The TileCal Energy Reconstruction for LHC Run2 and Future Perspectives

The Tile Calorimeter (TileCal) is the main hadronic calorimeter of ATLAS and it covers the central part of the detector (|eta|<1.6). The energy deposited by the particles in TileCal is read out by approximately 10,000 channels. The signal provided by the readout electronics for each channel is digitized at 40 MHz and its amplitude is estimated by an optimal filtering algorithm. The increase of LHC luminosity leads to signal pile-up that deforms the signal of interest and compromises the amplitude estimation performance. This work presents the proposed algorithm for energy estimation during LHC Run 2. The method is based on the same approach used during LHC Run 1, namely the Optimal Filter (OF). The only difference is that the signal baseline (pedestal) will be subtracted from the received digitized samples, while in Run 1 this quantity was estimated on an event-by-event basis. The pedestal value is estimated through special calibration runs and it is stored in a data base for online and offline usage. Additionally, the background covariance matrix will also be used for the computation of the OF weights for high occupancy channels. The use of such information reduces the bias and uncertainties introduced by signal pile-up. The performance of the OF version used in Run 1 and Run 2 is compared using Monte Carlo data. The efficiency achieved by the methods is shown in terms of error estimation, when different conditions of luminosity and occupancy are considered. Concerning future work, a new method based on linear signal deconvolution has been recently proposed and it is under validation. It could be used for Run 2 offline energy reconstruction and future upgrades.