Cargando…

Endcap Muon Low Voltage Power Supply Prototype

Low voltage power supply for endcap muon chambers using transformers. Input power 3-phase from MG set. DC output power for analog and digital.

Detalles Bibliográficos
Autor principal:	Farshid Feyzi
Lenguaje:	ENG
Publicado:	2002
Materias:	Muon Detector
Acceso en línea:	http://cds.cern.ch/record/42990

Ejemplares similares

Installation of muon chambers on endcap
por: Farshid Feyzi
Publicado: (2004)

Installation of Endcap Muon Chambers
por: Dan Wenman
Publicado: (2003)

Instalation of first endcap Muons station on YE+1
Publicado: (2005)

Installation of Muon Endcap Station 1 on YE+1
Publicado: (2005)

An Endcap Muon CSC with a prototype cooling plate mounted on the chamber frame. Visible are the aluminum cover supports that mount between the cathode front-end boards.
por: Sergei Lusin
Publicado: (2000)

Installation of ME1/1 Dubna chambers on the endcap disk YE-1
Publicado: (2005)

Pictures showing the test of CSC installation fixture. The CSC is fully balanced and free to rotate to any angle. After CSC is attached to mounts, fixture is rebalanced and removed. Electrical limits stops are set at with or without chamber balance points.
por: Farshid Feyzi, et al.
Publicado: (2001)

CSC installation fixture finished
por: Farshid Feyzi, et al.
Publicado: (2001)

Early Construction: Muon Chambers
por: Hoch, Michael
Publicado: (2007)

First Cosmic muon seen in four barrel muon stations at point 5 on 13 December 2005
por: Gianni Masetti
Publicado: (2005)

MWPC cathode plane. Prototype built in Oct 2000
por: Schneider, T
Publicado: (2000)

Lowering of the YE+3 endcap disc on 30th November
por: Max Brice, CERN
Publicado: (2006)

Last Muon DT SuperLayer glued in Legnaro
por: Paolo Checchia
Publicado: (2005)

MWPC prototype built in Oct 2000
por: Schneider, T
Publicado: (2000)

CMS RPC detectors assembled in Pakistan installed on the backside of the YE+1 endcap yoke
por: Walter Van Doninck, VUB-Brussels and CERN
Publicado: (2006)

Preparation for gluing of Carbon prototype MAB at INEGI, Porto
por: Miguel Moreira, Porto, INEGI, et al.
Publicado: (2001)

Installation of Barrel Muon stations (DTs and RPCs) in the two mobile wheels YB+1 and YB+2 is complete.
Publicado: (2005)

Muon Workshop
por: Pierluigi, Paolucci
Publicado: (2012)

An ME234/2 EMU chamber with a prototype copper cooling plate mounted on frame. Cooling plate is fully instrumented with cathode front-end boards, ALCT and low-voltage distribution board. All cable harnesses and strain reliefs are in place.
por: Sergei Lusin
Publicado: (2000)

MAB Prototype ready to be glued at INEGI
por: Hubert Gerwig
Publicado: (2001)

CMS Technology Transfer: Cosmic Muon Tomography
por: Checchia, Paolo
Publicado: (2017)

Images of CMS Muons - Drift Tubes (DT)
por: Puerta-Pelayo, J, et al.
Publicado: (2008)

Work on CMS Muon Detector during LS1
por: Jay, Hauser
Publicado: (2014)

Images of the CMS Muons - Cathode Strip Chambers (CSC)
por: Breedon, R, et al.
Publicado: (2008)

Images of CMS MUONs - Resistive Plate Chambers (RPC)
por: Puerta-Pelayo, J
Publicado: (2008)

Open Days 2019 - CMS Muon Group exhibit
por: Puerta Pelayo, Jesus, et al.
Publicado: (2019)

Work on CMS Muon Detector (CSCs) during Long Shutdown 1
por: Lapka, Marzena
Publicado: (2015)

Installation of last DT+RPC packages for the muon barrel detector of CMS
por: Jesus Puerta-Pelayo
Publicado: (2007)

Work on CMS Muon Detector (CSCs) during Long Shutdown 1 (LS1)
por: Hoch, Michael
Publicado: (2014)

Work on CMS Muon Detector (CSCs) during Long Shutdown 1 (LS1)
por: Heilman, Jesse
Publicado: (2014)

First test of a CMS DT chamber equipped with full electronics in a muon beam
por: Jesus Puerta-Pelayo
Publicado: (2003)

Work on CMS Muon Detector (RPC) during Long Shutdown 1 (LS1) - building 904, Prevessin
por: Dong Hyun, Kim
Publicado: (2015)

An ME234/2 EMU chamber with a laminated prototype cooling plate mounted. Dummy cathode boards and cathode board covers are installed.
por: Sergei Lusin
Publicado: (2000)

Work on CMS Muon Detector (CSCs) during Long Shutdown 1 (LS1) - Operation Support Centre SX5
por: Hausner, Jay
Publicado: (2013)

Work on CMS Muon Detector (RPC) during Long Shutdown 1 (LS1) - Point 5, Cessy, CMS cavern
por: Saleh, Muhammad
Publicado: (2015)

Work on CMS Muon Detector (RPC) during Long Shutdown 1 (LS1) - Point 5, Cessy, CMS cavern
por: Pedraza, Isabel
Publicado: (2013)

Work on CMS Muon Detector (RPC) during Long Shutdown 1 (LS1) - Point 5, Cessy, CMS cavern
por: Dong Hyun, Kim
Publicado: (2015)

Work on CMS Muon Detector (RPC) during Long Shutdown 1 (LS1) - Point 5, Cessy, CMS cavern
por: Maria Isabel, Pedraza Morales
Publicado: (2015)

Work on CMS Muon Detector (RPC) during Long Shutdown 1 (LS1) - Point 5, Cessy, CMS cavern
por: Verwilligen, Piet
Publicado: (2014)

Work on CMS Muon Detector (CSCs) during Long Shutdown 1 (LS1) - Point 5, Cessy, underground cavern
por: Hoch, Michael
Publicado: (2014)

Cannot write session to /tmp/vufind_sessions/sess_9t10vk6ga8d5idvtnqnnvdt3n6