Cargando…

Parameterization of the critical surface of REBCO conductors from Bruker

Parameterization of the critical surface of REBCO conductors will help determine the performance of such high temperature superconducting tapes/

Detalles Bibliográficos
Autores principales:	Danial, Muhammad, Van Nugteren, Jeroen
Lenguaje:	eng
Publicado:	2017
Materias:	Accelerators and Storage Rings
Acceso en línea:	http://cds.cern.ch/record/2277484

Ejemplares similares

Towards REBCO 20T+ dipoles for accelerators
por: van Nugteren, Jeroen, et al.
Publicado: (2018)

Electron Beam Characterization of REBCO-Coated Conductors at Cryogenic Conditions
por: Haubner, Michal, et al.
Publicado: (2023)

Investigation of REBCO Roebel Cable Irreversible Critical Current Degradation Under Transverse Pressure
por: Murtomaki, Jaakko Samuel, et al.
Publicado: (2018)

Evaluation of the nonlinear surface resistance of REBCO coated conductors for their use in the FCC-hh beam screen
por: Krkotić, P, et al.
Publicado: (2022)

High frequency response of thick REBCO coated conductors in the framework of the FCC study
por: Romanov, Artur, et al.
Publicado: (2020)

Effect of resin impregnation on the transverse pressure dependence of the critical current in ReBCO Roebel cables
por: Gao, P, et al.
Publicado: (2019)

Evaluation of the surface impedance of ReBCO coated conductors and requirements for their use as beam screen materials for the FCC-hh
por: Krkotic, Patrick
Publicado: (2023)

Potential impedance reduction by REBCO-coated conductors as beam screen coating for the Future Circular Hadron Collider
por: Krkotić, P, et al.
Publicado: (2022)

Bending Radius Limits of Different Coated REBCO Conductor Tapes - An Experimental Investigation with Regard to HTS Undulators
por: Richter, Sebastian C, et al.
Publicado: (2021)

Performance of high-temperature superconducting REBCO coated conductors under synchrotron irradiation for future circular colliders
por: Krkotić, Patrick, et al.
Publicado: (2023)

Inter-strand resistance and AC loss in resin-filler impregnated ReBCO Roebel cables
por: Gao, P, et al.
Publicado: (2019)

Transverse Thermal Conductivity of REBCO Coated Conductors
por: M. Bonura, M, et al.
Publicado: (2014)

Differential geometry method for minimum hard-way bending 3D design of coils with ReBCO tape conductor
por: Nes, T H, et al.
Publicado: (2022)

Control of power supplies type "bruker"
por: Coudert, G, et al.
Publicado: (1993)

Field and temperature scaling of the critical current density in commercial REBCO coated conductors
por: Senatore, Carmine, et al.
Publicado: (2016)

High-field thermal transports properties of REBCO coated conductors
por: Bonura, M, et al.
Publicado: (2015)

Effective Time Constants at 4.2 to 70 K in ReBCO Pancake Coils With Different Inter-Turn Resistances
por: Nes, T H, et al.
Publicado: (2022)

Idealized Coil Cross-Sections with Minimized Conductor Area for High Field Dipoles
por: van Nugteren, Jeroen, et al.
Publicado: (2018)

Measurement and Analysis of Normal Zone Propagation in a ReBCO Coated Conductor at Temperatures Below 50K
por: van Nugteren, J, et al.
Publicado: (2015)

First Cold Powering Test of REBCO Roebel Wound Coil for the EuCARD2 Future Magnet Development Project
por: Kirby, Glyn A, et al.
Publicado: (2017)

Small REBCO isotropic round wire (STAR): an important step from performant material to practical conductor in high field HTS magnets
por: Rossi, Lucio
Publicado: (2019)

In-Field Electrical Resistance at 4.2 K of REBCO Splices
por: Fleiter, Jerome, et al.
Publicado: (2017)

Status of the EuCARD 5.4-T REBCO Dipole Magnet
por: Borgnolutti, F, et al.
Publicado: (2016)

Mechanical Effects of the Non-Uniform Current Distribution on HTS Coils for Accelerators Wound with REBCO Roebel Cable
por: Murtomaki, Jaakko S, et al.
Publicado: (2017)

Design of a Cloverleaf-Racetrack Dipole Demonstrator Magnet With Dual $Re$BCO Conductor
por: Nes, T.H., et al.
Publicado: (2022)

Realization and First Test Results of the EuCARD 5.4-T REBCO Dipole Magnet
por: Durante, Maria, et al.
Publicado: (2018)

Development, Construction, and Commissioning of a Fully Automated Cabling Machine for Round Multi-Layer REBCO Cables
por: Barth, C, et al.
Publicado: (2023)

Measurement of splice resistance and normal zone propagation velocity in REBCO tapes for the Superconducting Link of HL-LHC
por: Matras, M, et al.
Publicado: (2020)

Critical Current Measurements On Nb$_{3}$Sn Conductors For The NED Project
por: den Ouden, A, et al.
Publicado: (2005)

High frequency response of thick REBCO coated conductors in the framework of the FCC study
por: Romanov, Artur, et al.
Publicado: (2020)

Development of ReBCO-CORC Wires With Current Densities of 400–600 A/mm$^{2}$ at 10 T and 4.2 K
por: Mulder, Tim, et al.
Publicado: (2018)

Specifications for conductors and proposed conductor configurations: Milestone M5.3
por: Bordini, Bernardo, et al.
Publicado: (2018)

Measurement and Numerical Evaluation of AC-Losses in a ReBCO Roebel Cable at 4.5 K
por: van Nugteren, J., et al.
Publicado: (2016)

Parameterization of secondary particle yields & neutrino beam simulation
por: Bonesini, M, et al.
Publicado: (2000)

Performance of first insert coil with REBCO CICC sub-size cable exceeding 6 kA at 21 T magnetic field
por: Zhou, Chao, et al.
Publicado: (2022)

Design and Preparation of Two ReBCO-CORC® Cable-In-Conduit Conductors for Fusion and Detector Magnets
por: Mulder, T, et al.
Publicado: (2017)

Study of a 5T Research Dipole Insert-Magnet using an Anisotropic ReBCO Roebel Cable
por: Van Nugteren, J, et al.
Publicado: (2015)

Critical Current, Electro-Mechanical Properties and Specific Heat of Bronze Nb$_{3}$Sn Conductors
por: Uglietti, D, et al.
Publicado: (2005)

Cos-$\theta$ design of dipole inserts made of ReBCO-Roebel or BSCCO-Rutherford cables
por: Lorin, C, et al.
Publicado: (2015)

Radiation damage tests of semi-conductors
por: Ohmori, C, et al.
Publicado: (2018)

Cannot write session to /tmp/vufind_sessions/sess_9gb1vf908b4bnf8a9dv69lrakj