Cargando…

Tip Heater for Minimum Quench Energy Measurements on Superconducting Strands

Superconducting strands can be characterized by their Minimum Quench Energy (MQE), i.e. the minimum heat pulse needed to trigger a quench in operation conditions (field, temperature, current), in the limit of a (temporally and spatially) d-shaped disturbance. The sub-mm/µs range of perturbation spac...

Descripción completa

Detalles Bibliográficos
Autores principales:	Bauer, P, Donnier, J, Oberli, L R
Lenguaje:	eng
Publicado:	1998
Materias:	Accelerators and Storage Rings
Acceso en línea:	http://cds.cern.ch/record/372931

Ejemplares similares

Minimum Quench Energies of LHC Strands
por: Bauer, P, et al.
Publicado: (1998)

Minimum Quench Energy and Early Quench Development in NbTi Superconducting Strands
por: Breschi, M, et al.
Publicado: (2007)

Quench Heater Experiments on the LHC Main Superconducting Magnets
por: Rodríguez-Mateos, F, et al.
Publicado: (2000)

Temperature Profiles During Quenches in LHC Superconducting Dipole Magnets Protected by Quench Heaters
por: Maroussov, V, et al.
Publicado: (1999)

Overview of the Performance of Quench Heaters for High-Current LHC Superconducting Magnets
por: Charifoulline, Zinour, et al.
Publicado: (2017)

Development of Industrially Produced Composite Quench Heaters for the LHC Superconducting Lattice Magnets
por: Szeless, Balázs, et al.
Publicado: (1996)

MD#1826: Measurement of Quench Heater vertical kick
por: Valette, Matthieu, et al.
Publicado: (2018)

Quench Heater Studies for the LHC Magnets
por: Rodríguez-Mateos, F, et al.
Publicado: (2001)

Magnetization Measurements on LHC Superconducting Strands
por: Fikis, H, et al.
Publicado: (1998)

Magnetization measurements on LHC superconducting strands
por: Le Naour, S, et al.
Publicado: (1999)

Coating Thickness of the LHC Superconducting Strands
por: Charras, N, et al.
Publicado: (2003)

Modeling heat transfer from quench protection heaters to superconducting cables in Nb$_{3}$Sn magnets
por: Salmi, T., et al.
Publicado: (2014)

The quality assurance of superconducting strand and cable for LHC
por: Oberli, L R
Publicado: (2001)

Experimental measured minimum quench energies of LHC cables
por: Wilson, M N, et al.
Publicado: (1997)

On the Mechanical Behavior of a Nb$_3$Sn Superconducting Coil During a Quench: Two-Dimensional Finite Element Analysis of a Quench Heater
por: Ferradas Troitino, J, et al.
Publicado: (2019)

Modeling of Minimum Energy Required to Quench an HTS Magnet With a Strip Heater
por: Härö, E, et al.
Publicado: (2015)

Calculation of minimum quench energies in Rutherford cables
por: Wilson, M N, et al.
Publicado: (1996)

Computation of minimum quench energies in LHC cables
por: Wilson, M N
Publicado: (1997)

Effect of Quench Heater and CLIQ Firing on the Circulating HL-LHC Beam
por: Valette, M, et al.
Publicado: (2017)

Strand Coating for the Superconducting Cables of the LHC Main Magnets
por: Adam, J D, et al.
Publicado: (1998)

DC measurement of electrical contacts between strands in superconducting cables for the LHC main magnets
por: Richter, D, et al.
Publicado: (1996)

Effect of Quench Heater Discharges on the Circulating Beam in the Large Hadron Collider
por: Richtmann, Lea
Publicado: (2021)

Assessment of MQXF Quench Heater Insulation Strength and Test of Modified Design
por: Baldini, Maria, et al.
Publicado: (2021)

Beam-Based Reconstruction of the Shielded Quench-Heater Fields for the LHC Main Dipoles
por: Richtmann, Lea, et al.
Publicado: (2022)

Critical Current Test Facilities for LHC Superconducting NbTi Cable Strands
por: Boutboul, T, et al.
Publicado: (2001)

Stability of Superconducting Strands for Accelerator Magnets
por: Bauer, P
Publicado: (1996)

Improved Quench Localization and Quench Propagation Velocity Measurements in the LHC Superconducting Dipole Magnets
por: Calvi, M, et al.
Publicado: (2005)

Quench protection heater studies for the 1-m model magnets for the LHC low-beta quadrupoles
por: Burkhardt, E E, et al.
Publicado: (2000)

Critical Current Density in Superconducting Nb-Ti Strands in the 100 mT to 11 T Applied Field Range
por: Boutboul, T, et al.
Publicado: (2006)

Thickness measurement of Sn-Ag hot dip coatings on Large Hadron Collider Superconducting strands by coulometry
por: Arnau-Izquierdo, G, et al.
Publicado: (2003)

Aluminum strand coating for increasing the interstrand contact resistance in Rutherford type superconducting cables
por: Scheuerlein, C, et al.
Publicado: (2009)

Overview of the Quench Heater Performance for MQXF, the Nb$_{3}$Sn Low-$\beta$ Quadrupole for the High Luminosity LHC
por: Izquierdo Bermudez, Susana, et al.
Publicado: (2018)

An Experimental Setup to Measure the Minimum Trigger Energy for Magneto-Thermal Instability in Nb$_{3}$Sn Strands
por: Takala, E, et al.
Publicado: (2012)

Investigation of quench pressure transients in the LHC superconducting magnets
por: Lebrun, P, et al.
Publicado: (1994)

Quench Protection Heater Study With the 2-m Model Magnet of Beam Separation Dipole for the HL-LHC Upgrade
por: Suzuki, Kento, et al.
Publicado: (2018)

Training Quench Performance and Quench Location of the Short Superconducting Dipole Models for the LHC
por: Sanfilippo, S, et al.
Publicado: (2002)

Investigation of quench pressure transients in the LHC superconducting magnets
por: Lebrun, P
Publicado: (1994)

Quench simulations for superconducting elements in the LHC accelerator
por: Sonnemann, F, et al.
Publicado: (2000)

Quench Protection for Superconducting IR Magnets in CESR
por: Codner, G W, et al.
Publicado: (1999)

Accelerator Magnet Quench Heater Technology and Quality Control Tests for the LHC High Luminosity Upgrade
por: Meuter, Florian
Publicado: (2017)

Cannot write session to /tmp/vufind_sessions/sess_gkr1lbm4pb9mo4auatdkq66tkn