Cargando…

The surface composition of pure Titanium and a Titanium alloy (73 Ti 13 V 11 Cr 3 Al 0.05C) as a function of temperature

Detalles Bibliográficos
Autor principal:	Mathewson, A G
Lenguaje:	eng
Publicado:	1974
Materias:	Accelerators and Storage Rings
Acceso en línea:	http://cds.cern.ch/record/314274

Ejemplares similares

Ion induced desorption coefficients for titanium alloy, pure aluminium and stainless steel
por: Mathewson, A G
Publicado: (1976)

Origin of colossal dielectric permittivity of rutile Ti(0.9)In(0.05)Nb(0.05)O(2): single crystal and polycrystalline
por: Song, Yongli, et al.
Publicado: (2016)

The Effect of the Corrosion Medium on Silane Coatings Deposited on Titanium Grade 2 and Titanium Alloy Ti13Nb13Zr
por: Kierat, Oliwia, et al.
Publicado: (2021)

Revealing the WEDM Process Parameters for the Machining of Pure and Heat-Treated Titanium (Ti-6Al-4V) Alloy
por: Gupta, Nitin Kumar, et al.
Publicado: (2021)

Mechanical Properties and Residual Stress Measurements of Grade IV Titanium and Ti-6Al-4V and Ti-13Nb-13Zr Titanium Alloys after Laser Treatment
por: Jażdżewska, Magdalena, et al.
Publicado: (2021)

Study of the Influence of Zirconium, Titanium and Strontium on the Properties and Microstructure of AlSi7Mg0.3Cu0.5 Alloy
por: Bolibruchová, Dana, et al.
Publicado: (2022)

Efficacy of Topical Cyclosporine Nanoemulsion 0.05% Compared with Topical Cyclosporine Emulsion 0.05% and Diquafosol 3% in Dry Eye
por: Park, Chang Hyun, et al.
Publicado: (2019)

Grain Growth Behavior of 0.95(Na(0.5)Bi(0.5))TiO(3)–0.05BaTiO(3) Controlled by Grain Shape and Second Phase
por: Jeon, Sang-Chae, et al.
Publicado: (2020)

Electronic, electrical and thermoelectric properties of Ba(0.95)Ca(0.05)Ti(0.95)Y(0.05)O(2.975) compound: Experimental study and DFT-mBJ calculation
por: Saidi, A., et al.
Publicado: (2023)

Effect of Microwave Sintering on the Properties of 0.95(Ca(0.88)Sr(0.12))TiO(3)–0.05(Bi(0.5)Na(0.5))TiO(3) Ceramics
por: Tian, Lei, et al.
Publicado: (2019)

In vitro evaluation of cytotoxicity and corrosion behavior of commercially pure titanium and Ti-6Al-4V alloy for dental implants
por: Chandar, Sanchitha, et al.
Publicado: (2017)

Efficacy of 0.05% Chlorhexidine and 0.05% Cetylpyridinium Chloride Mouthwash to Eliminate Living Bacteria on In Situ Collected Biofilms: An In Vitro Study
por: Becker, Kathrin, et al.
Publicado: (2021)

Are Only p-Values Less Than 0.05 Significant? A p-Value Greater Than 0.05 Is Also Significant!
por: Kwak, Sanggyu
Publicado: (2023)

Titanium and titanium alloys: fundamentals and applications
por: Leyens, Christoph, et al.
Publicado: (2003)

Bactericidal and antimicrobial effects of pure titanium and titanium alloy treated with short-term, low-energy UV irradiation
por: Itabashi, T., et al.
Publicado: (2017)

Combustion Behavior and Mechanism of Ti14 Titanium Alloy
por: Shao, Lei, et al.
Publicado: (2020)

Cytotoxicity of Commercially Pure Titanium (cpTi), Silver-Palladium (Ag-Pd), and Nickel-Chromium (Ni-Cr) Alloys Commonly Used in the Fabrication of Dental Prosthetic Restorations
por: Ellakany, Passent, et al.
Publicado: (2022)

Scale-Dependent Dielectric Properties in BaZr(0.05)Ti(0.95)O(3) Ceramics
por: Padurariu, Leontin, et al.
Publicado: (2020)

