Cargando…

Iron-free detector magnet options for the future circular collider

In this paper, several iron-free solenoid-based designs of a detector magnet for the future circular collider for hadron-hadron collisions (FCC-hh) are presented. The detector magnet designs for FCC-hh aim to provide bending power for particles over a wide pseudorapidity range (0 ≤ jηj ≤ 4). To achi...

Descripción completa

Detalles Bibliográficos
Autores principales:	Mentink, Matthias, Dudarev, Alexey, Pais Da Silva, Helder Filipe, Rolando, Gabriella, Cure, Benoit, Gaddi, Andrea, Klyukhin, Slava, Gerwig, Hubert, Wagner, Udo, Ten Kate, Herman
Publicado:	2016
Materias:	Accelerators and Storage Rings
Acceso en línea:	https://dx.doi.org/10.1103/PhysRevAccelBeams.19.111001 http://cds.cern.ch/record/2238521

Ejemplares similares

Design of a 56-GJ Twin Solenoid and Dipoles Detector Magnet System for the Future Circular Collider
por: Mentink, Matthias, et al.
Publicado: (2016)

Design of 4 Tm Forward Dipoles for the FCC-hh Detector Magnet System
por: Mentink, Matthias, et al.
Publicado: (2017)

Superconducting detector magnets baseline designs for particle physics experiments at the Future Circular Collider
por: Bielert, Erwin, et al.
Publicado: (2019)

Design of the Optional Forward Superconducting Dipole Magnet for the FCC-hh Detector
por: Bielert, Erwin R, et al.
Publicado: (2018)

Preliminary Conductor Layouts for the Detector Magnets of the Future Circular Collider
por: Berriaud, C, et al.
Publicado: (2016)

Superconducting Magnet with the Minimum Steel Yoke for the Hadron Future Circular Collider Detector
por: Klyukhin, V.I., et al.
Publicado: (2016)

Superconducting Magnet with the Reduced Barrel Yoke for the Hadron Future Circular Collider
por: Klyukhin, V.I., et al.
Publicado: (2015)

Comparison of the Baseline and the Minimal Steel Yoke Superconducting Magnets for the Future Circular Hadron-Hadron Collider
por: Klyukhin, V.I., et al.
Publicado: (2022)

Conceptual development of a novel ultra-thin and transparent 2 T superconducting detector solenoid for the Future Circular Collider
por: Kulenkampff, Tobias, et al.
Publicado: (2019)

Design and Quench Analysis of Superconducting Solenoids for the Lepton Future Circular Collider
por: Deelen, N, et al.
Publicado: (2022)

New and Optimized Magnetization Scheme for the Baby Magnetized Iron Neutrino Detector at J-PARC
por: Rolando, Gabriella, et al.
Publicado: (2017)

Using the Standard Linear Ramps of the CMS Superconducting Magnet for Measuring the Magnetic Flux Density in the Steel Flux Return Yoke
por: Klyukhin, Vyacheslav, et al.
Publicado: (2018)

Aluminium-Stabilized High-Temperature Superconducting Cable for Particle Detector Magnets
por: Vaskuri, Anna, et al.
Publicado: (2023)

Superconducting Detector Magnet for BabyIAXO
por: Bykovskiy, Nikolay, et al.
Publicado: (2021)

MOSFET-based HTS flux pump
por: Jurčo, Róbert, et al.
Publicado: (2023)

Fast Dump of the ATLAS Toroids
por: Dudarev, A, et al.
Publicado: (2010)

Material options for the superconducting rf system of the Future Circular Collider
por: Aull, Sarah, et al.
Publicado: (2018)

Design and Manufacturing of a 45 kA at 10 T REBCO-CORC Cable-in-Conduit Conductor for Large-Scale Magnets
por: Mulder, Tim, et al.
Publicado: (2016)

High Energy Booster Options for a Future Circular Collider at CERN
por: Stoel, Linda, et al.
Publicado: (2016)

Status of the High Energy Booster of the lepton option of the future circular collider
por: Dalena, B, et al.
Publicado: (2022)

The CMS Magnetic Field Measuring and Monitoring Systems
por: Klyukhin, Vyacheslav, et al.
Publicado: (2022)

Development of Joint Terminals for a New Six-Around-One ReBCO-CORC Cable-in-Conduit Conductor Rated 45 kA at 10T/4K
por: Mulder, Tim, et al.
Publicado: (2016)

Measuring the Magnetic Flux Density with Flux Loops and Hall Probes in the CMS Magnet Flux Return Yoke
por: Curé, B., et al.
Publicado: (2016)

Measuring the Magnetic Flux Density in the CMS Steel Yoke
por: Klyukhin, V.I., et al.
Publicado: (2012)

Flux Loop Measurements of the Magnetic Flux Density in the CMS Magnet Yoke
por: Klyukhin, V.I., et al.
Publicado: (2016)

Mechanical Design and Analysis of the Baby-IAXO Magnet Cold Mass, Cryostat and Support System
por: Pais Da Silva, Helder, et al.
Publicado: (2020)

Design of the BabyIAXO Superconducting Detector Magnet
por: Bykovskiy, Nikolay, et al.
Publicado: (2020)

Quench Protection of Very Large, 50-GJ-Class, and High-Temperature-Superconductor-Based Detector Magnets
por: Mentink, Matthias, et al.
Publicado: (2016)

Coupling impedance and single beam collective effects for the future circular collider (lepton option)
por: Belli, Eleonora
Publicado: (2019)

EuroCirCol 16 T Block-Coils Dipole Option for the Future Circular Collider
por: Lorin, Clement, et al.
Publicado: (2016)

Summary of the Workshop on Superconducting Detector Magnets
por: Mentink, Matthias, et al.
Publicado: (2022)

Validation of the CMS Magnetic Field Map
por: Klyukhin, V.I., et al.
Publicado: (2016)

Developing the Technique of Measurements of Magnetic Field in the CMS Steel Yoke Elements With Flux-Loops and Hall Probes
por: Klyukhin, V.I., et al.
Publicado: (2011)

Analysis of eddy current distributions in the CMS magnet yoke during the solenoid discharge
por: Klyukhin, V.I., et al.
Publicado: (2011)

Self-Protecting HTS Current Lead-Demonstration of a New Technology
por: Dudarev, Alexey, et al.
Publicado: (2020)

Ultra-Thin Solenoid and Cryostat Development for Novel Detector Magnets
por: Ilardi, Veronica, et al.
Publicado: (2021)

Design and Principles of Synchrotrons and Circular Colliders: Electron-Positron Circular Colliders
por: Jowett, J M
Publicado: (2013)

Engineering challenges in mechanics and electronics in the world’s first particle-flow calorimeter at a hadron collider: The CMS high-granularity calorimeter
por: Gerwig, Hubert
Publicado: (2022)

Future Circular Colliders
por: Benedikt, M, et al.
Publicado: (2019)

Future Circular Colliders
por: Benedikt, Michael, et al.
Publicado: (2015)

Cannot write session to /tmp/vufind_sessions/sess_pnbnqan2rqgp2e1v1m8mi2pc2j