Cargando…

A few simple expressions for checking vacuum requirements in a proton synchrotron

Detalles Bibliográficos
Autor principal:	Hardt, Werner
Lenguaje:	eng
Publicado:	1968
Materias:	Accelerators and Storage Rings
Acceso en línea:	http://cds.cern.ch/record/296859

Ejemplares similares

Features of boosters for super high energy proton synchrotrons
por: Hardt, Werner
Publicado: (1969)

The vacuum system of the CERN Proton Synchrotron, 1: Introduction and the vacuum chamber
por: Munday, G L
Publicado: (1960)

RF bypass on the proton synchrotron vacuum chamber flanges
por: Cappi, R
Publicado: (1989)

Experience with the vacuum equipment for the CERN 25 GeV proton synchrotron
por: Munday, G L, et al.
Publicado: (1962)

Specification for vacuum chambers inside 800 MeV Proton Synchrotron Booster
por: Unterlerchner, W
Publicado: (1970)

Impedance Considerations for the Design of the Vacuum System of the CERN PS2 Proton Synchrotron
por: Bane, K L F, et al.
Publicado: (2010)

Technical specification for stainless steel for the new proton synchrotron magnet vacuum chamber
Publicado: (1984)

A simple model for multiturn injection into A.G. proton synchrotrons
por: van der Stok, P D V
Publicado: (1977)

A simple model for multiturn injection into A.G. proton synchrotrons
por: van der Stok, P D V
Publicado: (1977)

Specification of ceramic vacuum pipes for injection kicker and beam transformers of the Proton Synchrotron Booster
por: Unterlerchner, W
Publicado: (1970)

Installation of the new figure of eight loops and vacuum chambers in the proton synchrotron of the PS division
por: Whitfield, C
Publicado: (1987)

Vacuum and beam pipe considerations ; 1, vacuum requirements for a high intensity proton ring
por: Oram, C J
Publicado: (1989)

Specification for vacuum tubes for magnets in the West Experimental Area of the 300 GeV proton synchrotron
por: Rufer, C E
Publicado: (1974)

Synchrotron Radiation in the LHC Vacuum System
por: Baglin, V, et al.
Publicado: (2011)

Vacuum aspects of synchrotron light sources
por: Reid, R J
Publicado: (2007)

Information on Site Requirements for a 300 GeV Proton Synchrotron
por: Zilverschoon, C J
Publicado: (1963)

Some crucial problems in the design of the booster for the 300 GeV synchrotron
por: Hardt, Werner
Publicado: (1969)

Non-destructive proton beam profile scanners for the CERN Proton Synchrotron, based on the ionization of residual gas in the beam vacuum chambers
por: Johnson, C D, et al.
Publicado: (1968)

LHC Injectors Upgrade Project: Outlook of the Modifications to the Super Proton Synchrotron (SPS) Vacuum System and Impact on the Operation of the Carbon-Coated Vacuum Chambers
por: Pasquino, Chiara, et al.
Publicado: (2018)

Vacuum Design of Synchrotron-light Sources Conference
por: Amer, Y G, et al.
Publicado: (1990)

On interlaced injector synchrotrons
por: Hardt, W
Publicado: (1966)

The CERN Proton Synchrotron
por: Regenstreif, Edouard
Publicado: (1959)

The CERN Proton Synchrotron
por: Regenstreif, Edouard
Publicado: (1962)

The CERN Proton Synchrotron
por: Adams, John Bertram
Publicado: (1960)

The CERN Proton Synchrotron
por: Regenstreif, Edouard
Publicado: (1960)

Proton Utilization at the CERN Proton Synchrotron
por: Bovet, C, et al.
Publicado: (1967)

Injection of polarized protons into the proton synchrotron
por: Eaton, T W, et al.
Publicado: (1967)

Characteristics of a vacuum-type microcalorimeter for synchrotron-radiation measurements
por: Nakashima, H, et al.
Publicado: (1995)

Synchrotron radiation lead shielding of the vacuum chambers for LEP
por: Chapman, G R, et al.
Publicado: (1983)

Synchrotron radiation lead shield on the vacuum chamber of LEP
por: Gröbner, Oswald
Publicado: (1979)

System software of the CERN Proton Synchrotron control system
por: Carpenter, Brian E, et al.
Publicado: (1984)

A comparison of separated and combined function lattices for the small booster of the 300 GeV synchrotron
por: Hardt, Werner, et al.
Publicado: (1968)

Technical requirements vacuum flanges for the CERN 400 GeV proton accelerator
por: CERN. Geneva
Publicado: (1979)

PERFORMANCE ANALYSIS OF MULTI-TURN EXTRACTION FROM THE PROTON SYNCHROTRON TO THE SUPER PROTON SYNCHROTRON
por: Abernethy, Samuel
Publicado: (2016)

Specification for the vacuum chamber assemblies comprising flexible metal bellows, transition pieces, flanges, and vacuum tubes for the magnets in the Experimental Areas of the 450 GeV Proton Synchrotron
por: CERN. Geneva
Publicado: (1982)

The Superconducting Super Proton Synchrotron
por: Dyks, Luke Aidan, et al.
Publicado: (2019)

Performance of the CERN Proton Synchrotron
por: Hine, M G N, et al.
Publicado: (1961)

The alternating-gradient proton synchrotron
por: Adams, John Bertram
Publicado: (1955)

The alternating gradient proton synchrotron
Publicado: (1954)

The CERN proton synchrotron booster
por: Reich, K H
Publicado: (1969)

Cannot write session to /tmp/vufind_sessions/sess_p517ditv74e0r16b9mrjvlmcd6