Cargando…

Installation of cavity prototype in ring-building.

Detalles Bibliográficos
Autor principal:	Lingjaerde, Tor
Lenguaje:	eng
Publicado:	1958
Materias:	Accelerators and Storage Rings
Acceso en línea:	http://cds.cern.ch/record/2840470

Ejemplares similares

The Stripline Kicker Prototype for the CLIC Damping Rings at ALBA: Installation, Commissioning and Beam Characterisation
por: Pont, Montserrat, et al.
Publicado: (2018)

NUFACT Prototype Horn Installation and Measurements
por: Maugain, J M, et al.
Publicado: (2001)

PS : accelerating cavity installed in the ring
por: CERN PhotoLab
Publicado: (1958)

LHC accelerating cavity prototype
Publicado: (2017)

D-C operating Characteristics of Cavity Tuning Preamplifier.
por: Lingjaerde, T, et al.
Publicado: (1959)

Prototype Development of the CLIC Crab Cavities
por: Burt, Graeme, et al.
Publicado: (2014)

Results with a LEP prototype superconducting cavity
por: Bernard, P, et al.
Publicado: (1985)

The Design And Construction Of Prototype RF Storage Cavities
por: Wilson, Ian H
Publicado: (1980)

Status of the LHC prototype superconducting RF cavity
por: Boussard, Daniel, et al.
Publicado: (1993)

Search for Aperture Limitation Ring 1 (last instalment)
por: Laeger, H
Publicado: (1972)

A superconducting 352 MHz prototype cavity for LEP
por: Arnolds-Mayer, G, et al.
Publicado: (1985)

Cold Tests of a Spoke Cavity Prototype for RIA
por: Kelly, M P, et al.
Publicado: (2001)

Prototype 350 MHz Niobium Spoke-loaded Cavities
por: Shepard, K W, et al.
Publicado: (1999)

Superconducting Wiggler Prototype for the CLIC Damping Rings
por: Bernhard, Axel, et al.
Publicado: (2013)

The LHC Beam Loss Monitoring System's Surface Building Installation
por: Dehning, B, et al.
Publicado: (2006)

Design of HOM Coupler Prototype for the APT Superconducting RF Cavities
por: Kuzminski, J, et al.
Publicado: (2001)

Superconducting prototype cavities for the Spallation Neutron Source (SNS) project
por: Ciovati, G, et al.
Publicado: (2001)

Trim Tuning of SPS-Series DQW Crab Cavity Prototypes
por: Verdú-Andrés, Silvia, et al.
Publicado: (2017)

An RF Cavity for the NLC Damping Rings
por: Rimmer, R A, et al.
Publicado: (2001)

Design of a Prototype Gas Jet Profile Monitor for Installation Into the Large Hadron Collider at CERN
por: Veness, Raymond, et al.
Publicado: (2022)

Intersecting Storage Rings Commitee, Preparation and Installation of the ISR Physics Programme
por: Bonaudi, Franco, et al.
Publicado: (1971)

In search of trapped modes in the single-cell cavity prototype for CESR-B
por: Hartung, W H, et al.
Publicado: (1993)

A prototype cavity beam position monitor for the CLIC Main Beam
por: Cullinany , F, et al.
Publicado: (2012)

Thermal stresses in the ferrite-rings of the cavities in the MPS
por: Bargmann, H W
Publicado: (1972)

The "experimental" RF cavity in ring 2 of the ISR
por: Bramham, Peter
Publicado: (1976)

Beam-cavity interaction in electron storage rings
por: Keil, Eberhard, et al.
Publicado: (1975)

Considerations on installing a strong solenoid in a low energy storage ring
por: Kewisch, J, et al.
Publicado: (1987)

Specification for assembly, testing and installation work on magnets for the CERN antiproton accumulator ring
Publicado: (1979)

The prototype superconducting quadrupole magnet for the CERN Intersecting Storage Rings
por: Ansorge, W R, et al.
Publicado: (1978)

Engineering design and prototype fabrication of HOM couplers for HL-LHC crab cavities
por: Zanoni, Carlo, et al.
Publicado: (2015)

Manufacture of a Compact Prototype 4R Crab Cavity for HL-LHC
por: Burt, Graeme, et al.
Publicado: (2013)

Successful Beam Test of the HOM Free Superconducting SOLEIL Cavity Prototype at the ESRF
por: Jacob, J, et al.
Publicado: (2003)

Long-term test of a LEP prototype superconducting cavity in the CERN SPS
por: Boussard, Daniel, et al.
Publicado: (1989)

rf system for the superconducting cavities in TRISTAN main ring
por: Akai, K, et al.
Publicado: (1990)

The Application of Superconducting RF Cavities to Electron Storage Rings
por: Hutton, A
Publicado: (1967)

Operating Experience with Superconducting Cavities in the HERA E-ring
por: Dwersteg, B, et al.
Publicado: (1996)

Beam Loading Compensation in the RF Cavities of Ring 1
por: Frischholz, Hans
Publicado: (1976)

Technical specification for the ferrite rings used in the PSB cavities
por: Zanaschi, D
Publicado: (1969)

Prototype vacuum test section for the CERN Large Storage Ring project
por: Blechschmidt, Diether, et al.
Publicado: (1977)

Development of a Prototype Capacitive BPM for the University of Maryland Electron Ring
por: Zou, Y, et al.
Publicado: (1999)

Cannot write session to /tmp/vufind_sessions/sess_m560l7i8o7dfogqqacbaggfk52