Cargando…

Installation for measurement of anode wires tension in detectors by an acoustic method

Detalles Bibliográficos
Autores principales:	Semenov, B Yu, Mishin, S V
Lenguaje:	rus
Publicado:	1998
Materias:	Detectors and Experimental Techniques
Acceso en línea:	http://cds.cern.ch/record/384840

Ejemplares similares

Pre-tensioning of Anode Wires.
por: Bratzler, U, et al.
Publicado: (1997)

MDT WIRE TENSION MEASUREMENT USING AN ELECTROSTATIC METHOD
por: Balla, A, et al.
Publicado: (1998)

Measuring and Verifying Wire Tension
por: Taylor, FE
Publicado: (1998)

Wire tension measurements for the ATLAS end-cap TRT
por: Barberio, E, et al.
Publicado: (2000)

Automated sixteen channels wire tension measurement system
por: Balla, A, et al.
Publicado: (1999)

A simple wire-tension measurement system
por: Fujimoto, K, et al.
Publicado: (1997)

A method for tension control of MWPC wires
por: Köne, B, et al.
Publicado: (1981)

A Laser Based Instrument for MWPC Wire Tension Measurement
por: Baldini, W, et al.
Publicado: (2007)

An acoustically controlled tetherless underwater vehicle for installation and maintenance of neutrino detectors in the deep ocean
por: Ballou, P J
Publicado: (1997)

Temperature Dependence of MDT Wire Tension
por: Lagouri, T
Publicado: (1998)

Minimum tension requirement for Charpak chamber wires
por: Trippe, T G
Publicado: (1969)

Dependence of Drift Tube Performance on the Anode Wire Diameter
por: Deile, M, et al.
Publicado: (2000)

A new compact MTD wire tension meter
por: Fassouliotis, D, et al.
Publicado: (2001)

Vibration of signal wires in wire detectors under irradiation
por: Boyko, I, et al.
Publicado: (1995)

Anode wire in cylindrical cathode tube : destabilizing electrostatic force
por: Wertelaers, P
Publicado: (2017)

Anode wire ageing in proportional counters: the problem of analog response
por: Algeri, A, et al.
Publicado: (1993)

Electrical tension-measurement in a multi-wire drift chamber for double $\beta$ decay experiments
por: Ohama, T, et al.
Publicado: (1998)

A method for determining drift cell wire tensions using conventional front-end electronics
por: Dougherty, W M, et al.
Publicado: (1994)

A computer-aided system for MWPC wire tension control
por: Calvetti, M, et al.
Publicado: (1980)

The Micro Wire Detector
por: Adeva, B., et al.
Publicado: (1999)

Vibration of Signal Wires in Wire Detectors under Irradiation
por: Boyko, IR, et al.
Publicado: (1995)

The wire tension and pitch measurement of the cathode strip chamber of CMS The CMS is stated for Compact Muon System
por: Jiang Chun Hua, et al.
Publicado: (2002)

Installation and operation of the LHCb Silicon Tracker detector
por: Esperante, D, et al.
Publicado: (2009)

Where to Install the I224 Detector
por: Gatignon, L
Publicado: (2001)

Wire Tension Meter for the Production of the LHCb Outer Tracker - Commissioning and Calibration
por: Vankov, P, et al.
Publicado: (2004)

Installation of C4F10 Cherenkov detectors
por: Brekhovskikh, V, et al.
Publicado: (2008)

An automatic system for controlling the quality of straws installed in the ATLAS TRT detector
por: Golunov, A O, et al.
Publicado: (2004)

Determination of the anode wire position by visible light in a new type straw for NA62 experiment tracker
por: Glonti, L, et al.
Publicado: (2016)

Documentation for the Installed Hardware of the ALEPH Minivertex Detector
por: Schwarz, A
Publicado: (1990)

The installation of the L3 silicon microvertex detector
por: CERN. Geneva. Audiovisual Unit
Publicado: (1993)

Integration and installation of the CMS pixel barrel detector
por: Kastli, Hans-Christian
Publicado: (2008)

Post-installation status of the ATLAS pixel detector
por: García-Sciveres, M
Publicado: (2008)

Advances in stretched and oscillating-wire methods for magnetic measurement
por: Arpaia, P, et al.
Publicado: (2016)

Development of Micromegas detectors with resistive anode pads
por: Chefdeville, M, et al.
Publicado: (2021)

ALICE Forward Multiplicity Detector: From Design to Installation
por: Holm Christensen, Christian
Publicado: (2007)

Memorandum: timetable for construction and installation of UA1 detector
por: CERN. Geneva. SPS Experiments Committee
Publicado: (1978)

Installation and running-in of the elastic scattering detector in I6
por: Rubbia, Carlo
Publicado: (1970)

Proposal to Use Resistive Wires as Measuring Elements for Linear Displacement Monitoring of ATLAS Detectors
por: Denisov, A, et al.
Publicado: (1995)

Proportional chambers for a 50000-wire detector
por: Bouclier, Roger, et al.
Publicado: (1974)

Evaluation of the multi anode photomultiplier for the LHCb RICH detectors
por: Bibby, J, et al.
Publicado: (1998)

Cannot write session to /tmp/vufind_sessions/sess_cduanmke05rvaja70eoe82cpkh