Cargando…

Possible parameters of pulsers for linear induction linacs

Detalles Bibliográficos
Autor principal:	Bobylev, V I
Lenguaje:	eng
Publicado:	CERN 1987
Materias:	XX
Acceso en línea:	https://dx.doi.org/10.5170/CERN-1987-011-V-1.202 http://cds.cern.ch/record/370349

Ejemplares similares

Possibilities Of Inductive Storage Circuits In Induction linacs
por: Bobylev, V I
Publicado: (1990)

New LINAC quadrupole pulsers
por: Sherwood, TR
Publicado: (1974)

Cost optimization of induction linac drivers for linear colliders
por: Barletta, W A
Publicado: (1987)

A High Power Linear Solid State Pulser
por: Yen, B, et al.
Publicado: (1999)

The Q-jump pulser
por: Cappi, R
Publicado: (1971)

The Timing and Diagnostic Systems of the Kicker Magnet Pulsers for the Stanford Linear Collider
por: Gough, D E, et al.
Publicado: (1990)

PULLIB - The test pulser library
por: Strom, D, et al.
Publicado: (1987)

A pulser for spark chambers
por: Rousseau, M D
Publicado: (1961)

Switch tube pulser for a 150 MW klystron
por: Bak, P, et al.
Publicado: (1997)

Simulation of Kicker Pulser with Matlab Simulink
por: Fann, C S, et al.
Publicado: (2001)

Q-jump pulser for transition experiments
por: Thorndahl, L
Publicado: (1969)

Commissioning of the hard tube pulser experiment at DESY
por: Bieler, M, et al.
Publicado: (1994)

RNA Modification Level Estimation with pulseR
por: Boileau, Etienne, et al.
Publicado: (2018)

Simulation studies of main linac steering in the next linear collider
por: Tenenbaum, P G
Publicado: (1999)

A ceramic thyratron wire spark chamber pulser
por: Friend, B
Publicado: (1969)

Experimental 0.5 ohm delay line pulser
por: CERN. Geneva. Super Proton Synchrotron Division (SPS)
Publicado: (1974)

A spark chamber pulser with short delay time
por: Goodchild, J L
Publicado: (1965)

Development of high power switches for the LHC beam dumping pulser
por: Courtois, L, et al.
Publicado: (1992)

MOS power transistor and ceramic thyratron for fast high voltage pulser
por: Beninati, A, et al.
Publicado: (1984)

Pulser Calibration of Time Projection Chambers in the NA61/SHINE Experiment
por: Lewicki, Maciej Piotr
Publicado: (2016)

Septum and Kicker Pulsers for the LNLS 500-MeV Booster Synchrotron
por: Lira, A C, et al.
Publicado: (2001)

High repetition rate pulser concepts for a recirculating HIF driver
por: Newton, M A, et al.
Publicado: (1992)

Induction linacs
por: De Mascureau, J
Publicado: (1996)

Possible modification of the linear and cyclical methods of acceleration
por: Sinelnikov, K D, et al.
Publicado: (1956)

A fast-charging power supply for the delay lines of the kicker magnet pulsers
por: Cupérus, J
Publicado: (1968)

The new high voltage supply for ISOLDE: 60 kV Pulser for Isolde
por: Fiander, DC
Publicado: (1992)

High average power linear induction accelerator development
por: Bayless, J R, et al.
Publicado: (1987)

Linac Parameters
por: Hill, CE, et al.
Publicado: (1983)

Deuterons Acceleration in I-100 Linac
por: Antipov, Yu M, et al.
Publicado: (2003)

A fast high voltage pulser using a cold cathode switch tube
por: Den Herder, J M
Publicado: (1967)

High tension burst pulser for the electron extraction kickers of the CERN Super Proton Synchrotron
por: Schröder, G, et al.
Publicado: (1984)

Construction and 60 kV tests of the prototype pulser for the LHC injection kicker system
por: Barnes, M J, et al.
Publicado: (1999)

A fast cycling resonant charging power supply for high voltage burst pulsers
por: Ducimetière, L
Publicado: (1991)

CLIC drive beam generation by induction Linac and FEL experimental studies for the CERN linear collider
por: Corsini, R, et al.
Publicado: (1993)

CLIC drive beam generation by induction Linac and FEL experimental studies for the CERN linear collider
por: Corsini, R, et al.
Publicado: (1993)

Using the Gene Pulser MXcell Electroporation System to Transfect Primary Cells with High Efficiency
por: McCoy, Adam M., et al.
Publicado: (2010)

Choice of parameters for linear colliders in multi-bunch mode
por: Claus, J
Publicado: (1987)

Energy recovery linacs
por: Werin, S
Publicado: (2005)

High current induction linacs
por: Barletta, W A, et al.
Publicado: (1994)

Design Proposal for a Compact, Solid-State, Low-Power Klystron-Pulser for CTF3
por: Pearce, P
Publicado: (2001)

Cannot write session to /tmp/vufind_sessions/sess_17rflvecsiv4dk6nah62murfjm