Cargando…

Quench propagation and protection analysis of the ATLAS Toroids

The ATLAS superconducting magnet system consists of the Barrel Toroid, two End Cap Toroids and the Central Solenoid. However, the Toroids of eight coils each are magnetically separate systems to the Central Solenoid. The Toroids are electrically connected in series and energized by a single power su...

Descripción completa

Detalles Bibliográficos
Autores principales:	Dudarev, A, Gavrilin, A V, ten Kate, H H J, Baynham, D Elwyn, Courthold, M J D, Lesmond, C
Lenguaje:	eng
Publicado:	2000
Materias:	Detectors and Experimental Techniques
Acceso en línea:	https://dx.doi.org/10.1109/77.828249 http://cds.cern.ch/record/438922

Ejemplares similares

Quench propagation and detection in the superconducting bus-bars of the ATLAS magnets
por: Dudarev, A, et al.
Publicado: (2000)

Quench modeling of the ATLAS superconducting toroids
por: Gavrilin, A V, et al.
Publicado: (2001)

Study of Heater Efficiency in the ATLAS Barrel Toroid Magnet
por: Gastineau, B, et al.
Publicado: (1998)

ATLAS End Cap Toroid Integration and Test
por: Baynham, D E, et al.
Publicado: (2007)

Engineering design optimisation of the superconducting end cap toroid magnets for the ATLAS experiment at LHC
por: Baynham, D Elwyn, et al.
Publicado: (1999)

ATLAS End Cap Toroid Cold Mass and Cryostat Integration
por: Baynham, D E, et al.
Publicado: (2006)

Engineering status of the superconducting end cap toroid magnets for the ATLAS experiment at LHC
por: Baynham, D Elwyn, et al.
Publicado: (2000)

The protection system of the superconducting coils in the Barrel Toroid of ATLAS
por: Acerbi, E, et al.
Publicado: (1999)

Stability and quench propagation velocities measurements on the "Racetrack" Mock-up of ATLAS toroid coil
por: Juster, F P, et al.
Publicado: (1999)

Fast Dump of the ATLAS Toroids
por: Dudarev, A, et al.
Publicado: (2010)

ATLAS superconducting toroids and solenoid
por: ten Kate, H H J
Publicado: (2005)

Mechanical Commissioning of the ATLAS Barrel Toroid Magnet
por: Foussat, A, et al.
Publicado: (2008)

Commissioning Test of ATLAS End-Cap Toroidal Magnets
por: Dudarev, A, et al.
Publicado: (2009)

Electro-mechanical behavior of the ATLAS toroids in fault condition
por: Foussat, A, et al.
Publicado: (2004)

End Cap Toroid Design Report
por: Baynham, D Elwyn, et al.
Publicado: (1992)

ATLAS barrel superconducting toroid: conceptual design
por: Desportes, H, et al.
Publicado: (1992)

Design of the supercondcting end cap toroids for the ATLAS experiment at LHC
por: Baynham, D Elwyn, et al.
Publicado: (1996)

ATLAS End Cap Toroid Magnets cold mass design and manufacturing status
por: Baynham, D Elwyn, et al.
Publicado: (2004)

ATLAS Superconducting Toroids: The Largest Ever Built
por: ten Kate, Herman H J
Publicado: (2010)

ATLAS end cap toroid magnets cryostat design, manufacture and integration at CERN
por: Baynham, D Elwyn, et al.
Publicado: (2004)

Theoretical and Experimental Investigation of the Ramp Losses in Conductor and Coil Casing of the ATLAS Barrel Toroid Coils
por: Rabbers, J J, et al.
Publicado: (2006)

The Proximity Cryogenic System for the ATLAS Toroidal Magnets
por: Baynham, D Elwyn, et al.
Publicado: (2001)

Quench protection and safety of the ATLAS central solenoid
por: Makida, Y, et al.
Publicado: (2002)

The normal zone propagation in ATLAS B00 model coil
por: Boxman, E W, et al.
Publicado: (2002)

The Superconducting Toroid for the New International AXion Observatory (IAXO)
por: Shilon, I., et al.
Publicado: (2013)

An estimation of the quench pressure rise in the ATLAS barrel toroid cooling channels
por: Elkonin, B
Publicado: (2000)

Manufacturing and integration progress of the ATLAS barrel toroid magnet at CERN
por: Védrine, P, et al.
Publicado: (2004)

ATLAS B0 toroid model coil test at CERN
por: Miele, P, et al.
Publicado: (2002)

Completion of the Manufacturing of the ATLAS Barrel Toroid Magnet at CERN
por: Védrine, P, et al.
Publicado: (2006)

On-Surface Test of the ATLAS Barrel Toroid Coils: Overview
por: Dudarev, A, et al.
Publicado: (2006)

Cold Mass Integration of the ATLAS Barrel Toroid Magnets at CERN
por: Rey, J M, et al.
Publicado: (2006)

New Superconducting Toroidal Magnet System for IAXO, the International AXion Observatory
por: Shilon, I., et al.
Publicado: (2013)

The ATLAS magnet test facility at CERN
por: Miele, P, et al.
Publicado: (2000)

Quench evolution and hot spot temperature in the ATLAS B0 model coil
por: Dudarev, A, et al.
Publicado: (2004)

Assembly Concept and Technology of the ATLAS Barrel Toroid
por: Foussat, A, et al.
Publicado: (2006)

Conceptual Design of a New Large Superconducting Toroid for IAXO, the New International AXion Observatory
por: Shilon, I., et al.
Publicado: (2012)

20.5 kA current leads for ATLAS Barrel Toroid superconducting magnets
por: Dudarev, A, et al.
Publicado: (2002)

Current diffusion and normal zone propagation inside the aluminum stabilized superconductor of ATLAS model coil
por: Boxman, E W, et al.
Publicado: (2003)

Synthesis of technological developments for the $B0$ model coil and the ATLAS barrel toroid coils
por: Acerbi, E, et al.
Publicado: (1999)

Analysis of the discharge of the ATLAS barrel toroid and end cap toroids with different configurations of the protection circuit
por: Acerbi, E, et al.
Publicado: (2001)

Cannot write session to /tmp/vufind_sessions/sess_f489lr8mahg0derqkitgscul6q