Cargando…

Progress on the conductor for the superconducting toroids of the ATLAS experiment

Detalles Bibliográficos
Autores principales:	Rossi, L, Volpini, G, Berriaud, C, Horváth, I L, Neuenschwander, J
Lenguaje:	eng
Publicado:	1999
Materias:	Detectors and Experimental Techniques
Acceso en línea:	http://cds.cern.ch/record/428397

Ejemplares similares

Development of an aluminium stabilised reinforced superconducting conductor
por: Fritz, D, et al.
Publicado: (1996)

Theoretical and Experimental Investigation of the Ramp Losses in Conductor and Coil Casing of the ATLAS Barrel Toroid Coils
por: Rabbers, J J, et al.
Publicado: (2006)

The protection system of the superconducting coils in the Barrel Toroid of ATLAS
por: Acerbi, E, et al.
Publicado: (1999)

Production and qualification of the 60-kA, aluminum-stabilized conductor for the ATLAS B0 coil
por: Rossi, L, et al.
Publicado: (1999)

Manufacturing and integration progress of the ATLAS barrel toroid magnet at CERN
por: Védrine, P, et al.
Publicado: (2004)

Progress in the design of a superconducting toroidal magnet for the ALAS detector on LHC
por: Baze, J M, et al.
Publicado: (1996)

A new approach for the protection system of the superconducting coils in the Barrel Toroid of ATLAS
por: Acerbi, E, et al.
Publicado: (1998)

ATLAS superconducting toroids and solenoid
por: ten Kate, H H J
Publicado: (2005)

Progress in the construction of the B0 model of the ATLAS Barrel Toroid magnet
por: Acerbi, E, et al.
Publicado: (2000)

Quench modeling of the ATLAS superconducting toroids
por: Gavrilin, A V, et al.
Publicado: (2001)

The superconducting strand for the CMS solenoid conductor
por: Curé, B, et al.
Publicado: (2002)

ATLAS Superconducting Toroids: The Largest Ever Built
por: ten Kate, Herman H J
Publicado: (2010)

ATLAS barrel superconducting toroid: conceptual design
por: Desportes, H, et al.
Publicado: (1992)

Repair of the ATLAS conductor by a junction
por: Acerbi, E, et al.
Publicado: (1998)

On-Surface Test of the ATLAS Barrel Toroid Coils: Overview
por: Dudarev, A, et al.
Publicado: (2006)

Engineering status of the superconducting end cap toroid magnets for the ATLAS experiment at LHC
por: Baynham, D Elwyn, et al.
Publicado: (2000)

Mechanical Commissioning of the ATLAS Barrel Toroid Magnet
por: Foussat, A, et al.
Publicado: (2008)

Completion of the Manufacturing of the ATLAS Barrel Toroid Magnet at CERN
por: Védrine, P, et al.
Publicado: (2006)

Analysis of the discharge of the ATLAS barrel toroid and end cap toroids with different configurations of the protection circuit
por: Acerbi, E, et al.
Publicado: (2001)

Synthesis of technological developments for the $B0$ model coil and the ATLAS barrel toroid coils
por: Acerbi, E, et al.
Publicado: (1999)

Production and qualification of 40 km of Al-stabilized NbTi cable for the ATLAS experiment at CERN
por: Baccaglioni, G, et al.
Publicado: (2002)

Engineering design optimisation of the superconducting end cap toroid magnets for the ATLAS experiment at LHC
por: Baynham, D Elwyn, et al.
Publicado: (1999)

Experimental characterization of resistive joints for use inside ATLAS toroids
por: Volpini, G, et al.
Publicado: (2001)

Electro-mechanical behavior of the ATLAS toroids in fault condition
por: Foussat, A, et al.
Publicado: (2004)

The CMS conductor
por: Blau, Bertrand, et al.
Publicado: (2002)

A possible geometry for joints inside windings for ATLAS Barrel Toroid
por: Acerbi, E, et al.
Publicado: (1998)

Fast Dump of the ATLAS Toroids
por: Dudarev, A, et al.
Publicado: (2010)

Thermal and electrical behaviour of a resistive junction in the ATLAS toroids
por: Acerbi, E, et al.
Publicado: (1997)

The CMS conductor
por: Horváth, I L, et al.
Publicado: (2000)

Industrial Controls for the Test Setup of the ATLAS Barrel Toroid Superconducting Magnets
por: Sicard, Claude Henri
Publicado: (1999)

20.5 kA current leads for ATLAS Barrel Toroid superconducting magnets
por: Dudarev, A, et al.
Publicado: (2002)

Experimental Area and Installation for the ATLAS Detector Superconducting Air Core Toroid option
por: Hatch, M, et al.
Publicado: (1993)

Some characteristics of the superconducting magnetic system of toroidal spectrometer STORS
por: Andreev, S V, et al.
Publicado: (1994)

ATLAS B0 toroid model coil test at CERN
por: Miele, P, et al.
Publicado: (2002)

First full-size ATLAS barrel toroid coil successfully tested up to 22 kA at 4 T
por: Dudarev, A, et al.
Publicado: (2005)

Superconducting dipole with internal conductor cooling
por: CERN. Geneva. Super Proton Synchrotron Division (SPS)
Publicado: (1974)

Transient behaviour of a resistive joint in the ATLAS toroids during the magnet ramp-up and discharge
por: Volpini, G, et al.
Publicado: (2000)

The Superconducting Toroid for the New International AXion Observatory (IAXO)
por: Shilon, I., et al.
Publicado: (2013)

Continuous EB welding of the reinforcement of the CMS conductor
por: Tavares, S S, et al.
Publicado: (2002)

Bond and electron beam welding quality control of the aluminum stabilized and reinforced CMS conductor by means of ultrasonic phased-array technology
por: Neuenschwander, J, et al.
Publicado: (2002)

Cannot write session to /tmp/vufind_sessions/sess_o08ccss9ab9ffn3bhemb8mnffl