Cargando…

Pre-alignment of CLIC using the double-wire method

Mostrar otras versiones (1)

Detalles Bibliográficos
Autores principales:	Coosemans, W, Mainaud, H
Lenguaje:	eng
Publicado:	1997
Materias:	Accelerators and Storage Rings
Acceso en línea:	http://cds.cern.ch/record/2831097

Ejemplares similares

Pre-Alignment of CLIC using the Double-Wire Method
por: Coosemans, Williame, et al.
Publicado: (1997)

Micrometric Propagation of Error Using Overlapping Streched Wires for the CLIC Pre-Alignment
por: Mainaud Durand, Helene, et al.
Publicado: (2017)

Cam Mover Alignment System positioning with the Wire Positioning with the Wire Position Sensor Feedback for CLIC
por: Kemppinen, Juha, et al.
Publicado: (2016)

CLIC pre-alignment — status and remaining challenges
por: Kemppinen, Juha, et al.
Publicado: (2021)

An Active Pre-Alignment System and Metrology Network for CLIC
por: Becker, F, et al.
Publicado: (2003)

Strategy and validation of fiducialisation for the pre-alignment of CLIC components
por: Griffet, S, et al.
Publicado: (2012)

Initial alignment of the CLIC
por: Coosemans, Williame
Publicado: (1990)

Validation of the CLIC alignment strategy on short range
por: Mainaud Durand, H, et al.
Publicado: (2012)

Feasibility study of multipoint based laser alignment system for CLIC
por: Stern, G, et al.
Publicado: (2012)

The New CLIC Main Linac Installation and Alignment Strategy
por: Mainaud Durand, Helene, et al.
Publicado: (2018)

Alignment Methods Developed for the Validation of the Thermal and Mechanical Behaviour of the Two Beam Test Modules for the CLIC Project
por: Mainaud Durand, Helene, et al.
Publicado: (2014)

Active Alignment Electronic System for CLIC 30 GHz Modules in CTF2
por: Carrica, D, et al.
Publicado: (1998)

Study and application of micrometric alignment on the prototype girders of the CLIC Two-Beam Module
por: Gazis, Nikolaos, et al.
Publicado: (2011)

Development and Validation of a Multipoint Based Laser Alignment System for CLIC
por: Stern, G, et al.
Publicado: (2013)

Stretched-Wire Techniques and Measurements for the Alignment of a 15GHz RF-BPM for CLIC
por: Zorzetti, Silvia, et al.
Publicado: (2016)

CLIC main beam quadrupole active pre-alignment based on cam movers
por: Kemppinen, J, et al.
Publicado: (2012)

Simulation of laser-wires at CLIC using BDSIM
por: Blair, G A
Publicado: (2002)

The Active Prealignment of the CLIC Components
por: Mainaud-Durand, Hélène, et al.
Publicado: (2007)

Alignment of the CLIC BDS
por: Latina, A, et al.
Publicado: (2008)

Alignment Tolerances for the CLIC Decelerator
por: Adli, E, et al.
Publicado: (2008)

Technological challenges of CLIC
por: Corsini, Roberto, et al.
Publicado: (2006)

CLIC Magnet Stabilization Studies
por: Redaelli, S, et al.
Publicado: (2004)

A Stochastic approach in uncertainty budgeting for Accelerator pre-alignment - Study for the CLIC project
por: Doytchinov, I
Publicado: (2016)

Beam-Based Alignment for the CLIC Decelerator
por: Adli, E, et al.
Publicado: (2008)

The CLIC 30 GHz two-beam test accelerator
por: Wilson, I, et al.
Publicado: (1998)

Development of an Eccentric CAM Based Active Pre-Alignment System for the CLIC Main Beam Quadrupole Magnet
por: Lackner, F, et al.
Publicado: (2010)

Status of the Clic Studies on Water Induced Quadrupole Vibrations
por: Assmann, R W, et al.
Publicado: (2003)

Theoretical and practical feasibility demonstration of a micrometric remotely controlled pre-alignment system for the CLIC linear collider
por: Mainaud Durand, H, et al.
Publicado: (2011)

Technical Specification for the CLIC Two-Beam Module
por: Riddone, G, et al.
Publicado: (2008)

The CLIC 30 GHz Two-Beam Test Accelerator
por: Wilson, Ian H, et al.
Publicado: (1998)

Laser Wire Simulations for the CLIC Beam Delivery System using GEANT4
por: Penn, G
Publicado: (2003)

Beam-Based Alignment for the Rebaselining of CLIC RTML
por: Han, Yanliang, et al.
Publicado: (2017)

Alignment and Wake Field Issues in the CLIC RTML
por: Stulle, F, et al.
Publicado: (2011)

CLIC Final Focus System Alignment and Magnet Tolerances
por: Snuverink, J, et al.
Publicado: (2013)

Determination of the Magnetic Axis of a CLIC Drive Beam Quadrupole with respect to External Alignment Targets using a Combination of WPS, CMM and Laser Tracker Measurements
por: Duquenne, Mathieu, et al.
Publicado: (2014)

Study of the Dynamic Response of CLIC Accelerating Structures
por: Daskalaki, Eleni, et al.
Publicado: (2015)

Drive Beam Quadrupoles for the CLIC Project: a Novel Method of Fiducialisation and a New Micrometric Adjustment System
por: Mainaud Durand, Helene, et al.
Publicado: (2014)

Improved CLIC performances using the beam response for correcting alignment errors
por: Fischer, C
Publicado: (1996)

Laser Wire Scanner: Basic Process and Perspectives for the CTF's and CLIC Machines
por: Lefèvre, T
Publicado: (2002)

Laser wire scanner: Basic process and perspectives for the CTF'S and CLIC machines
por: Lefevre, T
Publicado: (2001)

Cannot write session to /tmp/vufind_sessions/sess_6kuvv2tvqj4cf0omqnr5v8ridp