Cargando…

Some Features of Superconducting Dual Bore Lens

Detalles Bibliográficos
Autor principal:	Mikhailichenko, A A
Lenguaje:	eng
Publicado:	1999
Materias:	Accelerators and Storage Rings
Acceso en línea:	http://cds.cern.ch/record/552812

Ejemplares similares

Quadrupole and Sextupole for Dual Bore Ring
por: Mikhailichenko, A A
Publicado: (2001)

Beam heat load measurements in the cold bore superconductive undulator in ANKA
por: Casalbuoni, S, et al.
Publicado: (2007)

Simple Procedure for Superconducting Coil Winding
por: Mikhailichenko, A A, et al.
Publicado: (2001)

Measurements of the beam heat load in the cold bore superconductive undulator installed at ANKA
por: Casalbuoni, S
Publicado: (2007)

Testing of the large bore single aperture 1-meter superconducting dipoles made with phenolic inserts
por: Boschmann, H, et al.
Publicado: (1998)

Design and Manufacture of a Large-Bore 10 T Superconducting Dipole for the CERN Cable Test Facility
por: Leroy, D, et al.
Publicado: (1999)

Some high charge phenomena in CLIC injection complex
por: Mikhailichenko, A A
Publicado: (1994)

Initial studies of electromagnetic shower energy deposition in small-bore superconducting undulator structures in linac environments
por: Cremer, T, et al.
Publicado: (1995)

Design and Fabrication of a 1 m Model of the 70 mm Bore Twin Aperture Superconducting Quadrupole for the LHC Insertions
por: Kirby, G A, et al.
Publicado: (1999)

A Warm Bore Anticryostat for Series Magnetic Measurements of LHC Superconducting Dipole and Short Straight Section Magnets
por: Dunkel, O, et al.
Publicado: (2004)

Design, Fabrication and Initial Testing of a Large Bore Single Aperture 1 m Long Superconducting Dipole Made with Phenolic Inserts
por: Boschmann, H, et al.
Publicado: (1997)

Concentric ring colliding beam machine with dual aperture quadrupoles
por: Mikhailichenko, A A, et al.
Publicado: (1996)

Beam screen - Cold bore concentricity
por: Kos, N, et al.
Publicado: (1996)

Cold bore experiments at CERN ISR
por: Benvenuti, Cristoforo, et al.
Publicado: (1979)

Some results of recent lens-measurements
por: Brummer, P J
Publicado: (1966)

Some calculations concerning the mechanical behaviour of the superconducting coils of the LHC dipoles
por: Poncet, A
Publicado: (1984)

Quench Protection of the HL-LHC Hollow Electron Lens Superconducting Solenoid Magnets
por: Wozniak, Mariusz, et al.
Publicado: (2022)

Conceptual Design of the HL-LHC Hollow Electron Lens Superconducting Magnet System
por: Foussat, Arnaud, et al.
Publicado: (2022)

Dynamic vacuum behaviour of the Cold Bore saturated with hydrogen
por: Benvenuti, C, et al.
Publicado: (1978)

Long term Vacuum Test on an Unbaked Cold Bore
por: Benvenuti, C, et al.
Publicado: (1979)

Analysis of some resistive transitions in the ISR superconducting quadrupole magnets
por: Henrichsen, K N, et al.
Publicado: (1982)

A vacuum cold bore test section at the CERN ISR
por: Benvenuti, Cristoforo, et al.
Publicado: (1977)

Prototype development of a warm bore insert for the LHC magnet measurements
por: Clari, F, et al.
Publicado: (1994)

Preliminary Magnetic Designs for Large-Bore and High-Field Dipole Magnets
por: Leroy, D, et al.
Publicado: (2004)

A 120 mm Bore Quadrupole for the Phase 1 LHC Upgrade
por: Fessia, P, et al.
Publicado: (2010)

Rotating-Coil Measurement System for Small-Bore-Diameter Magnet Characterization
por: Lauria, Anna, et al.
Publicado: (2022)

Fundamental features superconductivity cavities for high energy accelerators
por: Piel, H
Publicado: (1987)

Design of a compact, cryogen-free superconducting solenoid for the electron lens of the Fermilab Integrable Optics Test Accelerator (IOTA)
por: Dhuley, R C, et al.
Publicado: (2021)

Design of a 120 mm Bore 15 T Quadrupole for the LHC Upgrade Phase II
por: Caspi, S, et al.
Publicado: (2010)

Technical specification for the supply of cold bore tubes for LHC dipole magnet prototypes
por: Main Magnets and Superconductors Group (LHC-MMS)
Publicado: (1998)

The 15 cm Bore PSB quadrupoles: for the injection-, transfer-, and transfer-spectrometer lines
por: Vlogaert, J
Publicado: (1971)

Behaviour of Cold Bore II during Run 921 - 31.3.1978
por: Benvenuti, C, et al.
Publicado: (1978)

Thermal effects in superconducting RF - cavities some new results from an improved program
por: Tückmantel, Joachim
Publicado: (1984)

The Thin Lens Model In The Second Order And Some Effects Due to Linear coupling
por: Garczynski, V
Publicado: (1993)

Quench Performance of HQ01, a 120 mm Bore LARP Quadrupole for the LHC Upgrade
por: Marchevsky, M, et al.
Publicado: (2012)

New features in MADX thin-lens tracking module
por: Sun, Y, et al.
Publicado: (2010)

Specification for 10 CM-bore quadrupole beam transport magnets for the CERN MPS-division
por: Bossard, P
Publicado: (1968)

Device and Technique for In-situ Coating of the RHIC Cold Bore Vacuum Tubes with Thick OFHC
por: Hershcovitch, Ady, et al.
Publicado: (2013)

Discussion of RF aspects of the proposed project: Remote sensing system for tunnel-boring machines
por: Caspers, F
Publicado: (1990)

Cold Bore Operation with a thin and a thick layer of condensed N2
por: Benvenuti, C, et al.
Publicado: (1980)

Cannot write session to /tmp/vufind_sessions/sess_ebhm9hnvn00b4ek1ee0es9c553