Cargando…

Notes on design problems of Booster vacuum system

Detalles Bibliográficos
Autor principal:	Gould, C
Lenguaje:	eng
Publicado:	1968
Materias:	Accelerators and Storage Rings
Acceso en línea:	http://cds.cern.ch/record/2305365

Ejemplares similares

Booster vacuum system: Introductory note
por: Riboni, P
Publicado: (1966)

Proposed vacuum system for Booster ring
por: Gould, C, et al.
Publicado: (1968)

A short review of some aspects of the Booster vacuum system (RING)
por: Brianti, G, et al.
Publicado: (1968)

Booster Vacuum system - Chamber to Chamber Insulation
por: Unterlerchner, W
Publicado: (1968)

300 GeV booster design note no.4 - lattice (booster 7)
por: Wilson, Edmund J N
Publicado: (1969)

Vacuum tests in the Booster with sublimation pumps
por: Brouet, M
Publicado: (1988)

Specification for sector valves for the Synchrotron Injector (Booster) vacuum system
por: Unterlerchner, W
Publicado: (1970)

Vacuum System for the LNLS 500-MeV Booster Synchrotron
por: Ferreira, M J, et al.
Publicado: (2001)

Beam coupling impedances of the Booster vacuum flanges
por: Schneider, G C
Publicado: (1989)

Beam coupling impedances of the booster vacuum flanges
por: Schneider, G C
Publicado: (1989)

SI Parameter meeting N°6: Booster vacuum system
por: Brianti, G
Publicado: (1972)

The Vacuum Upgrade of the CERN PS and PS Booster
por: Van Rooij, M, et al.
Publicado: (1996)

Vacuum synoptic for Isolde area and Booster accelerator
por: Sanchez Alvarez, J L, et al.
Publicado: (2005)

General specification covering welded vacuum containments in PS Booster system
por: Pearce, N
Publicado: (1971)

Upgrading of vacuum control systems for Linac2, Linac3 and the PS booster
por: Gavaggio, R, et al.
Publicado: (1994)

Reduction of the impedance created by the insulated vacuum flanges in the PS Booster
por: Blas, A, et al.
Publicado: (2000)

Vacuum system design
por: Dennis, N T M, et al.
Publicado: (1968)

Vacuum system design
por: Poncet, Alain
Publicado: (1995)

Low cost vacuum hardware developed for the CERN PS Booster
por: Rufer, C E, et al.
Publicado: (1971)

Proposed vacuum system transfer lines
por: Gould, C, et al.
Publicado: (1968)

Reduction of the Impedance Created by the Insulated Vacuum Flanges in the PS Booster
por: Blas, A, et al.
Publicado: (2000)

Design of ring vacuum system
por: Rufer, C E
Publicado: (1969)

Technical Note N°92: Calculation of Eddy curent effects in the vacuum chambers of the BOOSTER Synchrotron quadrupole and bending magnets
por: Asner, A
Publicado: (1967)

300 GeV booster design note no.6 - correcting elements
por: Möhl, D, et al.
Publicado: (1969)

Specification for ceramic vacuum tubes forming the gap of the P.S. booster RF accelerating system
Publicado: (1976)

Vacuum Chamber Eddy Current Selfcorrection For The Ags booster accelerator
por: Danby, G T, et al.
Publicado: (1990)

Some crucial problems in the design of the booster for the 300 GeV synchrotron
por: Hardt, Werner
Publicado: (1969)

Further notes on calculation of pressures in the ISR vacuum system
por: Hulek, Z
Publicado: (1971)

Note on vacuum system of Serpukhov fast ejection equipment
por: Riboni, P
Publicado: (1967)

300 GeV booster design note no.7 - compensation of injection errors
por: Brückner, A, et al.
Publicado: (1969)

300 GeV booster design note no.5 - Q-jump at transition
por: Hardt, Werner, et al.
Publicado: (1969)

Specification for vacuum chambers and tubes of the first part of the injection line - Booster
por: Unterlerchner, W
Publicado: (1970)

Vacuum in particle accelerators: modelling, design and operation of beam vacuum systems
por: Malyshev, Oleg B
Publicado: (2020)

Suggestions for PS vacuum improvement
por: Gould, C
Publicado: (1968)

Design of the SNS Accumulator Ring Vacuum Systems
por: Hseuh, H C, et al.
Publicado: (1999)

The design and construction of small vacuum systems
por: Green, Geoffrey W
Publicado: (1968)

Technical note - First pump down of the AA vacuum system
por: Malthouse, H F
Publicado: (1980)

Vacuum science and engineering: properties of gases at low pressure, vacuum measurements, design and operating features of vacuum pumps and systems
por: Van Atta, C W
Publicado: (1965)

Design of the AGS booster beam position monitor system
por: Beadle, E R, et al.
Publicado: (1989)

Comments on the Note: "Utilisation du noveau systeme de controle du booster"
por: Delahaye, J P, et al.
Publicado: (1982)

Cannot write session to /tmp/vufind_sessions/sess_t0uo2lb3cd8f16dn1e9k3ki4re