Cargando…

A miniature extractor gauge for the UHV

Detalles Bibliográficos
Autor principal:	Blechschmidt, Diether
Lenguaje:	eng
Publicado:	1974
Materias:	Accelerators and Storage Rings
Acceso en línea:	https://dx.doi.org/10.1116/1.1318702 http://cds.cern.ch/record/314279

Ejemplares similares

A miniature extractor gauge for the UHV (in particle storage rings)
por: Blechschmidt, Diether
Publicado: (1974)

Low pressure limitation of the orbitron ionization gauge
por: Blechschmidt, Diether
Publicado: (1974)

A new deflected beam gauge for pressures below 10$^{-12}$ torr
por: Blechschmidt, Diether
Publicado: (1975)

An ionization gauge using a Channel Electron Multiplier for pressures below 10$^{-12}$ Torr
por: Blechschmidt, Diether
Publicado: (1972)

UHV for accelerators
por: Poncet, A
Publicado: (1995)

Improvements of UHV copper gaskets
por: Wikberg, T
Publicado: (1968)

Technical requirements for UHV-flanges
por: Wahl, H
Publicado: (1979)

A rapid UHV protective gate valve
por: Delfosse, J
Publicado: (1980)

The LEAR UHV system: Past, present and future
por: Bourgeois, M, et al.
Publicado: (1987)

The operation of the ISR facility in relation to the UHV environment
por: Jones, E
Publicado: (1972)

Overview of Current UHV Activities on CERN Accelerators
por: Poncet, Alain
Publicado: (1998)

The LEAR UHV system: past, present and future
por: Bourgeois, M, et al.
Publicado: (1988)

UHV Arc for High Quality Film Deposition
por: Russo, R, et al.
Publicado: (2006)

Run 528, both rings, 5C26, 19.9.74: Dependence of the average pressure on the thermal outgassing of the UHV gauges
por: Calder, R, et al.
Publicado: (1974)

Monte Carlo study of light transmission through a cylindrical tube
por: Blechschmidt, Diether
Publicado: (1973)

A method to measure the vacuum stability limit of proton storage rings in the laboratory
por: Blechschmidt, Diether
Publicado: (1976)

Experience with UHV-compatible microwave absorbing materials at CERN
por: Caspers, F
Publicado: (1993)

Basic design of the vacuum system for 400 GeV LSR with normal magnets
por: Blechschmidt, Diether
Publicado: (1975)

In situ conditioning for proton storage ring vacuum systems
por: Blechschmidt, Diether
Publicado: (1978)

Basic design of the vacuum system for 400 GeV LSR with normal magnets
por: Blechschmidt, Diether
Publicado: (1975)

Design of a new UHV all-metal joint for CLIC
por: Lutkiewicz, P, et al.
Publicado: (2009)

Technical specification for the supply of vacuum gauges for the LEP pre-injector LINACS
por: Blechschmidt, G
Publicado: (1983)

Thermal analysis of UHV beam tube of SIS100 for FAIR
por: Shim, S Y, et al.
Publicado: (2009)

FEM calculations of UHV all-metal demountable joints for LEP
por: Wikberg, Tore, et al.
Publicado: (1990)

Super-conducting Niobium Films Produced By Means Of UHV Arc
por: Langner, J, et al.
Publicado: (2004)

Brazing of niobium to stainless steel for UHV applications in superconducting cavities
por: Bacher, J P, et al.
Publicado: (1987)

The optimization of a tubular condensation cryopump for pressures below 10$^{-13}$ torr
por: Benvenuti, Cristoforo, et al.
Publicado: (1974)

A Novel Differentially Pumped UHV Flange in the CESR Interaction Region
por: Li, Y, et al.
Publicado: (2001)

Minutes of the Long Term Development Committee
por: Johnsen, Kjell, et al.
Publicado: (1977)

Measurement of Ultra Low Outgassing Rates for NLC UHV Vacuum Chambers
por: Kishiyama, K, et al.
Publicado: (2001)

Requirements for and experience with the vacuum controls during commissioning of the LEP uhv system
por: Bienfait, J N, et al.
Publicado: (1989)

Requirements for and experience with the vacuum controls during commissioning of the LEP UHV-system
por: Strubin, Pierre M, et al.
Publicado: (1990)

Feasibility of a 5 cm vacuum aperture for the LSR: laboratory studies on a stainless steel warm and cool bore
por: Blechschmidt, Diether, et al.
Publicado: (1976)

Prototyp Vakuum-Sektor für das grosse Speicherring-Projekt des CERN
por: Blechschmidt, Diether, et al.
Publicado: (1978)

Parametres pour l'articulation fonctionnant sous U.H.V
Publicado: (1979)

An X-band Dielectric-based Wakefield Power Extractor
por: Jing, Chunguang, et al.
Publicado: (2013)

New vacuum techniques for small aperture proton storage rings
por: Blechschmidt, Diether, et al.
Publicado: (1977)

Deposition of superconducting niobium films for RF cavities by means of UHV cathodic Arc
por: Langner, J, et al.
Publicado: (2005)

Extractor Configurations for a Heavy Ion Fusion Volume Source
por: Anderson, O A
Publicado: (1999)

Molecular and radiation transmissivities of chevron type baffles for cryopumping
por: Benvenuti, Cristoforo, et al.
Publicado: (1981)

Cannot write session to /tmp/vufind_sessions/sess_quch3cp9inq2oa75b9lrc6n6lq