Cargando…

Cosϑ magnet design option

Detalles Bibliográficos
Autor principal:	Lorin, C
Formato:	info:eu-repo/semantics/article
Lenguaje:	eng
Publicado:	2015
Materias:	Accelerators and Storage Rings 10: Future Magnets (MAG) 10.3: 5 T HTS Dipole Magnet Design and Construction
Acceso en línea:	http://cds.cern.ch/record/2014019

Ejemplares similares

Development of a Roebel-cable-based cosθ dipole: design and windability of magnet ends
por: Lorin, Clément, et al.
Publicado: (2016)

Cos-$\theta$ design of dipole inserts made of ReBCO-Roebel or BSCCO-Rutherford cables
por: Lorin, C, et al.
Publicado: (2015)

Accelerator Quality HTS Dipole Magnet Demonstrator designs for the EuCARD-2, 5 Tesla 40 mm Clear Aperture Magnet
por: Kirby, G, et al.
Publicado: (2014)

The EuCARD-2 Future Magnets European Collaboration for Accelerator-Quality HTS Magnets
por: Rossi, L, et al.
Publicado: (2014)

Modeling of Minimum Energy Required to Quench an HTS Magnet With a Strip Heater
por: Härö, E, et al.
Publicado: (2015)

HTS Dipole Magnet for a Particle Accelerator using a Twisted Stacked Cable
por: Himbele, John J., et al.
Publicado: (2016)

Magnetization Losses of Roebel Cable Samples with 2G YBCO Coated Conductor Strands
por: Yang, Y., et al.
Publicado: (2016)

Study of a 5T Research Dipole Insert-Magnet using an Anisotropic ReBCO Roebel Cable
por: Van Nugteren, J, et al.
Publicado: (2015)

Advances in the Development of a 10-kA Class REBCO cable for the EuCARD2 Demonstrator Magnet
por: Badel, A., et al.
Publicado: (2016)

Modeling Quench Protection Heater Delays in an HTS Coil
por: Salmi, T, et al.
Publicado: (2014)

Performance tests of prototype high field HTS coils in Grenoble
por: Miyoshi, Y, et al.
Publicado: (2014)

Influence of the oxygen partial pressure on the phase evolution during Bi-2212 wire melt processing
por: Scheuerlein, C., et al.
Publicado: (2016)

Comparison of electromechanical properties and lattice distortions of different cuprate high temperature superconductors
por: Scheuerlein, C., et al.
Publicado: (2016)

Hot Spot Temperature in an HTS Coil: Simulations With MIITs and Finite Element Method
por: Härö, E, et al.
Publicado: (2015)

Variation of Quench Propagation Velocities in YBCO Cables
por: Härö, E., et al.
Publicado: (2015)

Enhancement of the transverse stress tolerance of REBCO Roebel cables by epoxy impregnation
por: Otten, S., et al.
Publicado: (2015)

Electromechanical behaviour of REBCO tape lap splices under transverse compressive loading
por: Grether, A, et al.
Publicado: (2016)

Measurement and Numerical Evaluation of AC-Losses in a ReBCO Roebel Cable at 4.5 K
por: van Nugteren, J., et al.
Publicado: (2016)

High Temperature Superconductor Accelerator Magnets
por: Van Nugteren, Jeroen
Publicado: (2016)

Quantification of atrial cardiomyopathy disease severity by electroanatomic voltage mapping and cardiac magnetic resonance imaging
por: Sim, I, et al.
Publicado: (2023)

On Roebel Cable Geometry for Accelerator Magnet
por: Fleiter, J, et al.
Publicado: (2015)

Combining atrial activation maps for the big picture of simulated atrial fibrillation mechanisms
por: Ozgul, O, et al.
Publicado: (2023)

Local conduction velocities determined by non-invasive electrocardiographic imaging predict arrhythmia-free survival after pulmonary vein isolation
por: Invers-Rubio, E, et al.
Publicado: (2023)

Atrial fibrillation screening to prevent stroke in patients with high NT-proBNP - a post-hoc analysis of the randomized LOOP study
por: Diederichsen, S Z, et al.
Publicado: (2023)

Diagnostic accuracy of smart gadgets/wearable devices in detecting atrial fibrillation in primary prevention: a meta-analysis
por: Vetta, G, et al.
Publicado: (2023)

The relationship of plasma catestatin concentrations with the extension of left atrial fibrosis
por: Katic, J, et al.
Publicado: (2023)

Extended use of preprocedural data to detect expiratory airflow limitation in patients with atrial fibrillation scheduled for ablation
por: Hereijgers, M J M, et al.
Publicado: (2023)

The role of biomarkers, sleep apnea and echocardiography as predictors of atrial fibrillation in a pacemaker population
por: Santos Sanchez, A, et al.
Publicado: (2023)

New parameter of the second part of the P-wave predict atrial fibrillation: comparison with P-wave signal-averaged electrocardiography
por: Lee, Y, et al.
Publicado: (2023)

Active monitoring for atrial fibrillation (AMALFI): a streamlined randomised controlled trial of remote screening for subclinical atrial fibrillation
por: Wijesurendra, R, et al.
Publicado: (2023)

Rigorous and long-term cardiac monitoring strategy in cryptogenic stroke or TIA patients in a tertiary care centre results in a two-fold increase in AF detection
por: Wouters, F, et al.
Publicado: (2023)

Left atrial dimensions and left atrial appendage morphology: differences in paroxysmal versus persistent atrial fibrillation patients
por: Pongratz, J, et al.
Publicado: (2023)

Mechanical Effects of the Non-Uniform Current Distribution on HTS Coils for Accelerators Wound with REBCO Roebel Cable
por: Murtomaki, Jaakko S, et al.
Publicado: (2017)

Latest developments and challenges in developing Coated Conductor magnets for accelerators within EuCARD-2
por: Goldacker, W, et al.
Publicado: (2016)

Superconducting Magnets R&D in the 10-20 T range for energy frontier machines
por: Lucio, R
Publicado: (2014)

Magnet yoke pieces
por: Pascal Petiot
Publicado: (2000)

LHCb Magnet assembly status
por: Koppenburg, P
Publicado: (2004)

The magnet and detector tests on point 5 surface come to an end. Pictures from the magnet and detector control rooms.
por: G. Perinic, et al.
Publicado: (2005)

First plate of LHCb Magnet Yoke in place
por: Lindner, R.
Publicado: (2003)

Parts of CMS Magnet Barrel Yoke at PS.
Publicado: (2000)

Cannot write session to /tmp/vufind_sessions/sess_0sn568k5vjgolnkbvf6qa7on4n