Cargando…

Room temperature measurements of the molecular photodesorption yields from a TiZr getter film

Mostrar otras versiones (1)

Detalles Bibliográficos
Autor principal:	Baglin, V
Lenguaje:	eng
Publicado:	1998
Materias:	Engineering
Acceso en línea:	http://cds.cern.ch/record/2309812

Ejemplares similares

Room temperature measurements of the molecular photodesorption yields from a TiZr getter film
por: Baglin, V, et al.
Publicado: (1998)

The secondary electron yield of TiZr and TiZrV non evaporable getter thin film coatings
por: Scheuerlein, C, et al.
Publicado: (2000)

Lowering the activation temperature of TiZrV non-evaporable getter films
por: Taborelli, M, et al.
Publicado: (1999)

Lowering the activation temperature of TiZrV non-evaporable getter films [for LHC]
por: Prodromides, A E, et al.
Publicado: (2001)

Influence of the substrate coating temperature on the vacuum properties of Ti-Zr-V non-evaporable getter films
por: Costa-Pinto, P, et al.
Publicado: (2003)

Adsorption and desorption properties of TiZrV getter film at different temperatures in the presence of synchrotron radiation
por: Anashin, V V, et al.
Publicado: (2008)

A Photodesorption Study of a TiZrV Coated Stainless Steel Vacuum Chamber
por: Collins, I R, et al.
Publicado: (2002)

Electron stimulated molecular desorption of a non-evaporable Zr-V-Fe alloy getter at room temperature
por: Le Pimpec, Frederic, et al.
Publicado: (2002)

Effect of oxidation at an elevated temperature on the evolution of phases, microstructure, and properties of the oxide films formed on the surface of TiZr
por: Chang, Shih-Hang, et al.
Publicado: (2023)

Photodesorption and Electron Yield Measurements of Thin Film Coatings for Future Accelerators
por: Kersevan, Roberto, et al.
Publicado: (2015)

Vacuum properties of TiZrV non-evaporable getter films
por: Benvenuti, Cristoforo, et al.
Publicado: (1999)

Hydrogen Embrittlement of TiZrV Non-Evaporable Getter Coating
por: Parragh, David Mate
Publicado: (2022)

A Review of Titanium Zirconium (TiZr) Alloys for Use in Endosseous Dental Implants
por: Grandin, H. Michelle, et al.
Publicado: (2012)

Enhancing strength and ductility via crystalline-amorphous nanoarchitectures in TiZr-based alloys
por: Ming, Kaisheng, et al.
Publicado: (2022)

Room temperature pumping characteristics of a Zr-Al non-evaporable getter for individual gases
por: Benvenuti, Cristoforo, et al.
Publicado: (1988)

Room temperature pumping characteristics for gas mixtures of a Zr-Al non-evaporable getter
por: Benvenuti, Cristoforo, et al.
Publicado: (1989)

Vacuum properties of TiZrV non-evaporable getter films [for LHC vacuum system]
por: Benvenuti, Cristoforo, et al.
Publicado: (2001)

Greater Osseointegration Potential with Nanostructured Surfaces on TiZr: Accelerated vs. Real-Time Ageing
por: Stavropoulos, Andreas, et al.
Publicado: (2021)

Decreasing surface outgassing by thin film getter coatings
por: Benvenuti, Cristoforo, et al.
Publicado: (1998)

A Pilot Study with Randomised Controlled Design Comparing TiZr Alloy Dental Implants to Ti Implants
por: Hultin, Kristina, et al.
Publicado: (2020)

Molecular surface pumping: the getter pumps
por: Benvenuti, Cristoforo
Publicado: (1999)

Comparison of photodesorption yields using synchrotron radiation of low critical energies for stainless steel, copper, and electrodeposited copper surfaces
por: Gómez-Goñi, J, et al.
Publicado: (1994)

Some aspects of diffusion in niobium by high temperature gettering
por: Singer, W
Publicado: (1996)

Molecular desorption of a nonevaporable getter St 707 irradiated at room temperature with synchrotron radiation of 194 eV critical photon energy
por: Le Pimpec, F, et al.
Publicado: (2003)

The efficient photodesorption of nitric oxide (NO) ices
por: Dupuy, R., et al.
Publicado: (2017)

Investigation of synchrotron radiation-induced photodesorption in cryosorbing quasi-closed geometry
por: Anashin, V V, et al.
Publicado: (1994)

Influence of Barrier Layers on ZrCoCe Getter Film Performance
por: Shi, Xin, et al.
Publicado: (2023)

XPS analysis of the activation process in non-evaporable getter thin films
por: Lozano, M, et al.
Publicado: (2000)

Influence of the elemental composition and crystal structure on the vacuum properties of Ti-Zr-V non-evaporable getter films
por: Prodromides, A E, et al.
Publicado: (2001)

Cold beam tube photodesorption experiments for the SSCL 20 TeV proton collider
por: Anashin, V V, et al.
Publicado: (1993)

Ti-Zr-V non-evaporable getter films: from development to large scale production for the Large Hadron Collider
por: Chiggiato, P, et al.
Publicado: (2005)

The Activation of Ti-Zr-V-Hf Non-Evaporable Getter Films with Open-Cell Copper Metal Foam Substrates
por: Wang, Jie, et al.
Publicado: (2020)

Wafer-Scale Room-Temperature Bonding of Smooth Au/Ti-Based Getter Layer for Vacuum Packaging
por: Matsumae, Takashi, et al.
Publicado: (2022)

Microstructural Degradation of the AlMo(0.5)NbTa(0.5)TiZr Refractory Metal High-Entropy Superalloy at Elevated Temperatures
por: Whitfield, Tamsin E., et al.
Publicado: (2021)

A novel route to extreme vacua: the non-evaporable getter thin film coatings
por: Benvenuti, Cristoforo, et al.
Publicado: (1999)

Assessing the Functional Properties of TiZr Nanotubular Structures for Biomedical Applications, through Nano-Scratch Tests and Adhesion Force Maps
por: Vardaki, Maria, et al.
Publicado: (2021)

Vacuum-UV photodesorption from compact Amorphous Solid Water : photon energy, isotopic and temperature effects
por: Fillion, J.-H, et al.
Publicado: (2021)

Measurement of the elastic modulus of kapton perpendicular to the plane of the film at room and cryogenic temperatures
por: Davidson, M P, et al.
Publicado: (1992)

Photodesorption of Water Ices: Highlights from Recent Synchrotron Radiation Studies
por: Fillion, Jean-Hugues, et al.
Publicado: (2023)

Conference on Gettering and Defect Engineering in Semiconductors : GADEST '93
Publicado: (1993)

Cannot write session to /tmp/vufind_sessions/sess_nbij09k2v7erl3nb7ak05v05d5