Quality control for ATLAS Inner Tracker strip sensor production

With the upgrade of the LHC to the High-Luminosity LHC (HL-LHC), scheduled to be installed in 2024, the Inner Detector will be replaced with the new all-silicon ATLAS Inner Tracker (ITk) to maintain tracking performance in this high-occupancy environment and to cope with the increase of approximately a factor of ten in the integrated radiation dose. The outer four layers in the barrel and six disks in the endcap region will host strip modules, built with single-sided strip sensors and glued-on hybrids carrying the front-end electronics necessary for readout. The strip sensors are manufactured as n-in-p strip sensors from high-resistivity silicon, which allow operation even after fluences expected towards the end of the proposed lifetime of the HL-LHC. Prototypes of different sensor designs have been extensively tested electrically as well as in testbeam setups, yielding generally good results. Since pre-production is scheduled to start at the end of 2019, it is necessary to have a quality control (QC) procedure for strip sensors to confirm that manufactured sensors comply with specifications necessary for operation in the HL-LHC, ranging from generic electric properties to reliability of long-term operation. An overview over the QC procedure and its results will be given as well as details about the ongoing challenges.