Cargando…

EPA-cavity : RF hardware

Detalles Bibliográficos
Autor principal:	Pirkl, W
Lenguaje:	eng
Publicado:	1982
Materias:	Accelerators and Storage Rings
Acceso en línea:	http://cds.cern.ch/record/2840485

Ejemplares similares

The transformer-coupled resonator model of the EPA RF cavity
por: Bartalucci, S, et al.
Publicado: (1988)

EPA hardware tests
por: Delahaye, J P
Publicado: (1986)

Fundamental and higher order mode measurements on the rf cavity for EPA
por: Bartalucci, S, et al.
Publicado: (1986)

Signal level parasitic mode measurements on the RF test cavity for EPA
por: Bell, M, et al.
Publicado: (1985)

Signal level parasitic mode measurements on the RF test cavity for EPA
por: Bell, M, et al.
Publicado: (1985)

Developments and news on RF hardware
por: Brown, P
Publicado: (1998)

RF Matching EPA-PS And PS-SPS
por: Hübner, K, et al.
Publicado: (1982)

Calculation of some RF dependent parameters for EPA
por: Bartalucci, S
Publicado: (1986)

Buncher / debuncher: Configuration of the RF
por: Pirkl, W
Publicado: (1973)

New Linac RF System: Considerations for the RF-output stages (Tank 1 - Tank 3)
por: Pirkl, W
Publicado: (1973)

Aspects of the new RF accelerating system
por: Pirkl, W
Publicado: (1969)

RF systems for linacs
por: Pirkl, Werner
Publicado: (1996)

Minimisation of the betafunction at the RF cavities
por: Zotter, Bruno W
Publicado: (1983)

Survey of possible improvements on the RF-system - Linac I
por: Pirkl, W
Publicado: (1982)

Short note on power requirements for an RF-deflector in BFI
por: Pirkl, W
Publicado: (1990)

PS-RF system : impedance and voltage levels in the chain
por: Pirkl, W
Publicado: (1974)

RF Cavity Design
por: Jensen, E
Publicado: (2014)

rf cavity feedback
por: Pedersen, F
Publicado: (1992)

RF cavity feedback
por: Pedersen, F
Publicado: (1992)

RF cavity fabrication
por: Proch, D
Publicado: (2004)

Superconducting RF cavities
por: Bernard, Philippe
Publicado: (1999)

rf hardware development work for the CLIC drive beam
por: Carron, G, et al.
Publicado: (1993)

Hardware and Initial Beam Commissioning of the LHC RF Systems
por: Linnecar, T, et al.
Publicado: (2008)

Requirements for the rigid RF-lines (Amlifiers to Tanks I-III)
por: Pirkl, W
Publicado: (1974)

Superconducting rf cavities for LEP
por: Bernard, P, et al.
Publicado: (1988)

Beam-phase adjustment of single-gap cavities
por: Pirkl, W
Publicado: (1993)

The RF System of the CERN "New Linac"
por: Cuperus, J, et al.
Publicado: (1979)

"SPARKING CAVITY" Test report
por: Marseille, N, et al.
Publicado: (2005)

Comparison of parasitic e-m resonances of two EPA cavity models
por: Bell, Μ, et al.
Publicado: (1984)

Accelerator Technology: RF Cavities
por: Jensen, E
Publicado: (2013)

Beam loading in rf cavities
por: Garoby, R
Publicado: (1992)

Fully hydroformed rf cavities
por: Hauviller, Claude
Publicado: (1990)

Hydroforming of rf copper cavities
por: Hauviller, Claude
Publicado: (1990)

A "Monochromatic" RF Cavity
por: Bartalucci, S, et al.
Publicado: (1987)

Beam loading in RF cavities
por: Garoby, R
Publicado: (1990)

Particle trapping with an RF cavity
por: Chao, A
Publicado: (1995)

RF systems: waveguides and cavities
por: Dôme, Georges
Publicado: (1987)

A "monochromatic" RF cavity
por: Bartalucci, S, et al.
Publicado: (1987)

Conventional RF cavity design
por: Puglisi, M
Publicado: (1992)

Precision of phase measurement during short R.F bursts
por: Cheretakis, A, et al.
Publicado: (1982)

Cannot write session to /tmp/vufind_sessions/sess_hvhalc67rltsf7uflsl3b4peor