Cargando…

Some aspects of diffusion in niobium by high temperature gettering

Detalles Bibliográficos
Autor principal:	Singer, W
Lenguaje:	eng
Publicado:	1996
Materias:	Engineering
Acceso en línea:	http://cds.cern.ch/record/315253

Ejemplares similares

High pressure water- and electroerosion cutting of niobium
por: Proch, D, et al.
Publicado: (1995)

Lowering the activation temperature of TiZrV non-evaporable getter films
por: Taborelli, M, et al.
Publicado: (1999)

Molecular surface pumping: the getter pumps
por: Benvenuti, Cristoforo
Publicado: (1999)

Influence of coating temperature on niobium films
por: Russo, R, et al.
Publicado: (1997)

Lowering the activation temperature of TiZrV non-evaporable getter films [for LHC]
por: Prodromides, A E, et al.
Publicado: (2001)

Room temperature measurements of the molecular photodesorption yields from a TiZr getter film
por: Baglin, V, et al.
Publicado: (1998)

Room temperature measurements of the molecular photodesorption yields from a TiZr getter film
por: Baglin, V
Publicado: (1998)

Influence of the substrate coating temperature on the vacuum properties of Ti-Zr-V non-evaporable getter films
por: Costa-Pinto, P, et al.
Publicado: (2003)

Adsorption and desorption properties of TiZrV getter film at different temperatures in the presence of synchrotron radiation
por: Anashin, V V, et al.
Publicado: (2008)

Conference on Gettering and Defect Engineering in Semiconductors : GADEST '93
Publicado: (1993)

Decreasing surface outgassing by thin film getter coatings
por: Benvenuti, Cristoforo, et al.
Publicado: (1998)

Temperature influence on the oxidation of niobium for superconducting RF cavities
por: Daccà, A, et al.
Publicado: (1997)

Electron stimulated molecular desorption of a non-evaporable Zr-V-Fe alloy getter at room temperature
por: Le Pimpec, Frederic, et al.
Publicado: (2002)

Hydroforming test of back extruded niobium tube
por: Gonin, I V, et al.
Publicado: (1997)

Molecular dynamics simulation of hydrogen diffusion in niobium: influence of point defects
por: Roux, B, et al.
Publicado: (1994)

Reactive diffusion produced niobium nitride films for superconducting cavity applications
por: Benvenuti, Cristoforo, et al.
Publicado: (1993)

Tantalum and niobium
por: Miller, George Leslie
Publicado: (1959)

XPS analysis of the activation process in non-evaporable getter thin films
por: Lozano, M, et al.
Publicado: (2000)

7th International Autumn Meeting on Gettering and Defect Engineering in Semiconductor Technology
Publicado: (1997)

Structural and RF properties of niobium films deposited onto annealed niobium resonators
por: Benvenuti, Cristoforo, et al.
Publicado: (1997)

High-Q, high gradient niobium-coated cavities at CERN
por: Calatroni, Sergio, et al.
Publicado: (1999)

Molecular desorption of a nonevaporable getter St 707 irradiated at room temperature with synchrotron radiation of 194 eV critical photon energy
por: Le Pimpec, F, et al.
Publicado: (2003)

A novel route to extreme vacua: the non-evaporable getter thin film coatings
por: Benvenuti, Cristoforo, et al.
Publicado: (1999)

Upgrading of niobium sheet cavities
por: Hilleret, Noël
Publicado: (1993)

Evidence of preferential diffusion and segregation of impurities at grain boundaries in very pure niobium used for radiofrequency cavities
por: Antoine, C Z, et al.
Publicado: (1996)

Black silicon significantly enhances phosphorus diffusion gettering
por: Pasanen, Toni P., et al.
Publicado: (2018)

Getter pumping
por: Benvenuti, C
Publicado: (2007)

Niobium sputter-coated copper resonators
por: Benvenuti, Cristoforo, et al.
Publicado: (1997)

Magnetic flux trapping in superconducting niobium
por: Benvenuti, Cristoforo, et al.
Publicado: (1997)

Givers and Not Getters
por: Steen, Anthony
Publicado: (1964)

Investigation on barrel polishing for superconducting niobium cavities
por: Higuchi, T, et al.
Publicado: (1996)

The secondary electron yield of TiZr and TiZrV non evaporable getter thin film coatings
por: Scheuerlein, C, et al.
Publicado: (2000)

Some aspect of strontium radiobiology
por: National Council on Radiation Protection and Measurements. Washington, DC
Publicado: (1991)

Production of ultra-high-vacuum chambers with integrated getter thin-film coatings by electroforming
por: Lain Amador, Lucia
Publicado: (2019)

Diagnostic of Defects in High Purity Niobium
por: Singer, W, et al.
Publicado: (1998)

RRR evaluation of niobium using AC susceptibility measurement
por: Wake, M, et al.
Publicado: (1996)

Tantalum and niobium-based capacitors: science, technology, and applications
por: Freeman, Yuri
Publicado: (2017)

Study of ultra-clean surface for niobium SC cavities
por: Saitô, K, et al.
Publicado: (1994)

Magnetization measurement of niobium for superconducting cavity material evaluation
por: Wake, M, et al.
Publicado: (1995)

Fluxon-induced losses in niobium thin-film cavities
por: Weingarten, Wolfgang
Publicado: (2000)

Cannot write session to /tmp/vufind_sessions/sess_dekeibpcuseldjv490vnmi6p17