Cargando…

Assembly of the front of a cold mass magnet LHC

Detalles Bibliográficos
Autor principal:	Patrice Loiez
Lenguaje:	ENG
Publicado:	1997
Materias:	Accelerators
Acceso en línea:	http://cds.cern.ch/record/40745

Ejemplares similares

LHC beam dump shielding blocks made from recuperated ISR dipole magnets filled with cement
por: Patrice Loiez
Publicado: (1997)

Macro view of a section through an MBSMS coil - LHC development
por: Laurent Guiraud, et al.
Publicado: (1996)

Beam screens for the LHC beam pipes
por: Patrice Loïez, et al.
Publicado: (1997)

LHC magnet assembly: coil installation
por: Cedric Bregnard
Publicado: (1996)

LHC Magnet (dipole) during assembly in hall 181. LHC magnet connections
por: Laurent Guiraud
Publicado: (1997)

Fitting super-insulation on the Noell 1 cold mass LHC
por: Laurent Guiraud
Publicado: (1996)

DIRAC detector experiment: the vacuum chamber (blue), beginning of the flat chamber (yellow), magnetic screen (orange) in front of the magnet. The vacuum tube for the primary proton beam is below (sil ver color)
por: Patrice Loïez
Publicado: (1999)

Influence of geometrical parameters on the flexural rigidity of the LHC dipole cold mass assembly
por: Bajko, M, et al.
Publicado: (2002)

Supporting System for the LHC Cold Mass
por: Mathieu, M, et al.
Publicado: (1997)

Metrology of the LHC Dipole Cold Masses
por: Bajkó, M, et al.
Publicado: (2002)

LHC magnets: cold tests & throughput
por: Chohan, V
Publicado: (2005)

Procedure for the Award of the Contracts for the Assembly of the Cold Masses of the Main Dipole Magnets of the LHC Machine
Publicado: (1997)

Quality Control of the LHC Main Dipole Cold Mass through Magnetic Measurements at Room Temperature
por: Todesco, Ezio, et al.
Publicado: (2003)

The LHC Pre-series Dipole Cold Mass Geometry
por: Bajko, M, et al.
Publicado: (2004)

Status of the Cold Mass of the Short Straight Section for the LHC
por: Rifflet, J M, et al.
Publicado: (1998)

Technical specification for the supply of 1158 cold masses of the superconductig dipole magnets for the LHC collider, 1 pt.
por: CERN. Geneva. LHC Project
Publicado: (2001)

Technical specification for the supply of 1158 cold masses of the superconductig dipole magnets for the LHC collider, 2 pt.
por: CERN. Geneva. LHC Project
Publicado: (2001)

Accordion detector for an LHC experiment
por: Patrice Loiez
Publicado: (1990)

HL-LHC magnets and cold masses in building 180
por: Garcia Obrero, Irene
Publicado: (2022)

Study of Short Straight Section Cold Mass Assembly Principles
por: Gagné, M, et al.
Publicado: (1996)

Hydraulic Validation of the LHC Cold Mass Heat Exchanger Tube
por: Provenaz, P
Publicado: (1998)

Warm-Cold Magnetic Field Correlation in the LHC Main Dipoles
por: Bottura, L, et al.
Publicado: (2003)

Magnetic Length of LHC Prototype Dipoles in Warm and Cold Conditions
por: Bottura, L, et al.
Publicado: (1998)

Transfer line quadrupole for SPS-LHC tunnel from Novosibirsk
por: Patrice Loiez
Publicado: (1999)

Industrialization of LHC main quadrupole cold masses up to series production
por: Burgmer, R, et al.
Publicado: (2004)

Control of the Dipole Cold Mass Geometry at CERN to Optimize LHC Performance
por: Wildner, E, et al.
Publicado: (2006)

Shielding of the LHC correcting magnets
por: Laurent Guiraud
Publicado: (1996)

Contact Resistances in the Cold Bypass Diode Leads of the Main LHC Magnets
por: Roger, V, et al.
Publicado: (2014)

Appointment of External Legal Counsel for the Preparation of Contract Documents for the Assembly of the Cold Masses of the Superconducting Main Dipole Magnets for the LHC
Publicado: (1997)

The LHC SSS cold mass inside the cryostat. The complexity of the bus-bars for the power supply of the magnets and cryogenic links can be seen. The two apertures in the centre will house the beam lines
Publicado: (2003)

Impact of Magnetic Permeability of the Collars and Warm-cold Correlations on Magnetic Field in the LHC Main Quadrupoles
por: Hagen, P, et al.
Publicado: (2006)

Magnetic Measurement Systems for the LHC Dipole Assembly Companies
por: Billan, J, et al.
Publicado: (2004)

Magnetic Measurement Systems for the LHC Dipole Assembly Firms
por: Reymond, Hubert, et al.
Publicado: (2004)

Dipole cold mass assembly
por: Modena, A
Publicado: (2004)

Optical In-Situ Measurement of Relative Deformations of the LHC Main Dipole Cold Masses
por: Aznar, S, et al.
Publicado: (2002)

Proposal for the award of a contract for the assembly of MQ-DS type cold masses for the LHC
Publicado: (2003)

Construction and Cold Test of the First Superferric Corrector Magnet for the LHC Luminosity Upgrade
por: Statera, Marco, et al.
Publicado: (2017)

Technical specification for the supply of cold bore tubes for LHC dipole magnet prototypes
por: Main Magnets and Superconductors Group (LHC-MMS)
Publicado: (1998)

Warm and Cold Magnetic and Mechanical Alignment Tests of LHC Short Straight Sections
por: Buzio, M, et al.
Publicado: (2006)

Users Guide to the ORACLE Magnet Database For the Components and the Assembly of the LHC Main Magnets
por: Gigliarelli-Fiumi, P, et al.
Publicado: (1996)

Cannot write session to /tmp/vufind_sessions/sess_r47comm6ub08l7rq00s3q22n8d