Cargando…

Beam screen - Cold bore concentricity

Detalles Bibliográficos
Autores principales:	Kos, N, Nikitina, L, Schneider, G, Veness, R
Lenguaje:	eng
Publicado:	1996
Materias:	Accelerators and Storage Rings
Acceso en línea:	http://cds.cern.ch/record/1636416

Ejemplares similares

Beam heat load measurements in the cold bore superconductive undulator in ANKA
por: Casalbuoni, S, et al.
Publicado: (2007)

Cold Leak Tests of LHC Beam Screens
por: Collomb-Patton, C, et al.
Publicado: (2008)

Measurements of the beam heat load in the cold bore superconductive undulator installed at ANKA
por: Casalbuoni, S
Publicado: (2007)

Cold bore experiments at CERN ISR
por: Benvenuti, Cristoforo, et al.
Publicado: (1979)

Dynamic vacuum behaviour of the Cold Bore saturated with hydrogen
por: Benvenuti, C, et al.
Publicado: (1978)

Long term Vacuum Test on an Unbaked Cold Bore
por: Benvenuti, C, et al.
Publicado: (1979)

Mechanical Design Aspects of The LHC Beam screen
por: Cruikshank, P, et al.
Publicado: (1997)

Beam Vacuum Interconnects for the LHC Cold Arcs
por: Veness, R J M, et al.
Publicado: (1999)

Beam induced heat loads on the beam-screens of the twin-bore magnets in the IRs of the HL-LHC
por: Iadarola, Giovanni, et al.
Publicado: (2016)

A vacuum cold bore test section at the CERN ISR
por: Benvenuti, Cristoforo, et al.
Publicado: (1977)

Conduction Cooled Beam Screen For the Short Straight Sections in the LHC
por: Schneider, G, et al.
Publicado: (1997)

Installation of beam screens in LHC arc cryomagnets
por: Cruikshank, P, et al.
Publicado: (1999)

A beam screen is inserted in one of the cryomagnet cold bores inside which the beam will be circulating
Publicado: (2003)

Cold Beam Vacuum Interconnects for the LHC Insertion Regions
por: Ramos, D, et al.
Publicado: (2004)

Technical specification for the supply of cold bore tubes for LHC dipole magnet prototypes
por: Main Magnets and Superconductors Group (LHC-MMS)
Publicado: (1998)

Behaviour of Cold Bore II during Run 921 - 31.3.1978
por: Benvenuti, C, et al.
Publicado: (1978)

Cold Bore Operation with a thin and a thick layer of condensed N2
por: Benvenuti, C, et al.
Publicado: (1980)

Device and Technique for In-situ Coating of the RHIC Cold Bore Vacuum Tubes with Thick OFHC
por: Hershcovitch, Ady, et al.
Publicado: (2013)

Operation of the Cold Bore with adsorbed helium, Run 1142 MD, 18th July 1980
por: Benvenuti, C, et al.
Publicado: (1980)

Development and test of single-bore $Cos \vartheta$ Nb$_3$Sn dipole models with cold iron yoke
por: Andreev, N, et al.
Publicado: (2002)

LHC Beam screen insertion tests with sliding rings
por: Kos, N
Publicado: (2000)

Behaviour of Cold Bore II during R 911 (28.2.78) and R 912
por: Benvenuti, C, et al.
Publicado: (1978)

P506 Prototype beam screens with reduced wall thickness
por: Kos, N
Publicado: (2000)

Cold Bore Operation with a thick layer of condensed N2 (R994, 2.11.1978)
por: Benvenuti, C, et al.
Publicado: (1978)

A Large Bore Pulsed Quadrupole Magnet for Transport of High Current Beams at Low Energies
por: Shuman, D B, et al.
Publicado: (2001)

Cold Powering Tests and Protection Studies of the FRESCA2 100 mm Bore Nb$_{3}$Sn Block-Coil Magnet
por: Willering, G, et al.
Publicado: (2018)

Specification for 10 CM-bore quadrupole beam transport magnets for the CERN MPS-division
por: Bossard, P
Publicado: (1968)

Performance study on proton-proton storage rings at several hundred GeV/c: cold bore vacuum stability
por: Calder, R
Publicado: (1974)

Preliminary Design of the HiLumi-LHC Triplet Area Beam Screen
por: Kersevan, R, et al.
Publicado: (2014)

Run 914 M, Observations VLOG avec 30 A dans R1 (Cold Bore refroidi)
por: Laurent, J M
Publicado: (1978)

First cooling in the ISR of the Cold Bore II to 4.2 K during Run 914 (6-7 March 1978)
por: Benvenuti, C, et al.
Publicado: (1978)

Quadrupole and Sextupole for Dual Bore Ring
por: Mikhailichenko, A A
Publicado: (2001)

Dynamic vacuum behaviour of the cold bore saturated with a thin and thick layer of hydrogen (Run 1202, 14th June 1981)
por: Benvenuti, C, et al.
Publicado: (1981)

Prototype beam screens for LHC dipole magnets from co-laminated stainless steel in 16 metre lengths
por: Kos, N
Publicado: (1996)

Heat Flow Measurements on Beam Screens with and without Supports
por: Bozzini, D, et al.
Publicado: (1999)

The ATLAS beam vacuum system
por: Veness, R
Publicado: (2009)

The Design of Cold to Warm Transitions of the LHC
por: Knaster, J R, et al.
Publicado: (2004)

Some Features of Superconducting Dual Bore Lens
por: Mikhailichenko, A A
Publicado: (1999)

Measurement of the mechanical behaviour of the LHC beam screen during a quench
por: Martínez-Darve, J, et al.
Publicado: (2001)

Chapter 13: Beam instrumentation and long-range beam–beam compensation
por: Jones, R, et al.
Publicado: (2020)

Cannot write session to /tmp/vufind_sessions/sess_4ldbmd8544a5s7srt8m2ar91jh