Cargando…

Construction problems with large proportional wire chambers

Detalles Bibliográficos
Autores principales:	Dieperink, J H, Kleinknecht, K, Steffen, P, Steinberger, Jack, Trippe, T G, Vannucci, François
Lenguaje:	eng
Publicado:	1969
Materias:	Detectors and Experimental Techniques
Acceso en línea:	http://cds.cern.ch/record/314012

Ejemplares similares

Construction and performance of large multiwire proportional chambers
por: Schilly, P, et al.
Publicado: (1970)

Some new resullts on the development of support lines for large proportional wire chambers
por: Kleinknecht, K, et al.
Publicado: (1970)

A large multiwire proportional chamber spectrometer
por: Dieperink, J H, et al.
Publicado: (1971)

Performance of large charpak chambers
por: Dieperink, J H, et al.
Publicado: (1969)

Some observations concerning the construction of proportional chambers with thick sense wires
por: Bréhin, S, et al.
Publicado: (1975)

A system of multigap proportional wire chambers
por: Bell, W, et al.
Publicado: (1978)

Proportional chambers for a 50000-wire detector
por: Bouclier, Roger, et al.
Publicado: (1974)

A system of proportional chambers with 50000 wires
por: Bouclier, Roger, et al.
Publicado: (1973)

Minimum tension requirement for Charpak chamber wires
por: Trippe, T G
Publicado: (1969)

Performance of a system of proportional wire chambers
por: Bemporad, C, et al.
Publicado: (1970)

The multiwire drift chamber a new type of proportional wire chamber
por: Walenta, Albert H, et al.
Publicado: (1971)

Operation of multiwire proportional chambers with small wire spacing
por: Bouclier, R, et al.
Publicado: (1970)

A wiring system for mass production of drift and proportional chambers
por: Böck, R K, et al.
Publicado: (1993)

A study of the performance of a propotional wire chamber with different distances between wire and High-voltage plane
por: Steffen, P, et al.
Publicado: (1969)

Calibration of the pad readout wire proportional chambers for the HPC calorimeter
por: Camporesi, T, et al.
Publicado: (1989)

Operation system for a 50000-wire proportional chamber detector
por: Bell, W, et al.
Publicado: (1974)

Tests on wire grouping in a multiwire proportional chamber (MWPC)
por: Uto, H, et al.
Publicado: (1972)

Comparative aging studies on a Single Wire Proportional Chamber
por: Fiorina, Davide
Publicado: (2020)

The cost of electronic circuits for multiwire proportional chambers
por: Kleinknecht, K, et al.
Publicado: (1970)

The automatic stabilisation of gas amplification in linear multi-wire proportional chambers
por: Lindsay, J, et al.
Publicado: (1977)

On the localization of the position of the particle along the wire of a multiwire proportional chamber
por: Föth, H, et al.
Publicado: (1973)

Development of large planar proportional chambers
por: Bozzo, M, et al.
Publicado: (1980)

A memory-level decision for a 50000-wire proportional-chamber detector
por: Brandt, A, et al.
Publicado: (1975)

Design and construction of the wire chamber sectors for the ALEPH time projection chamber
por: Ackermann, K H, et al.
Publicado: (1991)

Trigger-Induced Mechanical Resonances of Gating Grid Wires in the Multi-Wire Proportional Chambers of the ALICE TPC
por: Horn, C J, et al.
Publicado: (2012)

High-accuracy measurements in proportional chambers and clarification of the avalanche mechanisms around wires
por: Charpak, Georges, et al.
Publicado: (1978)

Iterative track fitting using cluster classification in multi wire proportional chamber
por: Primor, David, et al.
Publicado: (2007)

Anode wire ageing in proportional counters: the problem of analog response
por: Algeri, A, et al.
Publicado: (1993)

A trigger and control system for a 50K-wire proportional chamber detector
por: Bell, W, et al.
Publicado: (1973)

Design and construction of the wire chambers for the LHCb muon system
por: Kachtchouk, A, et al.
Publicado: (2001)

Some features of large multiwire proportional chambers
por: Charpak, Georges, et al.
Publicado: (1971)

Results of tests on a large multiwire proportional chamber
por: Bussmann, K, et al.
Publicado: (1970)

The aging of wire chambers filled with dimethyl ether: wire and construction materials and freon impurities
por: Jibaly, M, et al.
Publicado: (1989)

Apulse transformer for large wire spark chambers
por: Andersson, L, et al.
Publicado: (1969)

Electrostatics Problems of Multiwire Proportional Chambers with Dielectric in the Operational Volume
por: Shafranov, M D
Publicado: (1999)

A general description of the SFM read-out system for 50.000 proportional chamber wires
por: Lindsay, J, et al.
Publicado: (1971)

Proposed addition of wire proportional chamber arrays and scintillation hodoscopes in the I1 intersection region
por: CERN. Geneva, et al.
Publicado: (1972)

Design and Construction of a Cathode Readout Proportional Chamber for the HPC Calorimeter
por: Bollini, D, et al.
Publicado: (1985)

Design and construction of a cathode readout proportional chamber for the HPC calorimeter
por: Bollini, D, et al.
Publicado: (1986)

Problems connected with the use of sets of wire spark chambers in an experiment
por: Bradamante, F, et al.
Publicado: (1969)

Cannot write session to /tmp/vufind_sessions/sess_9f3uh693uno5bjgvgr4aro0k0g