Cargando…

Note on the "Proton Injection Time” (PIT) pulse

Mostrar otras versiones (1)

Detalles Bibliográficos
Autor principal:	Mulder, PB
Lenguaje:	eng
Publicado:	1960
Materias:	Accelerators and Storage Rings
Acceso en línea:	http://cds.cern.ch/record/2828691

Ejemplares similares

Note on the "Proton Injection Time" (PIT) pulse.
por: Mulder, P B
Publicado: (1960)

Correction to Note PS/Int.MG/RF 60-16: (A gate generator for the standard blocking oscillator)
por: Mulder, PB
Publicado: (1961)

Fast pulsed magnet systems for proton and antiproton injection into the CERN 400 GeV proton synchrotron
por: Frick, E, et al.
Publicado: (1982)

Injection of polarized protons into the proton synchrotron
por: Eaton, T W, et al.
Publicado: (1967)

A note on injection timing and tolerances for an A.G. synchrotron
Publicado: (1955)

Pulsed proton source for high current
por: Schneider, F
Publicado: (1957)

Pulsed proton source for high current
por: Schneider, F
Publicado: (1995)

Pulse compression in TTF injection II
por: Rosenzweig, J R
Publicado: (1995)

Pulsed magnets for injection and extraction at LSB
por: Travería, M, et al.
Publicado: (1996)

Localization and cure of PS booster multiturn injection pulse-to-pulse jitter
por: Gelato, G, et al.
Publicado: (1975)

Current pulse generator
por: Mulder, P B
Publicado: (1957)

Preliminary notes on the organization of the R.F. feed in linear accelerators during acceleration of 50-100 mA pulsed proton beams
por: Marin, B P
Publicado: (1963)

Preliminary notes on the organization of the R.F feed in linear accelerators during acceleration of 50-100 mA pulsed proton beams
por: Murin, B P
Publicado: (1963)

Balanced to unbalanced pulse transformer
por: Mulder, P B
Publicado: (1959)

A pulsed-beam transport system for the external proton beam of the CERN proton synchrotron
por: Langeseth, Bjarne
Publicado: (1964)

Pulsed Power Applications in High Intensity Proton Rings
por: Zhang, Wu, et al.
Publicado: (2005)

4-Decade Scaler for Μ.coincidence Unit
por: Mulder, PB
Publicado: (1960)

Distribution Scheme of RF acc.- and P.U. signals in the MCR
por: Mulder, PB
Publicado: (1960)

Linac Protection Circuits
por: Mulder, PB
Publicado: (1959)

Improvements of the Isolating Transformer.
por: Mulder, PB
Publicado: (1959)

A note about injection into CESAR and measurements on the injected beam
por: Pentz, Michael J
Publicado: (1963)

Crystal Collimation with protons at injection energy
por: Rossi, Roberto, et al.
Publicado: (2015)

Notes on betatron matching at EPA injection
por: Krusche, A
Publicado: (1983)

An estimation of the loss in antiproton yield caused by decreases in target density over times equal to the duration of the proton pulse
por: Eaton, Terry W
Publicado: (1986)

An estimation of the loss in antiproton yield caused by decreases in target density over times equal to the duration of the proton pulse
por: Eaton, T W
Publicado: (1986)

Effects of small offsets in the even pits
por: Keil, Eberhard
Publicado: (1995)

Modified odd pits for LEP with pretzels
por: Keil, Eberhard
Publicado: (1994)

Asymmetric horizontal bumps for the even pits
por: Keil, Eberhard
Publicado: (1994)

Synchronisation and tolerances for multi-pulse injection PS → SPS
por: Möhl, D
Publicado: (1976)

Injection of 3/2 CPS-pulses into ISR and shearing of pulses between the two storage rings
por: de Raad, B, et al.
Publicado: (1966)

Electrons And Protons Beam Produced By Ultra Short Laser Pulses
por: Malka, V, et al.
Publicado: (2004)

Injection Into A 300-Gev Proton Synchrotron
por: Resegotti, L
Publicado: (1963)

H- Injection Studies for the Fermilab Proton Driver
por: Prior, C R
Publicado: (2001)

Multiturn injection into the CERN Proton Synchrotron Booster
por: Van der Stok, P D V
Publicado: (1981)

Multiturn injection into the CERN proton synchrotron booster
por: van der Stok, P D V
Publicado: (1981)

Injection of protons and extraction of antiprotons at the antiproton decelerator
por: Mikkelsen, Ulrik
Publicado: (1998)

A note concerning multiturn injection experiments
por: Bernard, Ph, et al.
Publicado: (1965)

Further Notes on the e- W Injection System
por: Warner, D J
Publicado: (1982)

Design of an Inductive Adder for the FCC injection kicker pulse generator
por: Woog, D, et al.
Publicado: (2017)

Radiation-hard, pulsed magnets for the CERN ACOL injection line
por: Sherwood, T R, et al.
Publicado: (1988)

Cannot write session to /tmp/vufind_sessions/sess_431acvi2jd29t0h5h8kijmgv9u