Cargando…

Oil-filled transformer for 5 kV charging supply

Detalles Bibliográficos
Autor principal:	Pirkl, W
Lenguaje:	eng
Publicado:	1974
Materias:	Accelerators and Storage Rings
Acceso en línea:	http://cds.cern.ch/record/2833748

Ejemplares similares

A fast 60 kV resonant charging power supply for the LHC inflectors
por: Barnes, M J, et al.
Publicado: (1998)

Operation Modes of the Fast 60 kV Resonant Charging Power Supply for the LHC Inflectors
por: Barnes, M J, et al.
Publicado: (1997)

Design and tests of a 5 kJ, 60 kV resonant charging power supply for the ISR beam dumping system
por: Schröder, G
Publicado: (1972)

"300 kV power supplies": Not distributed - remained DRAFT
por: Kamber, I
Publicado: (1982)

Specification for energy storage capacitors for 14 kV power supplies
por: James, FH
Publicado: (1975)

Specification for energy storage capacitors for 14 kV power supplies
por: James, F H
Publicado: (1982)

The new high voltage supply for ISOLDE: 60 kV Pulser for Isolde
por: Fiander, DC
Publicado: (1992)

Specification for the supply of a precision voltage divider up to 300 kV
Publicado: (1982)

Extension of the 6 kV AC filter of the PS booster main power supply
por: Völker, F
Publicado: (1978)

A Solid State 100 kV Long Pulse Generator for Klystrons Power Supply
por: Martins, C A, et al.
Publicado: (2010)

Specification for regulated high-voltage power supplies 300 kV/1 mA
Publicado: (1983)

A charge-pump 60kV modulator for the ISOLDE target extraction voltage
por: Barlow, R A, et al.
Publicado: (2015)

Specification technique pour armoires 600 kV/300 kV (version toute transistorisée)
Publicado: (1980)

Run 1125 MD, 22.05.1980, Harmonic currents on 18 kV from main power supplies
por: Fernqvist, G
Publicado: (1980)

A 60kV modulator for electrostatic lens excitation
por: Fowler, A, et al.
Publicado: (1998)

A nanosecond pulse generator of 200 kV amplitude
por: Gygi, Edmond, et al.
Publicado: (1964)

Results of Start of the 150 kV Magnetic Pulse Compressor
por: Krylov, S A, et al.
Publicado: (1999)

CIAE 600 kV ns pulse neutron generator
por: Shen Guan Ren, et al.
Publicado: (2001)

The 6 kA, 10 kV, 100 Hz power supply and pulser for the collecting and focusing solenoid of e- e+ converter in the CERN LEP pre-injector
por: Royer, J P, et al.
Publicado: (1988)

The 6 kA, 10 kV, 100 Hz power supply and pulser for the collecting and focusing solenoid of the e- e+ converter in the CERN LEP pre-injector
por: Royer, J P, et al.
Publicado: (1988)

Measurements on a 12.5 kV Prototype Inductive Adder for the CLIC DR Extraction Kickers
por: Holma, Janne, et al.
Publicado: (2017)

Note on the dismounting of the 750 kV pre-injector accelerating column
por: Haseroth, H, et al.
Publicado: (1979)

A 4 nsec, 100 kV square pulse generator
por: Gygi, Edmond, et al.
Publicado: (1971)

Symposium on CIAE 600 kV ns pulse neutron generator
por: Shen Guan Ren
Publicado: (2001)

Diodes CERN - 210 kV Silicium bilan d'exploitation
por: Roméro, JP, et al.
Publicado: (1984)

Measurements on a 20-layer 12.5 kV prototype inductive adder for the CLIC DR kickers
por: Holma, J, et al.
Publicado: (2018)

Design and initial measurements of a 12.5 kV prototype inductive adder for CLIC DR kickers
por: Holma, Janne, et al.
Publicado: (2016)

Analysis of 400 kV incidents and recommendations for improved procedures and equipment modifications
por: Myers, S, et al.
Publicado: (1994)

Technical Specification: For pulsed power cable - 2 kV r.m.s.
Publicado: (1985)

Perturbations in PS operation caused by thunderstorms (18 kV network instabilities)
por: Mosig, R
Publicado: (1977)

Nouveau deflecteur DP 1 (20 kV) du faisceau 500 keV
por: Chiari, F
Publicado: (1970)

Extension of the 6 KV AC filter of the PS booster main power supply
por: Völker, F
Publicado: (1978)

Technical specification for the 18 kV switchgear for the new substation in the PS ring centre
Publicado: (1968)

Measurements on a FET based 1 MHz, 10 kV pulse generator
por: Wait, G D, et al.
Publicado: (1995)

Design for a FET based 1 MHz, 10 kV pulse generator
por: Barnes, M J, et al.
Publicado: (1995)

Construction and 60 kV tests of the prototype pulser for the LHC injection kicker system
por: Barnes, M J, et al.
Publicado: (1999)

A Transient Tolerant Automated Control System for the LEDA 75kV Injector
por: Thuot, M, et al.
Publicado: (1999)

Etude de conception d’une traversée sous vide 30 kV
por: Prost, A
Publicado: (2011)

Specification technique pour une cellule 6 kV avec disjoncteur mobile
Publicado: (1983)

Spécification technique pour une cellule 6 kV avec disjoncteur mobile
Publicado: (1983)

Cannot write session to /tmp/vufind_sessions/sess_q8cisg4mhslc74ooosj547u9u0