Cargando…

Test installation of MB1

Cradle has been tested to insert MB1s.

Detalles Bibliográficos
Autor principal:	Alberto Benvenuti
Lenguaje:	ENG
Publicado:	2002
Materias:	Muon Detector
Acceso en línea:	http://cds.cern.ch/record/43579

Ejemplares similares

Test insertion of MB3
por: Alberto Benvenuti
Publicado: (2002)

Installation of Muon Endcap Station 1 on YE+1
Publicado: (2005)

Lifting tools & MB4 rail
por: Lucien Veillet
Publicado: (2002)

First trial of MB insertion tooling.
por: L. Veillet
Publicado: (2002)

Installation of ME1/1 Support Disk on HE-1
por: Lucien Veillet
Publicado: (2002)

Instalation of first endcap Muons station on YE+1
Publicado: (2005)

Installation of Endcap Muon Chambers
por: Dan Wenman
Publicado: (2003)

Installation of muon chambers on endcap
por: Farshid Feyzi
Publicado: (2004)

Installation of ME1/2 + RE1/2 packages on YE+1
Publicado: (2005)

Installation of ME1/1 Dubna chambers on the endcap disk YE-1
Publicado: (2005)

Post for CSC installed on YE-2
por: Dan Wenman
Publicado: (2003)

CSC installation fixture finished
por: Farshid Feyzi, et al.
Publicado: (2001)

Installation of Barrel Muon stations (DTs and RPCs) in the two mobile wheels YB+1 and YB+2 is complete.
Publicado: (2005)

First CMS Gas Electron Multipliers (GEMs) installation
por: Lapka, Marzena
Publicado: (2019)

Installation of some Cathode Strip Chambers on March 2004
por: Richard Breedon
Publicado: (2004)

CMS RPC detectors assembled in Pakistan installed on the backside of the YE+1 endcap yoke
por: Walter Van Doninck, VUB-Brussels and CERN
Publicado: (2006)

A view of YE+1 after the installation of the first layer of RE1/3 RPC chambers.
Publicado: (2006)

Installation of last DT+RPC packages for the muon barrel detector of CMS
por: Jesus Puerta-Pelayo
Publicado: (2007)

Pictures showing the test of CSC installation fixture. The CSC is fully balanced and free to rotate to any angle. After CSC is attached to mounts, fixture is rebalanced and removed. Electrical limits stops are set at with or without chamber balance points.
por: Farshid Feyzi, et al.
Publicado: (2001)

An ME234/2 EMU chamber with a laminated prototype cooling plate mounted. Dummy cathode boards and cathode board covers are installed.
por: Sergei Lusin
Publicado: (2000)

ALICE Dimuon: Installing the station 5 tracking chamber in the test beam area.
por: Cicalo, C.
Publicado: (2004)

First tests of DT insertion in SX5.
por: Massimo Benettoni
Publicado: (2002)

Installation of station 1 of the tracking chambers of the ALICE Muon Spectrometer
por: Suire, Christophe
Publicado: (2007)

Arrival at CERN of the first MB4 DT chambers from Turin
por: Marcos Fernandez Garcia
Publicado: (2005)

Completion of installation of DT and RPC chambers before Cosmic Challenge
por: Mimmo Dattola
Publicado: (2006)

First installation of DT and RPC packages into the CMS iron yoke
por: Jesus Puerta-Pelayo
Publicado: (2004)

Endcap Muon Low Voltage Power Supply Prototype
por: Farshid Feyzi
Publicado: (2002)

Installation of the front-end electronics of the muon spectrometer tigger chambers
por: Saba, A
Publicado: (2006)

Installation of the front-end electronics of the muon spectrometer tigger chambers
por: Saba, A.
Publicado: (2006)

Completion of cathode strip chamber (CSC) installation on the "plus" endcap of CMS
por: Richard Breedon, UC Davis
Publicado: (2006)

First DT+RPC chambers installation round in the UX5 cavern
por: Jesus Puerta-Pelayo
Publicado: (2007)

First test of mounting a CSC on YE-2
por: Walter van Doninck
Publicado: (2001)

MWPC cathode plane. Prototype built in Oct 2000
por: Schneider, T
Publicado: (2000)

First test of a CMS DT chamber equipped with full electronics in a muon beam
por: Jesus Puerta-Pelayo
Publicado: (2003)

Installation of the first Cathode Strip Chambers (CSC) of CMS at P5 (Cessy, France) on June 2003
Publicado: (2003)

Completion of cathode strip chamber (CSC) installation on the so-called YE+2 wheel of CMS on March 2005.
por: Tejinder S. Virdee
Publicado: (2005)

Last Muon DT SuperLayer glued in Legnaro
por: Paolo Checchia
Publicado: (2005)

First Cosmic muon seen in four barrel muon stations at point 5 on 13 December 2005
por: Gianni Masetti
Publicado: (2005)

Early Construction: Muon Chambers
por: Hoch, Michael
Publicado: (2007)

CMS GE1/1 chambers at Prevessin lab
por: Starling, Elizabeth Rose
Publicado: (2019)

Cannot write session to /tmp/vufind_sessions/sess_691bepn9n5bemv12t5mhqet0fn