active Control of Quadrupole Motion for Future Linear Particle Colliders
por: Collette, Christophe, et al.
Publicado: (2009)

Status of Ground Motion Mitigation Techniques for CLIC
por: Snuverink, J, et al.
Publicado: (2011)

GROUND VIBRATION AND COHERENCE LENGTH MEASUREMENTS FOR THE CLIC NANO-STABILIZATION STUDIES
por: Artoos, K, et al.
Publicado: (2009)

CLIC Quadrupole Module final report
por: Artoos, K, et al.
Publicado: (2013)

CLIC main beam quadrupole active pre-alignment based on cam movers
por: Kemppinen, J, et al.
Publicado: (2012)

Seismic response of linear accelerators
por: Collette, C, et al.
Publicado: (2010)

Active vibration isolation of high precision machines
por: Collette, C, et al.
Publicado: (2010)

CLIC BDS Tuning, Alignment and Feedbacks Integrated Simulations
por: Dalena, B, et al.
Publicado: (2010)

Interaction point feedback design and integrated simulations to stabilize the CLIC final focus
por: Balik, G, et al.
Publicado: (2011)

Design and Manufacture of a Main Beam Quadrupole Model for CLIC
por: Modena, Michele, et al.
Publicado: (2012)

Design of the Clic main Linac accelerating structure for Clic conceptual design report
por: Grudiev, A, et al.
Publicado: (2010)

Validation of a Micrometric remotely controlled pre-alignment system for the CLIC Linear Collider using a test setup (Mock-Up) with 5 degrees of freedom
por: Mainaud Durand, H, et al.
Publicado: (2011)

Design and Manufacture of a Hybrid Final Focus Quadrupole Model for CLIC
por: Modena, Michele, et al.
Publicado: (2012)

Laser wire emittance measurement line AT CLIC
por: Garcia, H, et al.
Publicado: (2011)

INVESTIGATION OF AN ALTERNATE MEANS OF WAKEFIELD SUPPRESSION IN THE MAIN LINACS OF CLIC
por: Khan, V F, et al.
Publicado: (2009)

Status of the CLIC Beam Delivery System
por: Tomás, R, et al.
Publicado: (2010)

Influence of the Coil and the Magnet Support on the Modal Behaviour of the CLIC type 4 MBQ
por: Esposito, M
Publicado: (2012)

CLIC OVERVIEW
por: Tomas, R
Publicado: (2009)

A high phase advance damped and detuned structure for the main linacs of CLIC
por: Khan, V.F., et al.
Publicado: (2010)

Muon Backgrounds in CLIC
por: Burkhardt, H, et al.
Publicado: (2010)

CLIC TWO-BEAM MODULE FOR THE CLIC CONCEPTUAL DESIGN AND RELATED EXPERIMENTAL PROGRAM*
por: Samoshkin, A, et al.
Publicado: (2011)

PRELIMINARY DESIGN OF CLIC MAIN BEAM NORMAL CONDUCTING MAGNETS REQUIRED FOR THE DAMPING RINGS.
por: Vorozhtsov, A
Publicado: (2010)

PRELIMINARY DESIGN OF CLIC MAIN BEAM NORMAL CONDUCTING MAGNETS REQUIRED FOR THE POST COLLISION LINE.
por: Vorozhtsov, A
Publicado: (2010)

Breakdown Studies for the CLIC Accelerating
por: Calatroni, S, et al.
Publicado: (2010)

The CLIC Post-Collision Line
por: Gschwendtner, E, et al.
Publicado: (2010)

Muon Background Reduction in CLIC
por: Deacon, Lawrence, et al.
Publicado: (2012)

Cannot write session to /tmp/vufind_sessions/sess_6f7ndahiefk49l6ir00feft1v9