Cargando…

Studies on the LHC superconducting circuits and routine qualification of their functionalities

The Large Hadron Collider (LHC) is systematically undergoing periods of maintenance stop (either 4-5 days stops or longer Christmas breaks), after which some or all superconducting circuits have to be re-commissioned to check the correct functionality of all powering and protection systems. Detailed...

Descripción completa

Detalles Bibliográficos
Autores principales:	Pojer, M, D’Angelo, G, Mompo, R, Schmidt, R, Solfaroli Camillocci, M
Lenguaje:	eng
Publicado:	2012
Materias:	Accelerators and Storage Rings
Acceso en línea:	http://cds.cern.ch/record/1459484

Ejemplares similares

Re-commissioning of the Superconducting Circuits
por: Solfaroli Camillocci, M, et al.
Publicado: (2015)

Optimization of the powering tests of the LHC superconducting circuits
por: Bellesia, B, et al.
Publicado: (2009)

Performance of the Superconducting Corrector Magnet Circuits during the Commissioning of the LHC
por: Venturini-Delsolaro, W, et al.
Publicado: (2008)

Magnet Circuits
por: Vergara Fernandez, A, et al.
Publicado: (2009)

Automatic System for the D.C. High Voltage Qualification of the Superconducting Electrical Circuits of the LHC Machine
por: Bozzini, D, et al.
Publicado: (2008)

A Statistical Analysis of Electrical Faults in the LHC Superconducting Magnets and Circuits
por: Bottura, Luca, et al.
Publicado: (2017)

Consolidation of the LHC Superconducting Magnets and Circuits
por: Tock, J Ph, et al.
Publicado: (2016)

Machine recovery and re-qualification
por: Zerlauth, M, et al.
Publicado: (2019)

Qualification of the Bypass Continuity of the Main Dipole Magnet Circuits of the LHC
por: Rowan, Scott, et al.
Publicado: (2015)

Energy Extraction for the LHC Superconducting Circuits
por: Dahlerup-Petersen, K, et al.
Publicado: (2001)

Construction and Qualification of the Pre-Series MQM Superconducting Quadrupoles for the LHC Insertions
por: Ostojic, R, et al.
Publicado: (2004)

Methods to detect faulty splices in the superconducting magnet system of the LHC
por: Bailey, R, et al.
Publicado: (2009)

Welding and Quality Control for the Consolidation of the LHC Superconducting Magnets and Circuits
por: Atieh, Said, et al.
Publicado: (2014)

Automated Execution and Tracking of the LHC Commissioning Tests
por: Fuchsberger, K, et al.
Publicado: (2012)

LHC Report: superconducting circuit powering tests
por: Mirko Pojer, et al.
Publicado: (2015)

Coordination of the commissioning of the LHC technical systems
por: Saban, R, et al.
Publicado: (2008)

Performance of the Main Dipole Magnet Circuits of the LHC during Commissioning
por: Verweij, A, et al.
Publicado: (2008)

Performance of the Protection System for Superconducting Circuits during LHC Operation
por: Denz, R, et al.
Publicado: (2011)

EYETS recovery
por: Camillocci, M Solfaroli, et al.
Publicado: (2017)

Status of the Consolidation of the LHC Superconducting Magnets and Circuits
por: Tock, J Ph, et al.
Publicado: (2014)

Experiments on the margin of beam induced quenches a superconducting quadrupole magnet in the LHC
por: Bracco, C, et al.
Publicado: (2012)

Measurement of the Residual Resistivity Ratio of the Bus Bars Copper Stabilizer of the 13 kA Circuits of the LHC
por: Apollonio, A, et al.
Publicado: (2012)

The Test Facility for the Short Prototypes of the LHC Superconducting Magnets
por: Arn, A, et al.
Publicado: (2001)

Qualification of ITER Correction Coil Superconducting Joint
por: Wang, Lin, et al.
Publicado: (2018)

Upgrade of the protection system for superconducting circuits in the LHC
por: Denz, R, et al.
Publicado: (2009)

LHC nominal cycle
por: Camillocci, M Solfaroli
Publicado: (2016)

Conductor-Limited Quenches of LHC Superconducting Main Dipoles
por: Pojer, M, et al.
Publicado: (2005)

Main Field Tracking Measurement in the LHC Superconducting Dipole and Quadrupole Magnets
por: Xydi, P, et al.
Publicado: (2008)

Automatic Analysis at the Commissioning of the LHC Superconducting Electrical Circuits
por: Reymond, H, et al.
Publicado: (2011)

FPGA Qualification and Failure Rate Estimation Methodology for LHC Environments Using Benchmarks Test Circuits
por: Scialdone, Antonio, et al.
Publicado: (2022)

Enhanced Diagnostic Systems for the Supervision of the Superconducting Circuits of the LHC
por: Denz, Reiner, et al.
Publicado: (2015)

Consolidation of the 13-kA Superconducting Magnet Circuits of the LHC at CERN
por: Lackner, F, et al.
Publicado: (2015)

Impact of the Voltage Transients after a Fast Power Abort on the Quench Detection System in the LHC Main Dipole Chain
por: Ravaioli, E, et al.
Publicado: (2012)

GEOMETRICAL TOLERANCES FOR THE QUALIFICATION OF LHC MAGNETS
por: Jeanneret, Jean Bernard
Publicado: (2006)

Measurement of the Residual Resistivity Ratio of the busbars copper stabilizer of the 13kA circuits of the LHC
por: Apollonio, A, et al.
Publicado: (2012)

Electrical Quality Assurance of the Superconducting Circuits during LHC Machine Assembly
por: Bozzini, D, et al.
Publicado: (2008)

Performance of the First LHC Pre-series Superconducting Dipoles
por: Bottura, L, et al.
Publicado: (2002)

Preparation and Execution of the Electrical Quality Assurance Program On the LHC Superconducting Circuits During the Second Long Shutdown
por: Ludwin, Jaromir, et al.
Publicado: (2021)

Consolidation of the LHC superconducting magnets and circuits during LS1
por: Tock, J Ph
Publicado: (2012)

Quench detection and diagnostic systems for the superconducting circuits for the HL-LHC
por: Denz, Reiner, et al.
Publicado: (2019)

Cannot write session to /tmp/vufind_sessions/sess_rfc5clg5n77r73ala3l7je4tlj