Cargando…

Injection and accumulation studies

Detalles Bibliográficos
Autores principales:	Hübner, K, Potier, J P, Rinolfi, L R
Lenguaje:	eng
Publicado:	1989
Materias:	Accelerators and Storage Rings
Acceso en línea:	http://cds.cern.ch/record/2854324

Ejemplares similares

EPA accumulation tests: I-EPA Accumulation Rate and Maximum Current Versus Injected Beam Oscillations and Stored Beam Oscillations Experimental Results
por: Hübner, K, et al.
Publicado: (1990)

LPI performance during LEP injection tests
por: Delahaye, J P, et al.
Publicado: (1988)

Positron injection and accumulation into EPA performances and limitations
por: Delahaye, J P, et al.
Publicado: (1987)

Measurement of EPA parameters with the beam at equilibrium
por: Battisti, S, et al.
Publicado: (1989)

Measurements and analysis of collective effects in the LEP electron positron accumulator (EPA)
por: Bartalucci, S, et al.
Publicado: (1988)

Measurements and analysis of collective effects in the LEP electron positron accumulator (EPA)
por: Bartalucci, S, et al.
Publicado: (1988)

The LEP Pre-Injector as a Multipurpose Facility
por: Potier, J P, et al.
Publicado: (1998)

The LEP pre-injector as a multipurpose facility
por: Potier, JP, et al.
Publicado: (1998)

LPI peak performances recorded in December 89
por: Potier, JP, et al.
Publicado: (1990)

Isochronous optics and related measurements in EPA
por: Corsini, R, et al.
Publicado: (2000)

Isochronous Optics and Related Measurements in EPA
por: Corsini, R, et al.
Publicado: (2000)

Special injection region quadrupole for the CERN Antiproton collector ring
por: Rinolfi, L
Publicado: (1987)

Electron-Positron Injection In The PS
por: Bouthéon, M, et al.
Publicado: (1983)

First micro-bunch measurements in EPA as isochronous ring at 500 MeV
por: Corsini, R, et al.
Publicado: (1999)

Propositions pour une simplification du cadencement LPI
por: Frammery, B, et al.
Publicado: (1989)

A bunch transfer scheme for the beauty factory in the ISR tunnel
por: Hübner, K, et al.
Publicado: (1989)

An injection system for the beauty factory in the ISR tunnel (BFI)
por: Potier, J P
Publicado: (1990)

Proposal for an improved positron accumulation rate in LPI
por: Delahaye, J P, et al.
Publicado: (1989)

A Low-Charge Demonstration of Electron Pulse Compression for the CLIC RF Power Source
por: Corsini, R., et al.
Publicado: (2000)

Progress report on the LEP pre-injector
por: Battisti, S, et al.
Publicado: (1989)

The injection kicker system of the CERN antiproton accumulator
por: Fiander, David C, et al.
Publicado: (1981)

Longitudinal parameters at injection of BFI
por: Hübner, K, et al.
Publicado: (1990)

Longitudinal parameters at injection of BFI
por: Hübner, K, et al.
Publicado: (1990)

Longitudinal parameters at injection of BFI
por: Hübner, K, et al.
Publicado: (1990)

A low-charge demonstration of electron pulse compression for the CLIC RF power source
por: Corsini, R, et al.
Publicado: (2000)

Procedures followed to optimize the 500 MeV e+ beam during the 1988 start-up in WK 12
por: Frammery, B, et al.
Publicado: (1988)

The beam cutting ejection from the CERN electron-positron accumulator
por: Krusche, A, et al.
Publicado: (1990)

The beam cutting ejection from the CERN electron-positron accumulator
por: Krusche, A, et al.
Publicado: (1990)

Special injection region quadrupole for the CERN antiproton collector ring
por: Rinolfi, Louis
Publicado: (1988)

Injection avec un ḃ faible et grossissement longitudinal controle tres proche de l'injection
por: Garoby, R, et al.
Publicado: (1983)

Timing LPI
por: Levis, J, et al.
Publicado: (1989)

Progress report on the LEP pre-injector
por: Battisti, S, et al.
Publicado: (1989)

Conversion of PSB and PS injection to 1 GeV: - Revisited -
por: Potier, JP, et al.
Publicado: (1986)

Transfert psb ps et injection a 1 gev dans le ps
por: Potier, J. P
Publicado: (1983)

A novel injection/extraction scheme for short bunch separation in accelerator rings
por: Delahaye, J P, et al.
Publicado: (1994)

Compte rendu de la réunion du 9 - 2 - 88
por: Bellanger, A, et al.
Publicado: (1988)

Instrumentation pour l'injection des electrons et positrons dans le PS
por: Battisti, S, et al.
Publicado: (1984)

Machine developpement du 13.2.1980: Preparation de l'injection de particules α
por: Potier, J P
Publicado: (1980)

EXM 89-26
por: Daems, G, et al.
Publicado: (1989)

An Injection System For The LEP Injector Synchrotron
por: Hübner, K
Publicado: (1978)

Cannot write session to /tmp/vufind_sessions/sess_9nfrngv53m1m6nf4e37jbjohjs