Cargando…

Endcap Yoke, survey at assembly and final measurement with photogrammetry at CERN SX5

Endcap Yoke, survey at assembly and final measurement with photogrammetry at CERN SX5

Detalles Bibliográficos
Autor principal:	C. Humbertclaude and R. Goudard
Publicado:	2001
Materias:	Metrology of experiments
Acceso en línea:	http://cds.cern.ch/record/42526

Ejemplares similares

YOKE ENDCAP YE+2 and YE-2, measurements of the posts by photogrammetry
por: J.F.FUCHS, et al.
Publicado: (2003)

HADRON CALORIMETER ENDCAP HE-1, measurements by photogrammetry
por: J.F.FUCHS, R.Goudard
Publicado: (2003)

Measurement of the cylindricity of the CMS Inner Vactank before the insersion test - SX5 hall - Feb. 02
por: Raphael GOUDARD, et al.
Publicado: (2002)

CMS - HF ASSEMBLY TEST - SURVEY MEASUREMENTS
por: Raphael GOUDARD, et al.
Publicado: (2002)

HADRON CALORIMETER HB+1 measurements by photogrammetry
por: J.F.FUCHS, R.Goudard
Publicado: (2003)

CMS HB+1 FULLY ASSEMBLED AT FELGUERA (S)
por: Raphael Goudard, Celine Humbertclaude, Dirk Mergelkuhl
Publicado: (2001)

CMS - VACTANK CYLINDRICITY
por: Raphael GOUDARD, et al.
Publicado: (2002)

SET-UP OF THE FERRIS WHEEL SUPPORTING THE CMS SWIVELLING PLATFORM - Levelling and alignment of both axis - March 2002
por: Raphael GOUDARD, et al.
Publicado: (2002)

Re-montage of the first HB barrel CMS in SX. September 2001. Note the survey network around the cradle.
por: C.Lasseur
Publicado: (2001)

Control of the CMS coil swiveling platform - August 2001 - South Korea
por: C.Humbertclaude/C.Lasseur
Publicado: (2001)

Assembly of Endcap started at SX5
por: Farshid Feyzi
Publicado: (2001)

Panoramic view of the CMS assembly hall - May 2001.
por: C.Lasseur
Publicado: (2001)

ATLAS - Liquid Argon Barrel LArg at CERN - August 2001
por: Christian LASSEUR
Publicado: (2001)

CAST (CERN Axion Solar Telescope) Experiment - During first test of vertical motion - 2002
por: ?
Publicado: (2002)

Ring Coils on the Endcap Yoke of a CLIC Detector
por: Gerwig, H, et al.
Publicado: (2011)

ATLAS - Sub components of the Hybrid Vessel for the ECT
por: Dirk Mergelkuhl
Publicado: (2001)

General view from HARP—PS214 experiment in the 157 hall.
por: André FROTON
Publicado: (2001)

General view downstream from Compass - NA58 experiment in the 888 hall
por: André FROTON
Publicado: (2001)

COMPASS - RICH - Alignment of the Mirrors
por: Jean-Christophe GAYDE
Publicado: (2001)

Atlas - Test alignment end cap (DATCHA) - H8 beam test
por: Jean-Frederic FUCHS
Publicado: (2001)

Magnetic measurement bench
por: PhotoLab
Publicado: (1984)

Distinvar on a SPS quadrupole. Distance measurement in the geodetic network.
por: PhotoLab
Publicado: (1975)

SPS jacks, clinometer "mille pattes" studied to measure the SPS quadrupoles twist.
por: PhotoLab
Publicado: (1975)

Measure by photogrammetry of outer vactank cylindricity after adjunction of the reinforcement rings.
por: Céline Humbertclaude
Publicado: (2001)

CMS RPC detectors assembled in Pakistan installed on the backside of the YE+1 endcap yoke
por: Walter Van Doninck, VUB-Brussels and CERN
Publicado: (2006)

Installation of a dipole in String 2
por: Laurent Guiraud
Publicado: (2001)

Alignment of a SPS girder by A. Froton
por: PhotoLab
Publicado: (1974)

Fiducialisation tools : old techniques
por: Dominique Missiaen, et al.
Publicado: (2002)

Fiducialisation tools and techniques
por: Dominique Missiaen, et al.
Publicado: (2002)

Photogrammetry of a CMS endcap and part of the hadronic calorimeter. The structure was covered by targets photographed by the numerical cameras
Publicado: (2003)

A group from Moscow and Minsk, helped by the team of CMS SX5 hall and crane drivers from DBS, is assembling the first Hadronic endcap calorimeter in SX5.
por: Service de Presse
Publicado: (2002)

CERN survey team at KHI for photogrammetry of magnetic endcaps.Raphaël Goudard (CERN), Farshid Feyzi (from PSL) and Céline Humbertclaude (CERN) with KHI engineers.
por: R. Loveless/U. of Wisconsin
Publicado: (2000)

Assembly of Ferryswheel in SX5 ,Pt.5.
por: Pascal Petiot
Publicado: (2000)

Start of Final Assembly of the CMS Barrel Yoke on schedule at P5 the 1st august, 2000. I
por: Hubert Gerwig, CERN/ EP-CMI
Publicado: (2000)

SC magnet : lower yoke assembly
por: CERN PhotoLab
Publicado: (1956)

Assembly of YE-2 finished at SX5
por: Dick Loveless, et al.
Publicado: (2001)

Delivery and assembly of the 80 T cranes in SX5
por: L. Veillet
Publicado: (2000)

Rapid Assessment of Neutralizing Antibodies Using Influenza Viruses with a Luciferase Reporter
por: Sergeeva, M. V., et al.
Publicado: (2022)

Actual status of the magnet assembly in SX5 hall
por: P.Petiot
Publicado: (2001)

Evaluation of Streched Wire Measurement Based on Photogrammetry in the Context of CERN
por: Behrens, A, et al.
Publicado: (2016)

Cannot write session to /tmp/vufind_sessions/sess_3k73h3ldjnk31nads0i2a0is43