Cargando…

Feasibility of a 5 cm vacuum aperture for the LSR: laboratory studies on a stainless steel warm and cool bore

Detalles Bibliográficos
Autores principales:	Blechschmidt, Diether, Bojon, J P
Lenguaje:	eng
Publicado:	1976
Materias:	Accelerators and Storage Rings
Acceso en línea:	http://cds.cern.ch/record/312295

Ejemplares similares

New vacuum techniques for small aperture proton storage rings
por: Blechschmidt, Diether, et al.
Publicado: (1977)

Basic design of the vacuum system for 400 GeV LSR with normal magnets
por: Blechschmidt, Diether
Publicado: (1975)

Basic design of the vacuum system for 400 GeV LSR with normal magnets
por: Blechschmidt, Diether
Publicado: (1975)

Prototype vacuum test section for the CERN Large Storage Ring project
por: Blechschmidt, Diether, et al.
Publicado: (1977)

A method to measure the vacuum stability limit of proton storage rings in the laboratory
por: Blechschmidt, Diether
Publicado: (1976)

In situ conditioning for proton storage ring vacuum systems
por: Blechschmidt, Diether
Publicado: (1978)

Reduction of stainless-steel outgassing in ultra-high vacuum
por: Calder, R, et al.
Publicado: (1967)

Specification for welded stainless steel vacuum chambers of the PS
Publicado: (1974)

The Biological Safety of Stainless Steel Needles Used in Warm-needling
por: Lim, Sabina, et al.
Publicado: (2010)

Design considerations in the use of stainless steel for vacuum and cryogenic equipment
por: Geyari, C
Publicado: (1976)

Stainless steel for the new PS vacuum chamber: Status report
por: Poncet, A
Publicado: (1986)

Stainless steel for the new PS vacuum chamber : Status report
por: Poncet, A
Publicado: (1986)

Prototype vacuum test section for the Large Storage Ring (LSR) project.
Publicado: (1977)

Hydrogen content and outgassing of air-baked and vacuum-fired stainless steel
por: Westerberg, L, et al.
Publicado: (1997)

Ultrathin Polyimide-Stainless Steel Heater for Vacuum System Bake-out
por: Rathjen, Christian, et al.
Publicado: (2005)

Proposal for the award of a contract for the supply of seamless austenitic stainless steel tubes for the cold bores of the LHC main magnets
Publicado: (2000)

Relative Magnetic Permeabilities Encountered in the Stainless-Steel Body of the DELPHI Vacuum Vessel
por: Grillet, J P
Publicado: (1986)

Technical specification: Austenitic stainless steel sheets for ultra high vacuum uses
por: CERN. Geneva
Publicado: (1991)

Technical specification for stainless steel for the new proton synchrotron magnet vacuum chamber
Publicado: (1984)

Technical specification stainless steel forgings for the antiproton accumulator ring vacuum system
Publicado: (1978)

Technical specifications - Stainless steel flanges for the antiproton accumulator ring vacuum system
Publicado: (1978)

Stainless steels
por: Davis, J R
Publicado: (1994)

<25> cm aperture lenses at the SC
por: CERN PhotoLab
Publicado: (1966)

The 10 cm aperture, 75 cm long superconducting quadrupole of CERN
por: Asner, Alfred M
Publicado: (1970)

Cleaning and surface analysis of stainless steel ultrahigh vacuum chambers by argon gas discharge
por: Calder, R, et al.
Publicado: (1977)

The influence of vacuum annealing, glow discharge and electropolishing on the topography of stainless steel sheet metal
por: Unterlerchner, W
Publicado: (1977)

IR aperture measurement at β*=40 cm
por: Bruce, Roderik, et al.
Publicado: (2015)

Aperture of the stochastic cooling system
por: Beloshitsky, P, et al.
Publicado: (1998)

Vacuum chamber apertures for the PSB
por: Bovet, C
Publicado: (1969)

Vacuum chamber apertures of the PS
por: Richter, W
Publicado: (1971)

Corrosion of stainless steels /
por: Sedriks, A. John
Publicado: (1996)

Corrosion of stainless steels
por: Sedriks, A John
Publicado: (1996)

A Photodesorption Study of a TiZrV Coated Stainless Steel Vacuum Chamber
por: Collins, I R, et al.
Publicado: (2002)

Thermal And Pressure Induced Stresses In A Prototype Stainless Steel LEP-70 Vacuum Chamber
por: Lefrançois, A, et al.
Publicado: (1978)

The Impact of Surface Treatment and Degree of Vacuum on the Interface and Mechanical Properties of Stainless Steel Clad Plate
por: Feng, Ying-ying, et al.
Publicado: (2018)

Large-bore vacuum-assisted biopsy of axillary lymphadenopathy
por: Forester, ND, et al.
Publicado: (2011)

Dynamic vacuum behaviour of the Cold Bore saturated with hydrogen
por: Benvenuti, C, et al.
Publicado: (1978)

Long term Vacuum Test on an Unbaked Cold Bore
por: Benvenuti, C, et al.
Publicado: (1979)

Linear sputter-ion pump for integration in high magnetic fields
por: Blechschmidt, Diether, et al.
Publicado: (1980)

Incoherent tune shift in LSR
por: Bassetti, M, et al.
Publicado: (1974)

Cannot write session to /tmp/vufind_sessions/sess_8uiemtvicrloc16r5dv93cv2f7