Cargando…
An Endcap Muon CSC with a prototype cooling plate mounted on the chamber frame. Visible are the aluminum cover supports that mount between the cathode front-end boards.
EMU CSC copper cooling plate mounted on chamber, no electronics installed.
Autor principal: | Sergei Lusin |
---|---|
Publicado: |
2000
|
Materias: | |
Acceso en línea: | http://cds.cern.ch/record/42025 |
Ejemplares similares
-
An ME234/2 EMU chamber with a laminated prototype cooling plate mounted. Dummy cathode boards and cathode board covers are installed.
por: Sergei Lusin
Publicado: (2000) -
An ME234/2 EMU chamber with a prototype copper cooling plate mounted on frame. Cooling plate is fully instrumented with cathode front-end boards, ALCT and low-voltage distribution board. All cable harnesses and strain reliefs are in place.
por: Sergei Lusin
Publicado: (2000) -
First test of mounting a CSC on YE-2
por: Walter van Doninck
Publicado: (2001) -
Completion of cathode strip chamber (CSC) installation on the "plus" endcap of CMS
por: Richard Breedon, UC Davis
Publicado: (2006) -
Pictures showing the test of CSC installation fixture. The CSC is fully balanced and free to rotate to any angle. After CSC is attached to mounts, fixture is rebalanced and removed. Electrical limits stops are set at with or without chamber balance points.
por: Farshid Feyzi, et al.
Publicado: (2001)