Design, Construction and Testing of the Digital Hadron Calorimeter (DHCAL) Electronics

A novel hadron calorimeter is being developed for future lepton colliding beam detectors. The calorimeter is optimized for the application of Particle Flow Algorithms (PFAs) to the measurement of hadronic jets and features a very finely segmented readout with 1 x 1 cm2 cells. The active media of the...

Descripción completa

Detalles Bibliográficos
Autores principales: Adams, C., Bambaugh, A., Bilki, B., Butler, J., Corriveau, F., Cundiff, T., Drake, G., Francis, K., Guarino, V., Haberichter, B., Hazen, E., Hoff, J., Holm, S., Kreps, A., DeLurgio, P., Dal Monte, L., Mucia, N., Norbeck, E., Northacker, D., Onel, Y., Pollack, B., Repond, J., Schlereth, J., Smith, J.R., Trojand, D., Underwood, D., Velasco, M., Walendziak, J., Wood, K., Wu, S., Xia, L., Zhang, Q., Zhao, A.
Lenguaje:eng
Publicado: 2016
Materias:
Detectors and Experimental Techniques
Acceso en línea:http://cds.cern.ch/record/2137432
Descripción
Sumario:A novel hadron calorimeter is being developed for future lepton colliding beam detectors. The calorimeter is optimized for the application of Particle Flow Algorithms (PFAs) to the measurement of hadronic jets and features a very finely segmented readout with 1 x 1 cm2 cells. The active media of the calorimeter are Resistive Plate Chambers (RPCs) with a digital, i.e. one-bit, readout. To first order the energy of incident particles in this calorimeter is reconstructed as being proportional to the number of pads with a signal over a given threshold. A large-scale prototype calorimeter with approximately 500,000 readout channels has been built and underwent extensive testing in the Fermilab and CERN test beams. This paper reports on the design, construction, and commissioning of the electronic readout system of this prototype calorimeter. The system is based on the DCAL front-end chip and a VME-based back-end.

Ejemplares similares