Cargando…

Can one 1013 proton burst melt the ps vacuum chamber?

Mostrar otras versiones (1)

Detalles Bibliográficos
Autor principal:	Steinbach, C
Lenguaje:	eng
Publicado:	1973
Materias:	Accelerators and Storage Rings
Acceso en línea:	http://cds.cern.ch/record/2830632

Ejemplares similares

Can one 10$^{13}$ proton burst melt the PS vacuum chamber ?
por: Steinbach, C
Publicado: (1973)

Vacuum chamber apertures of the PS
por: Richter, W
Publicado: (1971)

Installation of the new figure of eight loops and vacuum chambers in the proton synchrotron of the PS division
por: Whitfield, C
Publicado: (1987)

Specification for welded stainless steel vacuum chambers of the PS
Publicado: (1974)

Results of the dimensional inspection of the prototype PS vacuum chamber and manifold
por: Whitfield, C
Publicado: (1986)

Results of the dimensional inspection of the prototype PS vacuum chambers and manifold
por: Whitfield, C
Publicado: (1986)

Radiation dose measurements around the ps vacuum chamber
por: Madsen, JHB
Publicado: (1966)

The vacuum system of the CERN Proton Synchrotron, 1: Introduction and the vacuum chamber
por: Munday, G L
Publicado: (1960)

Stainless steel for the new PS vacuum chamber: Status report
por: Poncet, A
Publicado: (1986)

Longitudinal coupling impedances at insulated PS vacuum chamber flanges
por: Faltens, A, et al.
Publicado: (1974)

Longitudinal coupling impedances at insulated PS vacuum chamber flanges
por: Faltens, A, et al.
Publicado: (1974)

Stainless steel for the new PS vacuum chamber : Status report
por: Poncet, A
Publicado: (1986)

Technical specification - Manufacture of the supports for the vacuum chamber of the PS machine
Publicado: (1986)

RF bypass on the proton synchrotron vacuum chamber flanges
por: Cappi, R
Publicado: (1989)

Specification for convoluted vacuum chamber PS-3A-214-2
Publicado: (1980)

Specification for convoluted vacuum chamber PS-3A-173-2
Publicado: (1979)

New PS Vacuum chamber correction JIG: Drawing N° P-00148-2
por: Whitfield, C
Publicado: (1986)

Parasitic Losses in the PS and SPS Vacuum Chambers During $e^{+}e^{-}$ Operation
por: Hübner, K, et al.
Publicado: (1980)

New PS vacuum chamber correction jig: Drawing no. P-00148-2
Publicado: (1986)

Minutes of a meeting of 17.1.1995 on grounding of the PS vacuum chamber and RF by-passing
por: Schneider, G C
Publicado: (1995)

Additional specifications for the manufacture of standard and enlarged size vacuum chambers and manifolds for the PS machine
Publicado: (1986)

Specification for vacuum chambers inside 800 MeV Proton Synchrotron Booster
por: Unterlerchner, W
Publicado: (1970)

Specification for tubular components for the vacuum chambers of the 300 GeV proton accelerator
por: CERN. Geneva
Publicado: (1972)

Technical specification for stainless steel for the new proton synchrotron magnet vacuum chamber
Publicado: (1984)

Vacuum chamber apertures for the PSB
por: Bovet, C
Publicado: (1969)

Impedance Considerations for the Design of the Vacuum System of the CERN PS2 Proton Synchrotron
por: Bane, K L F, et al.
Publicado: (2010)

Synchrotron radiation induced desorption of a PS vacuum chamber : Results of tests at DCI-Orsay . . . .
por: Poncet, A
Publicado: (1984)

The Vacuum Upgrade of the CERN PS and PS Booster
por: Van Rooij, M, et al.
Publicado: (1996)

Booster Vacuum system - Chamber to Chamber Insulation
por: Unterlerchner, W
Publicado: (1968)

Suggestions for PS vacuum improvement
por: Gould, C
Publicado: (1968)

Trajectories and optics of proton beams through CPS magnet field inside vacuum chamber
por: Reich, K H
Publicado: (1963)

Technical specification for ceramic ultra- high vacuum chambers for the PS transverse feedback kicker: price enquiry ref. DO-20313/PS
por: Lacroix, J M
Publicado: (2002)

Vacuum chambers in composite material
por: Engelmann, G, et al.
Publicado: (1987)

The impedance of layered vacuum chambers
por: Keil, Eberhard, et al.
Publicado: (1998)

Intersection vacuum chamber in inconel
por: CERN. Geneva
Publicado: (1979)

Design rules for vacuum chambers
por: Hauviller, Claude
Publicado: (2007)

Low Impedance Vacuum Chambers
por: Weiland, T
Publicado: (1995)

Non-destructive proton beam profile scanners for the CERN Proton Synchrotron, based on the ionization of residual gas in the beam vacuum chambers
por: Johnson, C D, et al.
Publicado: (1968)

Ceramic Vacuum Chambers: Determination of coating thickness for the MedAustron kicker magnets vacuum chambers
por: Stadlbauer, T, et al.
Publicado: (2011)

Design of the CLIC Quadrupole Vacuum Chambers
por: Garion, C, et al.
Publicado: (2009)

Cannot write session to /tmp/vufind_sessions/sess_ps0tbj9u2gijm43rn6rqt0nds2