Cargando…

Status of CLIC MBQ and DBQ Prototypes Procurement

This paper gives the status of studies, design and prototype procurement for the magnets needed for the CLIC R&D and for the LAB and CLEX Test Programs.

Detalles Bibliográficos
Autor principal:	Modena, Michele
Lenguaje:	eng
Publicado:	2012
Materias:	Accelerators and Storage Rings
Acceso en línea:	http://cds.cern.ch/record/1427162

Ejemplares similares

CLIC QD0 "Short Prototype" Status
por: Modena, Michele
Publicado: (2012)

Influence of the Coil and the Magnet Support on the Modal Behaviour of the CLIC type 4 MBQ
por: ESPOSITO, M
Publicado: (2012)

Prototype Adjustable Permanent Magnet Quadrupoles For CLIC
por: Shepherd, Ben J A, et al.
Publicado: (2013)

Performance of the Optimized Mechanical Design of the CLIC Main-Beam Quadrupole Magnet Prototype
por: Modena, Michele, et al.
Publicado: (2020)

Influence of the Coil and the Magnet Support on the Modal Behaviour of the CLIC type 4 MBQ
por: Esposito, M
Publicado: (2012)

Preliminary Design of CLIC beam delivery System (CLIC BDS): Project Breakdown Structure (PBS): 4.1
por: Aloev, Alexander, et al.
Publicado: (2012)

Prototype Development of the CLIC Crab Cavities
por: Burt, Graeme, et al.
Publicado: (2014)

CLIC Final Focus Optics
por: Tomas, Rogelio, et al.
Publicado: (2013)

CLIC project R&D studies: the magnet system for the 3 TEV
por: Modena, Michele
Publicado: (2017)

Design of the anti-solenoid system for the CLIC SiD Experiment
por: Bartalesi, Antonio, et al.
Publicado: (2012)

Status of CLIC Magnets Studies
por: Modena, Michele, et al.
Publicado: (2011)

Tuning of Clic accelerating structure prototypes at CERN
por: Shi, J, et al.
Publicado: (2010)

Superconducting Wiggler Prototype for the CLIC Damping Rings
por: Bernhard, Axel, et al.
Publicado: (2013)

Test Results of the CLIC Damping Wiggler Prototype
por: Bragin, Alexey V, et al.
Publicado: (2016)

The ZEPTO Dipole: Zero Power Tuneable Optics for CLIC
por: Bainbridge, Alexander, et al.
Publicado: (2017)

CLIC Beam Delivery System
por: Tomas, Rogelio, et al.
Publicado: (2013)

The Prototype Inductive Adder With Droop Compensation for the CLIC Kicker Systems
por: Holma, J, et al.
Publicado: (2014)

CLIC Muon Sweeper Design
por: Aloev, A., et al.
Publicado: (2016)

First Experimental Results with the CLIC Drive Beam Phase Feedforward Prototype at the CLIC Test Facility CTF3
por: Christian, Glenn B, et al.
Publicado: (2016)

The Stripline Kicker Prototype for the CLIC Damping Rings at ALBA: Installation, Commissioning and Beam Characterisation
por: Pont, Montserrat, et al.
Publicado: (2018)

CLIC Status and Outlook
por: Stapnes, Stapnes
Publicado: (2012)

CLIC: Status and Plan
por: Sailer, Andre
Publicado: (2014)

Status of the CLIC study
por: Raubenheimer, T O
Publicado: (1997)

A prototype cavity beam position monitor for the CLIC Main Beam
por: Cullinany , F, et al.
Publicado: (2012)

Non-Linear Beam Dynamics Studies of the CLIC Damping Wiggler Prototype
por: Gethmann, Julian, et al.
Publicado: (2017)

Preparations for Beam Tests of a CLIC Damping Wiggler Prototype at ANKA
por: Bernhard, Axel, et al.
Publicado: (2013)

Design, Fabrication and Tests of the Second Prototype of the Double-Length CLIC PETS
por: Sánchez, Laura, et al.
Publicado: (2014)

Vacuum arc localization in CLIC prototype radio frequency accelerating structures
por: Rajamaki, Robin
Publicado: (2016)

Fabrication and validation of the prototype supporting system for the CLIC Two-Beam modules
por: Gazis, N, et al.
Publicado: (2011)

Experience on Fabrication and Assembly of the First CLIC Two-Beam Module Prototype
por: Gudkov, D, et al.
Publicado: (2013)

Effects of RF breakdown on the beam in a CLIC prototype accelerator structure
por: Palaia, A., et al.
Publicado: (2013)

Initial measurements on a prototype inductive adder for the CLIC kicker systems
por: Holma, Janne, et al.
Publicado: (2013)

3D FEA Computation of the CLIC Machine Detector Interface Magnets
por: Bartalesi, A, et al.
Publicado: (2012)

High Power Tests of a Prototype X-Band Accelerating Structure for CLIC
por: Zennaro, Riccardo, et al.
Publicado: (2017)

RF Design of the CLIC Structure Prototype Optimized for Manufacturing from Two Halves
por: Zha, Hao, et al.
Publicado: (2015)

Measurements and Laboratory Tests on a Prototype Stripline Kicker for the CLIC Damping Rings
por: Belver-Aguilar, C, et al.
Publicado: (2014)

Study and application of micrometric alignment on the prototype girders of the CLIC Two-Beam Module
por: Gazis, Nikolaos, et al.
Publicado: (2011)

Design and Manufacturing Description of the Prototype Striplines for the Extraction Kicker of the CLIC Damping Rings
por: Belver-Aguilar, C, et al.
Publicado: (2013)

Thermo-mechanical modelling and experimental validation of CLIC prototype module type 0
por: Kortelainen, Lauri
Publicado: (2013)

CLIC status and beam dynamics
por: Guignard, Gilbert
Publicado: (1993)

Cannot write session to /tmp/vufind_sessions/sess_j5ltbutrg9gebthate5fdgfgdo