Cargando…

Behaviour of non-laminated core Armco-iron magnets at low induction

Detalles Bibliográficos
Autor principal:	Ferger, Fritz Alfred
Lenguaje:	eng
Publicado:	1962
Materias:	Accelerators and Storage Rings
Acceso en línea:	http://cds.cern.ch/record/296989

Ejemplares similares

The design of the betatron core for the 2 MeV storage ring
por: Ferger, Fritz Alfred
Publicado: (1962)

Magnetic screening for the storage ring
por: Ferger, Fritz Alfred
Publicado: (1961)

Magnetic measurements on a quadrupole lens
por: Ferger, Fritz Alfred
Publicado: (1961)

A laminated-iron fast-pulsed magnet
por: Faugeras, Paul E, et al.
Publicado: (1977)

The reproductivity of magnetic field settings with solid-cored and laminated magnets
por: Harris, F M, et al.
Publicado: (1966)

Production of the steel sheet for the laminations of the ISR main magnet cores
por: Taylor, T M
Publicado: (1969)

Some thoughts about tuning narrow band cavities with reactance valves
por: Ferger, Fritz Alfred
Publicado: (1962)

The compensation of the earth field in the experimental hall for the storage ring
por: Ferger, Fritz Alfred
Publicado: (1961)

The programming and timing of betatron acceleration cycles of the storage ring for 2 MeV electrons
por: Ferger, Fritz Alfred, et al.
Publicado: (1962)

The RF scanning system for the 2 MeV electron storage ring
por: Ferger, Fritz Alfred, et al.
Publicado: (1963)

Wide-band impedance matching by the root locus method: application to the design of a high-power radio-frequency system for an FFAG accelerator
por: Ferger, Fritz Alfred, et al.
Publicado: (1960)

The high-power part of the RF-system for the CERN Intersecting Storage Rings (ISR)
por: Ferger, Fritz Alfred, et al.
Publicado: (1970)

A broad-bank termination for IF coaxial lines
por: Susini, A, et al.
Publicado: (1961)

On the description of the dynamic behaviour of laminated magnets by means of effective fields and an effective permeability
Publicado: (1954)

Manufactures of the iron cores for the ISR main magnet units
por: Taylor, T M
Publicado: (1976)

Production of the soft magnetic steel laminations for the LEP dipole magnets
por: Laeger, H, et al.
Publicado: (1988)

Specification for the ESRF S3 septum magnet lamination
por: Valbuena, R
Publicado: (1990)

Dynamic Behavior of Laminated Magnets With Solid Tension Bars
por: Zickler, Thomas
Publicado: (2018)

Specification of the steel laminations for PS pulsed septum magnets
por: Thivent, M, et al.
Publicado: (1992)

Forces on laminations in gaps between PS magnet blocks
por: Umstätter, H H
Publicado: (1977)

Simple expressions to evaluate eddy current effects in laminated magnets
por: Reistad, D
Publicado: (1968)

Laminated Magnetic Materials Losses Analysis under Non-Sinusoidal Flux Waveforms in Power Electronics Systems
por: Aguglia, D, et al.
Publicado: (2014)

The CERN electron storage ring model
por: Ferger, Fritz Alfred, et al.
Publicado: (1963)

The design, fabrication and testing of an iron-core current compensated magnetic channel for cyclotron extraction
por: Laxdal, R E, et al.
Publicado: (1994)

Basic expressions for evaluating iron core magnets - A possible procedure to minimize their cost
por: Brianti, G, et al.
Publicado: (1970)

Measurements on Magnetic Cores for Inductive Adders with Ultra-Flat Output Pulses for CLIC DR Kickers
por: Holma, Janne, et al.
Publicado: (2016)

The CERN electron storage-ring model
por: Ferger, Fritz Alfred, et al.
Publicado: (1964)

Implications of New Induction Core Materials and Coatings for High Power Induction Accelerators
por: Molvik, A W, et al.
Publicado: (1999)

Design & optimization of the alignment supports for the new laminated magnets for the CERN East Area consolidation project
por: Vanhoutte, Robin, et al.
Publicado: (2019)

New laminated window frame bending magnet TBH: Transfer-Iine Bending for Horizontal deflection
Publicado: (1976)

A permanent magnet quadrupole design with iron yoke and low harmonic content
por: De Vita, E, et al.
Publicado: (1986)

Compressing coils of single and multiple aperture superconducting magnets with "Scissors" laminations: principles and results of tests on mechanical
por: Ijspeert, Albert
Publicado: (1994)

Superconducting Coil Compression by Scissor Laminations
por: Ijspeert, Albert, et al.
Publicado: (1996)

An iron magnet for 30 kilogauss
por: Jacob, U, et al.
Publicado: (1964)

Prototype beam screens for LHC dipole magnets from co-laminated stainless steel in 16 metre lengths
por: Kos, N
Publicado: (1996)

Core shaping of the ISR main magnets
por: Caeymaex, S, et al.
Publicado: (1970)

Runs Nos. 49 and 50, April 6th, 1971: Effect of clearing-electrodes (CE) in cavities Nos. 5 and 6
por: Ferger, F
Publicado: (1971)

Preliminary Results of first trial-runs of the CERN Intersecting Storage Rings
por: Ferger, F
Publicado: (1970)

Run No. 18, February 1st 1971, Pressure rise in vacuum at r.f. stations due to r.f. voltage
por: Ferger, F
Publicado: (1971)

Run No. 18, February 1st 1971, Pressure rise in vacuum at r.f. stations due to r.f. voltage
por: Ferger, F
Publicado: (1971)

Cannot write session to /tmp/vufind_sessions/sess_djnqieop6ljovc5jicesdafto7