Cargando…

A fast cycling resonant charging power supply for high voltage burst pulsers

Detalles Bibliográficos
Autor principal:	Ducimetière, L
Lenguaje:	eng
Publicado:	1991
Materias:	Accelerators and Storage Rings
Acceso en línea:	http://cds.cern.ch/record/2837726

Ejemplares similares

The new high voltage supply for ISOLDE: 60 kV Pulser for Isolde
por: Fiander, DC
Publicado: (1992)

A fast 60 kV resonant charging power supply for the LHC inflectors
por: Barnes, M J, et al.
Publicado: (1998)

Operation Modes of the Fast 60 kV Resonant Charging Power Supply for the LHC Inflectors
por: Barnes, M J, et al.
Publicado: (1997)

A High Power Linear Solid State Pulser
por: Yen, B, et al.
Publicado: (1999)

A remotely powered high tension burst pulser for the injection systems of CERN's Large Electron Positron collider (LEP)
por: Jansson, U, et al.
Publicado: (1986)

High tension burst pulser for the electron extraction kickers of the CERN Super Proton Synchrotron
por: Schröder, G, et al.
Publicado: (1984)

Development of high power switches for the LHC beam dumping pulser
por: Courtois, L, et al.
Publicado: (1992)

A fast-charging power supply for the delay lines of the kicker magnet pulsers
por: Cupérus, J
Publicado: (1968)

MOS power transistor and ceramic thyratron for fast high voltage pulser
por: Beninati, A, et al.
Publicado: (1984)

The Q-jump pulser
por: Cappi, R
Publicado: (1971)

A 250 MVA long duration sine wave pulser without power switches in the resonant circuit
por: Vossenberg, Eugène B
Publicado: (1987)

New LINAC quadrupole pulsers
por: Sherwood, TR
Publicado: (1974)

Construction and 60 kV tests of the prototype pulser for the LHC injection kicker system
por: Barnes, M J, et al.
Publicado: (1999)

A fast rise time high voltage pulse burst generator
por: Grier, D, et al.
Publicado: (1983)

A fast rise time high voltage pulse burst generator
por: Grier, D, et al.
Publicado: (1983)

Technical specification for high voltage regulated power supplies
por: Jamsek, J
Publicado: (1987)

Effect of source voltage subharmonics on a rapid cycling synchrotron power supply
por: Zhang, F Q, et al.
Publicado: (1998)

Simulation of Kicker Pulser with Matlab Simulink
por: Fann, C S, et al.
Publicado: (2001)

Q-jump pulser for transition experiments
por: Thorndahl, L
Publicado: (1969)

FAK pulsed resonant power supply including voltage measurement and servo control
por: Fiander, D, et al.
Publicado: (1975)

High-current low-voltage power supplies for superconducting magnets
por: Coulinge, Emilien, et al.
Publicado: (2017)

High Voltage Power Supplies for 352.21 MHz Klystrons
por: Bordry, Frederick, et al.
Publicado: (2004)

High-Current Low-Voltage Power Supply for Superconducting Magnets
por: Coulinge, Émilien Luc Henri
Publicado: (2020)

Specification for high voltage power supply tank for LEP modulator
Publicado: (1982)

Commissioning of the hard tube pulser experiment at DESY
por: Bieler, M, et al.
Publicado: (1994)

Experimental results on a fast-cycling pulsed HV power supply
por: Brückner, Alois, et al.
Publicado: (1972)

General specification for a new high voltage charging d’quing system and ancilliary modulator power supply units
por: Pearce, P
Publicado: (1990)

Design Proposal for a Compact, Solid-State, Low-Power Klystron-Pulser for CTF3
por: Pearce, P
Publicado: (2001)

Design proposal for a compact, solid-state, low-power klystron-pulser for CTF3
por: Pearce, P
Publicado: (2001)

High repetition rate pulser concepts for a recirculating HIF driver
por: Newton, M A, et al.
Publicado: (1992)

The 6 kA, 10 kV, 100 Hz power supply and pulser for the collecting and focusing solenoid of e- e+ converter in the CERN LEP pre-injector
por: Royer, J P, et al.
Publicado: (1988)

The 6 kA, 10 kV, 100 Hz power supply and pulser for the collecting and focusing solenoid of the e- e+ converter in the CERN LEP pre-injector
por: Royer, J P, et al.
Publicado: (1988)

Reactive power of magnet power supplies and choice of rectifier output voltage
por: Haüsler, M
Publicado: (1973)

Low Voltage Power Supply Incorporating Ceramic Transformer
por: Imori, M, et al.
Publicado: (2007)

Technical specification for the supply of the modulator high voltage power supply tank for the LEP pre-injector Linacs
Publicado: (1983)

Technical specification for the supply of the modulator high voltage power supply tank for the LEP pre-injector Linacs
Publicado: (1983)

Specification for power supplies for charging of capacitor banks
Publicado: (1978)

The 200 kJ pulser and power converter for the 36 mm lithium lens of the antiproton accumulator and collector (AAC) at CERN
por: Voelker, F
Publicado: (1989)

A resonant charging pulsed high voltage power supply
por: Brückner, A, et al.
Publicado: (1968)

Septum and Kicker Pulsers for the LNLS 500-MeV Booster Synchrotron
por: Lira, A C, et al.
Publicado: (2001)

Cannot write session to /tmp/vufind_sessions/sess_aulalf298hq64jvhf3nt7650ds