Cargando…

A fast high voltage pulser using a cold cathode switch tube

Detalles Bibliográficos
Autor principal:	Den Herder, J M
Lenguaje:	eng
Publicado:	1967
Materias:	Detectors and Experimental Techniques
Acceso en línea:	http://cds.cern.ch/record/299621

Ejemplares similares

MOS power transistor and ceramic thyratron for fast high voltage pulser
por: Beninati, A, et al.
Publicado: (1984)

A pulser for spark chambers
por: Rousseau, M D
Publicado: (1961)

PULLIB - The test pulser library
por: Strom, D, et al.
Publicado: (1987)

Switch tube pulser for a 150 MW klystron
por: Bak, P, et al.
Publicado: (1997)

A ceramic thyratron wire spark chamber pulser
por: Friend, B
Publicado: (1969)

Experimental 0.5 ohm delay line pulser
por: CERN. Geneva. Super Proton Synchrotron Division (SPS)
Publicado: (1974)

A fast cycling resonant charging power supply for high voltage burst pulsers
por: Ducimetière, L
Publicado: (1991)

Pulser Calibration of Time Projection Chambers in the NA61/SHINE Experiment
por: Lewicki, Maciej Piotr
Publicado: (2016)

Limited streamer tubes with resistive cathode
por: Battistoni, G, et al.
Publicado: (1982)

Cathode readout with stripped resistive drift tubes
por: Bychkov, V, et al.
Publicado: (1994)

Signal propagation in straw tubes with resistive cathode
por: Marzec, J, et al.
Publicado: (2000)

High voltage switch for kicker magnet applications
por: CERN. Geneva. Super Proton Synchrotron Division (SPS)
Publicado: (1974)

The wire, pad and direct cathode readout of streamer tubes
por: Arefev, A, et al.
Publicado: (1983)

Commissioning of the hard tube pulser experiment at DESY
por: Bieler, M, et al.
Publicado: (1994)

A fast voltage preamplifier for use with MWPCs
por: Barbosa-Ademarlaudo, F, et al.
Publicado: (2005)

Anode wire in cylindrical cathode tube : destabilizing electrostatic force
por: Wertelaers, P
Publicado: (2017)

Dynamic astigmatism and focus correction of the cathode ray tube of ERASME
por: Anders, H, et al.
Publicado: (1974)

Development of high power switches for the LHC beam dumping pulser
por: Courtois, L, et al.
Publicado: (1992)

High voltage tests and training of plastic streamer tubes for the DELPHI hadron calorimeter
por: Alekseev, G D, et al.
Publicado: (1987)

A fast-cathode pad-photon detector for Cherenkov ring imaging
por: Arnold, R, et al.
Publicado: (1992)

GaAs devices with vertical and planar structures for optically activated high-voltage switching
por: Bertolucci, Ennio, et al.
Publicado: (1998)

A fast integrated readout system for a cathode pad photon detector
por: French, M, et al.
Publicado: (1992)

A fast integrated readout system for a cathode pad photon detector
por: French, M, et al.
Publicado: (1993)

The new high voltage supply for ISOLDE: 60 kV Pulser for Isolde
por: Fiander, DC
Publicado: (1992)

A preliminary study of a cathode-ray tube device for scanning spark chamber photographs
por: Anders, H, et al.
Publicado: (1963)

Irradiation of optically activated SI-GaAs high-voltage switches with low and high energy protons
por: Bertolucci, Ennio, et al.
Publicado: (1999)

"Luciole", a cathode-ray tube flying-spot digitizer for measurement of spark-chamber pictures
por: Anders, H, et al.
Publicado: (1964)

Symposium on Cold Cathode Tubes
por: Institution of Electronic and Radio Engineers. London
Publicado: (1964)

Fast tracking detector using multidrift tubes
por: Bouclier, Roger, et al.
Publicado: (1987)

Fast algorithm for track segment and hit reconstruction in the CMS Cathode Strip Chambers
por: Barashko, Victor, et al.
Publicado: (2007)

Development of Fast High-Resolution Muon Drift-Tube Detectors for High Counting Rates
por: Bittner, B., et al.
Publicado: (2016)

Fast Triggering with a Plastic Streamer Tube Calorimeter
por: Eerola, P, et al.
Publicado: (1987)

Fast triggering with a plastic streamer tube calorimeter
por: Eerola, Paule Anna Mari, et al.
Publicado: (1988)

A low-pressure hollow cathode switch triggered by a pulsed electron beam emitted from ferroelectrics
por: Gundel, H, et al.
Publicado: (1989)

Fast Gases for the ATLAS Monitored Drift Tubes
por: Dold, M, et al.
Publicado: (1994)

Cold cathode glow discharge tubes
por: Weston, G F
Publicado: (1968)

Design and Development of a control system for the Drift Tube Chamber High Voltage Power Supply
por: Leon Vega, Luis Gerardo
Publicado: (2017)

Amplitude-tuneable, octal LED pulser for emulation of scintillation light in multi-channel photon detectors
por: Rusu, Alexandru, et al.
Publicado: (2019)

Very low power, high voltage base for a Photo Multiplier Tube for the KM3NeT deep sea neutrino telescope
por: Timmer, P, et al.
Publicado: (2010)

Spatial Resolution Studies in Cathode Pad and in Cathode Strip Chambers
por: Bimbot, L, et al.
Publicado: (1997)

Cannot write session to /tmp/vufind_sessions/sess_7lqp9j4q9k1c8r05s1s3nm0o0r