Cargando…
CMS Brass Absorber
This brass block was part of the CMS experiment. Its role was to slow down particles before their energy was measured. The Compact Muon Solenoid (CMS) experiment is one of two large general-purpose particle physics detectors built on the Large Hadron Collider (LHC).
Publicado: |
2020
|
---|---|
Materias: | |
Acceso en línea: | http://cds.cern.ch/record/2717674 |
Ejemplares similares
-
Measurement of torque applied to the end plug central brass pin due to gas jumper
por: Borisov, A, et al.
Publicado: (1998) -
Response to muons, electrons and pions of a calorimeter constituted by small cross section brass tubes
por: Bocciolini, M, et al.
Publicado: (1987) -
Influence of the High Granularity Calorimeter Stainless Steel Absorbers onto the CMS Solenoid Inner Magnetic Field
por: Klyukhin, Vyacheslav
Publicado: (2021) -
FLUKA predictions of the absorbed dose in the HCAL Endcap scintillators using a Run1 (2012) CMS FLUKA model
por: CMS Collaboration
Publicado: (2016) -
Particle optics inside an absorber
por: Banaigs, J, et al.
Publicado: (1966)