Cargando…

Evaluation of the surface impedance of ReBCO coated conductors and requirements for their use as beam screen materials for the FCC-hh

The Future Circular Hadron Collider (FCC-hh) is a proposal for a 100-kilometre-long particle accelerator with collision energy substantially higher than previous colliders to expand the Large Hadron Collider (LHC) research.<br>The selection of a low surface impedance beam scre...

Descripción completa

Detalles Bibliográficos
Autor principal:	Krkotic, Patrick
Lenguaje:	eng
Publicado:	CORA-TDX-UPC 2023
Materias:	Accelerators and Storage Rings Engineering
Acceso en línea:	https://dx.doi.org/10.17181/CERN.4W8R.NSGX http://cds.cern.ch/record/2846227

Ejemplares similares

Evaluation of the nonlinear surface resistance of REBCO coated conductors for their use in the FCC-hh beam screen
por: Krkotić, P, et al.
Publicado: (2022)

Measurement and Analysis of Normal Zone Propagation in a ReBCO Coated Conductor at Temperatures Below 50K
por: van Nugteren, J, et al.
Publicado: (2015)

Potential impedance reduction by REBCO-coated conductors as beam screen coating for the Future Circular Hadron Collider
por: Krkotić, P, et al.
Publicado: (2022)

High frequency response of thick REBCO coated conductors in the framework of the FCC study
por: Romanov, Artur, et al.
Publicado: (2020)

High frequency response of thick REBCO coated conductors in the framework of the FCC study
por: Romanov, Artur, et al.
Publicado: (2020)

Calculating Parameters for a ReBCO Cable Joint Terminal
por: Vipp, Venno
Publicado: (2016)

Electron Beam Characterization of REBCO-Coated Conductors at Cryogenic Conditions
por: Haubner, Michal, et al.
Publicado: (2023)

Design and Preparation of Two ReBCO-CORC® Cable-In-Conduit Conductors for Fusion and Detector Magnets
por: Mulder, T, et al.
Publicado: (2017)

Demonstration of the ReBCO CORC 47kA@10T/4.2K Cable-In-Conduit-Conductor and its Joint Terminals at 4.5 and 77 K
por: Mulder, T, et al.
Publicado: (2017)

Differential geometry method for minimum hard-way bending 3D design of coils with ReBCO tape conductor
por: Nes, T H, et al.
Publicado: (2022)

Thermally Activated ReBCO Switches for Charging High-Current Magnets
por: Bykovskiy, Nikolay, et al.
Publicado: (2019)

Performance of high-temperature superconducting REBCO coated conductors under synchrotron irradiation for future circular colliders
por: Krkotić, Patrick, et al.
Publicado: (2023)

Transverse Thermal Conductivity of REBCO Coated Conductors
por: M. Bonura, M, et al.
Publicado: (2014)

Inter-strand resistance and AC loss in resin-filler impregnated ReBCO Roebel cables
por: Gao, P, et al.
Publicado: (2019)

Effect of resin impregnation on the transverse pressure dependence of the critical current in ReBCO Roebel cables
por: Gao, P, et al.
Publicado: (2019)

Cos-$\theta$ design of dipole inserts made of ReBCO-Roebel or BSCCO-Rutherford cables
por: Lorin, C, et al.
Publicado: (2015)

FCC-hh transverse impedance budget
por: Arsenyev, Sergey, et al.
Publicado: (2018)

High-field thermal transports properties of REBCO coated conductors
por: Bonura, M, et al.
Publicado: (2015)

Performance Test of an 8 kA @ 10-T 4.2-K ReBCO-CORC Cable
por: Mulder, Tim, et al.
Publicado: (2016)

Study of a 5T Research Dipole Insert-Magnet using an Anisotropic ReBCO Roebel Cable
por: Van Nugteren, J, et al.
Publicado: (2015)

Measurement and Numerical Evaluation of AC-Losses in a ReBCO Roebel Cable at 4.5 K
por: van Nugteren, J., et al.
Publicado: (2016)

Development of Joint Terminals for a New Six-Around-One ReBCO-CORC Cable-in-Conduit Conductor Rated 45 kA at 10T/4K
por: Mulder, Tim, et al.
Publicado: (2016)

Resistive-Wall Impedance of Insertions for FCC-hh
por: Riemann, Bernard, et al.
Publicado: (2018)

Beam-beam studies for FCC-hh
por: Barranco Garcia, Javier, et al.
Publicado: (2017)

Essential Material Knowledge and Recent Model Developments for REBCO-Coated Conductors in Electric Power Systems
por: Trillaud, Frederic, et al.
Publicado: (2021)

Parameterization of the critical surface of REBCO conductors from Bruker
por: Danial, Muhammad, et al.
Publicado: (2017)

FCC-hh beam screen prototype
por: Brice, Maximilien
Publicado: (2016)

Effective Time Constants at 4.2 to 70 K in ReBCO Pancake Coils With Different Inter-Turn Resistances
por: Nes, T H, et al.
Publicado: (2022)

Field and temperature scaling of the critical current density in commercial REBCO coated conductors
por: Senatore, Carmine, et al.
Publicado: (2016)

FCC-hh
por: Aleksa, Martin
Publicado: (2018)

Development of ReBCO-CORC Wires With Current Densities of 400–600 A/mm$^{2}$ at 10 T and 4.2 K
por: Mulder, Tim, et al.
Publicado: (2018)

Broadband Impedance of Pumping Holes and Interconnects in the FCC-hh Beamscreen
por: Arsenyev, Sergey, et al.
Publicado: (2018)

Optimising A Read Out for A Possible FCC hh Collision
por: Alagaraisamy, Revathy
Publicado: (2017)

Design of a Cloverleaf-Racetrack Dipole Demonstrator Magnet With Dual $Re$BCO Conductor
por: Nes, T.H., et al.
Publicado: (2022)

Modelling Wake Impedance of a Rough Surface in Application to the FCC-hh Beamscreen
por: Arsenyev, Sergey, et al.
Publicado: (2018)

Physics requirements for the FCC-hh calorimeter system
por: Selvaggi, Michele
Publicado: (2019)

Calorimeters for the FCC-hh
por: Neubuser, Coralie, et al.
Publicado: (2019)

Effect of the proton irradiation on the thermally activated flux flow in superconducting SmBCO coated conductors
por: Choi, W. J., et al.
Publicado: (2020)

Requirements from physics for the FCC-hh detector design
por: Selvaggi, Michele, et al.
Publicado: (2020)

Bending Radius Limits of Different Coated REBCO Conductor Tapes - An Experimental Investigation with Regard to HTS Undulators
por: Richter, Sebastian C, et al.
Publicado: (2021)

Cannot write session to /tmp/vufind_sessions/sess_330joff738sa9dta51ikgc7inr