Cargando…
Wire Materials for Scanners in the Large Hadron Collider: An Unusual Materials Selection Problem
The transverse distribution of particles in the hadron beam of the Large HadronCollider (LHC) is measured using wire scanners that pass a thin wire through thehadron beam and detect scattered radiation. Increasing demands on beaminstrumentation in the LHC leads one to consider the choice of material...
Autores principales: | Bigland, Hal, Huber, John E, Veness, Raymond, Cocks, Alan C F |
---|---|
Lenguaje: | eng |
Publicado: |
2020
|
Materias: | |
Acceso en línea: | https://dx.doi.org/10.1002/adem.201900927 http://cds.cern.ch/record/2815863 |
Ejemplares similares
-
Selection of Wires for the New Generation of Fast Wire Scanners at CERN
por: Mariet, Alexandre, et al.
Publicado: (2019) -
Cavity mode related wire breaking of the SPS Wire Scanners and loss measurements of wire materials
por: Roncarolo, Federico, et al.
Publicado: (2003) -
Cavity Mode Related Wire Breaking of the SPS Wire Scanners and Loss Measurements of Wire Materials
por: Caspers, Friedhelm, et al.
Publicado: (2003) -
Investigation of collimator materials for the High Luminosity Large Hadron Collider
por: Quaranta, Elena
Publicado: (2017) -
CERN-SPS Wire Scanner Impedance and Wire Heating Studies
por: Berrig, OE, et al.
Publicado: (2014)