0.05 - 100 MHz 4 W amplifier
por: Paoluzzi, M
Publicado: (1997)

Halometasone monohydrate (0.05%) in occupational contact dermatitis
por: Maiti, Rituparna, et al.
Publicado: (2016)

Tribological Properties of Ti-TiC Composite Coatings on Titanium Alloys
por: Zhevtun, Ivan G., et al.
Publicado: (2022)

Magnetic properties of the complex concentrated alloy system CoFeNi(0.5)Cr(0.5)Al(x)
por: Morley, N. A., et al.
Publicado: (2020)

A Lightweight AlCrTiV(0.5)Cu(x) High-Entropy Alloy with Excellent Corrosion Resistance
por: Peng, Zhen, et al.
Publicado: (2023)

Microstructural Characterization of Al(0.5)CrFeNiTi High Entropy Alloy Produced by Powder Metallurgy Route
por: Geambazu, Laura Elena, et al.
Publicado: (2023)

Is titanium–zirconium alloy a better alternative to pure titanium for oral implant? Composition, mechanical properties, and microstructure analysis
por: Sharma, Ajay, et al.
Publicado: (2021)

Nitriding Phenomena in Titanium and the 6Al-4V Titanium Alloy
por: Cuthill, J. R., et al.
Publicado: (1960)

Influence of Titanium on Microstructure, Phase Formation and Wear Behaviour of AlCoCrFeNiTi(x) High-Entropy Alloy
por: Löbel, Martin, et al.
Publicado: (2018)

Fretting Corrosion Behavior of Experimental Ti-20Cr Compared to Titanium
por: Sawada, Tomofumi, et al.
Publicado: (2017)

The possibility of recasting of pure titanium
por: Lai, Pei-Ling, et al.
Publicado: (2017)

Carbon in Commercially Pure Titanium
por: Szkliniarz, Agnieszka, et al.
Publicado: (2023)

EFFECT OF TEMPERATURE VARIATION ON THE CYTOTOXICITY OF CAST DENTAL ALLOYS AND COMMERCIALLY PURE TITANIUM
por: Faria, Adriana Cláudia Lapria, et al.
Publicado: (2009)

Corrosion Analysis of an Experimental Noble Alloy on Commercially Pure Titanium Dental Implants
por: Bortagaray, Manuel Alberto, et al.
Publicado: (2016)

Analogous Anti-Ferroelectricity in Y(2)O(3)-Coated (Pb(0.92)Sr(0.05)La(0.02))(Zr(0.7)Sn(0.25)Ti(0.05))O(3) Ceramics and Their Energy-Storage Performance
por: Fang, Bijun, et al.
Publicado: (2019)

The Optoelectronic Properties of p-Type Cr-Deficient Cu[Cr(0.95−x)Mg(0.05)]O(2) Films Deposited by Reactive Magnetron Sputtering
por: Lin, Song-Sheng, et al.
Publicado: (2020)

The Microstructural Difference and Its Influence on the Ballistic Impact Behavior of a Near β-Type Ti5.1Al2.5Cr0.5Fe4.5Mo1.1Sn1.8Zr2.9Zn Titanium Alloy
por: Zhu, Xinjie, et al.
Publicado: (2020)

Machining of titanium alloys
por: Davim, J
Publicado: (2014)

Electron Beam Welding Process for Ti6Al-4V Titanium Alloy
por: Wencel, Zbigniew, et al.
Publicado: (2023)

Comparison of Mechanical and Structural Properties of Nickel-titanium Alloy with Titanium-molybdenum Alloy and Titanium-niobium Alloy as Potential Metals for Endodontic Files
por: Nino-Barrera, Javier Laureano, et al.
Publicado: (2021)

High-Temperature Wear Behaviour of Spark Plasma Sintered AlCoCrFeNiTi(0.5) High-Entropy Alloy
por: Löbel, Martin, et al.
Publicado: (2019)

Comparison of the latanoprost 0.005%/timolol 0.5% + brinzolamide 1% versus dorzolamide 1%/timolol 0.5% + latanoprost 0.005%: a 12-week, randomized open-label trial
por: Nakakura, Shunsuke, et al.
Publicado: (2012)

Cannot write session to /tmp/vufind_sessions/sess_vmu68abrkchigqkoe50iasmhct